scholarly journals High Quality of a Perchlorate‐Based Hybrid Perovskite‐Type Cage‐Like Single Crystal – Evidence of Temperature‐Induced Distinct Dielectric Transition

2021 ◽  
Author(s):  
Yi‐Fang Huang ◽  
Lin Xiang ◽  
Yan Feng ◽  
Zhen An ◽  
Le‐Ping Miao ◽  
...  
Keyword(s):  
Single Crystal ◽  
High Quality ◽  
Hybrid Perovskite ◽  
Perovskite Type ◽  
Dielectric Transition

Growth and Characterization of Single Crystal Epitaxial CoGa on MBE Grown III-V Semiconductors

1988 ◽  
Vol 144 ◽  
Author(s):  
K. C. Garrison ◽  
C. J. Palmstrøm ◽  
R. A. Bartynski
Keyword(s):  
Substrate Temperature ◽  
Single Crystal ◽  
Single Crystals ◽  
Structural Quality ◽  
High Quality ◽  
Auger Analysis ◽  
Post Deposition

ABSTRACTWe have demonstrated growth of high quality single crystal CoGa films on Ga1−xAlxAs. These films were fabricated in-situ by codeposition of Co and Ga on MBE grown Ga1−xAlxAs(100) surfaces. The elemental composition of the films was determined using Rutherford Backscattering (RBS) and in-situ Auger analysis. The structural quality of the films' surfaces was studied using RHEED (during deposition) and LEED (post deposition). RBS channeling was used to determine the bulk crystalline quality of these films.For ∼500 Å CoGa films grown at ∼450°C substrate temperature, channeling data showed good quality epitaxial single crystals [χmin ∼7%] with minimal dechanneling at the interface.

Progress in the Preparation of Aluminum Nitride Substrates from Bulk Crystals

2002 ◽  
Vol 722 ◽  
Author(s):  
J.C. Rojo ◽  
L.J. Schowalter ◽  
Glen Slack ◽  
K. Morgan ◽  
J. Barani ◽  
...  
Keyword(s):  
Dislocation Density ◽  
Aluminum Nitride ◽  
Single Crystal ◽  
Central Region ◽  
Electronic Device ◽  
Bulk Crystals ◽  
High Quality ◽  
X Ray ◽  
Uv Led

AbstractLarge (11-mm diameter) single-crystal AlN boules have been prepared using sublimationrecondensation growth. X-ray topography shows that substrates prepared from those boules have a dislocation density of less than 500 cm-2, while the central region of these substrates was nearly dislocation-free. Rocking curves of less than 10 arcsecs have been obtained indicating the high quality of these crystals. The AlN substrates have been used to growth an AlGaN/AlN multiquantum well structure with excellent crystalline quality and with photoluminescence peaked at around 260nm. In addition, a UV LED with emission wavelength at 360nm has been fabricated. This is the first operating opto-electronic device demonstrated on an AlN substrate.

scholarly journals Y3Ru2−x—A Representative of a Composite Modulated Family of Intermetallics

Crystals ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 189 ◽  
Author(s):  
Sven Lidin ◽  
Laura Folkers
Keyword(s):  
Single Crystal ◽  
High Quality ◽  
Space Group ◽  
Q Vector

The compound Y3Ru2−x was synthesized from the elements and the structure was solved from single crystal synchrotron data. The high quality of the data allowed the determination of the incommensurate ordering of the compound, previously reported as disordered, with respect to the second subsystem. The compound crystallizes in the super space group X-3(00γ)0 with the q-vector axial along c*, q = 00, λ = 0.4276(7) and the centering vectors (1/3 2/3 0 1/3), (2/3 1/3 0 2/3).

Influence of technology parameters of free-cutting steel continuous casting on the billet internal structure

2020 ◽  
Vol 76 (2) ◽  
pp. 139-142
Author(s):  
A. T. Kunakbaeva ◽  
A. M. Stolyarov ◽  
M. V. Potapova
Keyword(s):  
Regression Analysis ◽  
Continuous Casting ◽  
Internal Structure ◽  
Sulfur Content ◽  
Manganese Content ◽  
High Quality ◽  
Correlation And Regression Analysis ◽  
Cutting Steel ◽  
Continuously Cast

Free-cutting steel gains specific working properties thanks to the high content of sulfur and phosphorus. These elements, especially sulfur, have a rather high tendency to segregation. Therefore, segregation defects in free-cutting steel continuously cast billets can be significantly developed. The aim of the work was to study the influence of the chemical composition of freecutting steel and casting technological parameters on the quality of the macrostructure of continuously cast billets. A metallographic assessment of the internal structure of cast metal made of free-cutting steel and data processing by application of correlation and regression analysis were the research methods. The array of production data of 43 heats of free-cutting steel of grade A12 was studied. Steel casting on a five-strand radial type continuous casting machine was carried out by various methods of metal pouring from tundish into the molds. Metal of 19 heats was poured with an open stream, and 24 heats – by a closed stream through submerged nozzles with a vertical hole. High-quality billets had a cross-sectional size of 150×150 mm. The macrostructure of high-quality square billets made of free-cutting steel of A12 grade is characterized by the presence of central porosity, axial segregation and peripheral point contamination, the degree of development of which was in the range from 1.5 to 2.0 points, segregation cracks and strips – about 1.0 points. In the course of casting with an open stream, almost all of these defects are more developed comparing with the casting by a closed stream. As a result of correlation and regression analysis, linear dependences of the development degree of segregation cracks and strips both axial and angular on the sulfur content in steel and on the ratio of manganese content to sulfur content were established. The degree of these defects development increases with growing of sulfur content in steel of A12 grade. These defects had especially strong development when sulfur content in steel was of more than 0.10%. To improve the quality of cast metal, it is necessary to have the ratio of the manganese content to the sulfur content in the metal more than eight.

