Solubility of Zinc Silicate and Zinc Ferrite in Aqueous Solution to High Temperatures

2009 ◽  
Vol 38 (7) ◽  
pp. 869-892 ◽  
Author(s):  
Donald A. Palmer ◽  
Lawrence M. Anovitz
2007 ◽  
Vol 43 (2) ◽  
pp. 214-221 ◽  
Author(s):  
Masafumi Takesue ◽  
Kenji Shimoyama ◽  
Sachiko Murakami ◽  
Yukiya Hakuta ◽  
Hiromichi Hayashi ◽  
...  

2010 ◽  
Vol 74 (2) ◽  
pp. 406-411 ◽  
Author(s):  
ZHANG Xuetong ◽  
ZHANG Ronghua ◽  
HU Shumin ◽  
YU Wenbin

2012 ◽  
Vol 99 (9) ◽  
pp. 731-738 ◽  
Author(s):  
Nizar El-Murr ◽  
Marie-Christine Maurel ◽  
Martina Rihova ◽  
Jacques Vergne ◽  
Guy Hervé ◽  
...  

1998 ◽  
Vol 520 ◽  
Author(s):  
A.A. Burukhin ◽  
B.R. Churagulov ◽  
N.N. Oleynikov ◽  
Yu.V. Kolen'Ko

ABSTRACTNanostructured a-Fe2O3 powders were generated by rapid expansion of supercritical fluid solutions (RESS, T=773 K, P=100 MPa) and by rapid thermal decomposition of precursors in solution ( RTDS, T=623 K, P=100 MPa) on lab RESS-setup from 0,040 M and 0,10 M aqueous solutions of Fe(NO3)3. The size of subcrystallites is about 22-29 nm. Comparison of reactivity of α-Fe2O3 powders in a model solid state reaction between a-Fe2O3 powders (generated by RESS from 0,040 M solution) and Li2CO3 (mole ratio 1:1) with literature data on a-Fe2O3 powders produced by other methods shows that its reactivity is markedly higher. A basic essence possibility of zinc ferrite ZnFe2O4 formation immediately at the stage of the rapid expansion (T=773K; P=100 MPa) of a supercritical aqueous solution of zinc and iron nitrates (molar ratio Zn:Fe=1:2; C=0. 1 M) was shown.


In this communication Mr. Faraday shows that when sulphuric acid and naphthaline act upon each other, a peculiar compound pos­sessed of distinct acid characters is the result. This acid is most readily obtained by heating two parts of naphthaline with one of sulphuric acid. The mixture concretes on cooling, and separates into two parts, the uppermost of which is little else than naphthaline, but the lower, heavier part contains the peculiar acid, which, being soluble in water, is easily separated by that fluid, not, however, pure, but still containing mixed sulphuric acid. The author, however, ob­tained the pure acid by decomposing its compound with baryta, which is soluble, by sulphuric acid. It then had a bitter sour taste, and formed a distinct class of salts with the different bases, all of which are soluble in water and in alcohol, and combustible. By careful evaporation of the aqueous solution of this acid, a white crystalline deliquescent solution was obtained, evolving water when heated, and at high temperatures affording sulphurous acid, char­coal, and naphthaline. To determine the ultimate component parts of this acid, its compound with baryta was subjected to rigid analysis.


Sign in / Sign up

Export Citation Format

Share Document