scholarly journals EXPERIMENTAL STUDY OF THE INFLUENCE OF TEMPERATURE ON PASTEURIZATION OF PÊRA RIO IN NATURA ORANGE JUICE

Author(s):  
Gabriela Regina Rosa GALIASSI ◽  
◽  
Maribel Valverde RAMIREZ

Heat treatment is one of the most used methods to preserve food, such as orange juices, which are an excellent source of ascorbic acid. To avoid vitamin C degradation and reduce loss, fast heating is recommended. This work aimed to determine the vitamin C content using the iodometric method and the convective heat transfer coefficient using the method of dimensionless numbers and the experimental method. Time and temperature were controlled throughout the experiment. In pasteurization, the solution was heated to 80 °C, heating lasted 50 minutes and cooling for 42 minutes. The convective heat transfer coefficient was evaluated in two regions of the cylindrical container: near the wall and in the central region. The graphic profile of the curve follows the same trend of the literature. The convective heat transfer coefficient is higher in the region near the wall. As time passes and temperature decreases, the central region tends to equilibrium, and the coefficient becomes more constant. The vitamin C content remained constant before and after pasteurization, so it was observed that the pasteurization did not cause ascorbic acid degradation since the heating step was fast in the heat treatment. As a result of the study, it was noted that studying the thermal behavior in the cooling of orange juice is extremely important to ensure its quality. It is pertinent to mention that in order to avoid this degradation and reduce its loss, it is necessary that in thermal treatments, fast heating is carried out and that the juice has low exposure to air and heat at the time of its preparation.

Author(s):  
Feng Sun ◽  
G. Aguilar ◽  
K. M. Kelly ◽  
G.-X. Wang

Basel cell carcinoma (BCC) is the most common human skin malignancy. Its incidence has increased significantly in Australia, Europe and North America over the past decade. A number of modalities are currently used for treatment of BCC, including cryosurgery which offers a potential for high cure rate, low cost, minimal bleeding and good cosmetic effect. However, cryosurgery is not used frequently for BCC because no current method exists to design adequate treatment parameters. We present a numerical analysis on the thermal history of the target tissue during cryosurgery of a nodular BCC using liquid nitrogen (LN2) spray. The model uses Pennes equation to describe the heat transfer within the target tissue. A convective thermal boundary is used to describe the heat interaction between the tissue and LN2, and the apparent heat capacity method is applied to address the tissue phase change process. A parametric study is conducted on the convective heat transfer coefficient (hs: 104~106 W/m2·K), cooling site area (rs/R0: 0.5~1.0) and spray time (t: 0~30 sec.), with the objective to understand the thermal history during tissue freezing, including lethal temperature (-50 °C) and cooling rate (CR). Results demonstrate that propagation of the lethal isotherm is sensitive to the convective heat transfer coefficient, hs, with a range of 104~5×104 W/m2·K. Increasing the cooling site area can significantly enhance cooling efficiency, producing dramatic increase in the amount of tissue encompassed by the lethal isotherm. The cooling rate (CR) shows a highly dynamic distribution during the cooling process: the highest CR drops quickly from 140 °C/sec. (t=0.5 sec.) to 20 °C/sec. (t=5 sec.). The highest CR is initially located close to the cooling site but moves toward the inside of the tissue as treatment proceeds. The model presented herein provides a simulation tool for treatment planning of cryosurgery using LN2 spray, in which the protocol parameters, e.g. cooling site area and spray time, can be determined for an optimal outcome. The quantitative predictions on the propagation of lethal isotherm and the distribution of CR should help to optimize cryosurgery efficacy.


Sign in / Sign up

Export Citation Format

Share Document