Experience of clinical testing of personal telemedicine system ‘Obereg’ for remote monitoring of patients in intensive care units

2020 ◽  
pp. 52-58 ◽  
Author(s):  
A. A. Eryomenko ◽  
N. V. Rostunova ◽  
S. A. Budagyan ◽  
V. V. Stets
Keyword(s):  
Intensive Care ◽  
Intensive Care Units ◽  
Remote Monitoring ◽  
Clinical Testing ◽  
Transportation Of Patients ◽  
High Quality ◽  
Telemedicine System ◽  
Accuracy Of Measurements ◽  
Hospital Equipment

The experience of clinical testing of the personal telemedicine system ‘Obereg’ for remote monitoring of patients at the intensive care units of leading Russian clinics is described. The high quality of communication with the remote receiving devices of doctors, the accuracy of measurements, resistance to interference from various hospital equipment and the absence of its own impact on such equipment were confirmed. There are significant advantages compared to stationary patient monitors, in particular, for intra and out-of-hospital transportation of patients.

METHODOLOGICAL ASPECTS OF VISUALIZATION OF CORONARY ARTERIES WITH TRANSTHORACIC ECHOCARDIOGRAPHY

2018 ◽  
pp. 26-35
Author(s):  
Z. A. Agaeva ◽  
K. B. Baghdasaryan
Keyword(s):  
Blood Flow ◽  
Coronary Blood Flow ◽  
Coronary Arteries ◽  
Transthoracic Echocardiography ◽  
Second Harmonic ◽  
Anatomic Reconstruction ◽  
High Quality ◽  
Acoustic Window ◽  
Methodological Aspects

The transthoracic echocardiography made by multifrequency probes with support of the mode of the second harmonic imaging, is a competitive method for visualization of the main coronary arteries and allows to estimate coronary blood flow with high quality. Of course, the method has considerable restrictions, most important of which is the low spatial resolution of a method, due to small acoustic window. Because of this the transthoracic visualization of coronary arteries perhaps will not become the leading method of anatomic reconstruction of separately taken coronary artery and especially all coronary arteries system. However uniqueness and indisputable advantage of this method is an opportunity to noninvasively estimate a coronary blood flow both once, and in dynamics.

Estimates on poverty in Russia and the additional measures to reduce it at the regional level

2020 ◽  
Vol 18 (4) ◽  
pp. 739-752 ◽  
Author(s):  
R.M. Sadykov
Keyword(s):  
Poverty Rate ◽  
Regional Level ◽  
Living Standards ◽  
Standard Of Living ◽  
High Quality ◽  
Social Standard ◽  
Republic Of Bashkortostan ◽  
The Republic ◽  
Sociological Studies

Subject. This article deals with the issues of social justice and a high quality of life, creating favorable economic and social conditions. Objectives. The article aims to assess the rate and changes in poverty in Russia and the Republic of Bashkortostan and develop complementary measures to reduce it. Methods. For the study, I used the methods of logical, comparative, economic and statistical analyses, the results of sociological studies, and official statistics. Results. The article highlights additional measures to reduce poverty in the region, including the establishment of a minimum social standard of living in each particular region that determines the poverty rate. Conclusions. Various factors, such as economic sanctions, economic slowdowns, territorial and regional imbalances, lead to living standards decline and poverty rise.

SCIENTIFIC BASIS OF POSTGRADUATE TRAINING FOR OFFICER WORKING ETHNIC AFFAIRS USING STATE BUDGET IN THE PERIOD OF 2018 – 2025

2017 ◽  
Author(s):  
La Duc Minh ◽  
Nguyen Thi Hao ◽  
Vu Thi Thuy
Keyword(s):  
Economic Development ◽  
Ethnic Groups ◽  
Human Resource ◽  
Postgraduate Training ◽  
Scientific Basis ◽  
National Defense ◽  
High Quality ◽  
State Budget ◽  
International Integration

Ethnic affairs play an important role in socio of ethnic groups’ solidarity, assurance of security and national defense stability. In -economic development, maintenanceorder to improve the quality of ethnic affairs, it is practical to carry out postgraduate training of officer implementing ethnic affairs using state budget with the aim of encouraging and enhancing officer quality to satisfy high-quality human resource in international integration.

Удобрение перца сладкого

2018 ◽  
Author(s):  
V.A. Borisov ◽  
A.M. Menshikh ◽  
V.S. Sosnov ◽  
G.F. Monakhos
Keyword(s):  
Drip Irrigation ◽  
Sweet Pepper ◽  
Water Soluble ◽  
Mineral Fertilizers ◽  
High Quality ◽  
Organic Mineral ◽  
Soluble Fertilizer

Показано действие минеральных удобрений, микрокристаллического комплексного водорастворимого удобрения «Мастер» и органоминерального наноудобрения с ростостимулирующей активностью «Арксойл» при капельном орошении на урожайность и качество сладкого перца нового гибрида F1 Темп. Сочетание основного удобрения с листовой и корневой подкормками позволяет получить до 65 т/га плодов перца высокого качества.The action of mineral fertilizers, microcrystalline complex water soluble fertilizer Master and organic mineral nano-fertilizer with growth-stimulating activity Arksoil under drip irrigation on the productivity and quality of sweet pepper of the new hybrid F1 Temp is shown. The combination of basic fertilizer with leaf and root fertilizing allows to obtain up to 65 t/ha of pepper fruits of high quality.

Sign in / Sign up

Export Citation Format

Share Document