Water Infiltration and Water Stability of Compacted Loess Roadbeds Based on Vibration Compaction

2021 ◽  
Author(s):  
Yingjun Jiang ◽  
Yong Yi ◽  
Tian Tian ◽  
Hongwei Sha ◽  
Jiangtao Fan ◽  
...  
Keyword(s):  
Water Infiltration ◽  
Water Stability ◽  
Vibration Compaction ◽  
Compacted Loess

scholarly journals A study on the effect of pore and particle distributions on the soil water characteristic curve of compacted loess

2021 ◽  
Author(s):  
Yu Wang ◽  
Tonglu Li ◽  
Chenxi Zhao ◽  
Xiaokun Hou ◽  
Ping Li ◽  
...  
Keyword(s):  
Soil Water ◽  
Construction Projects ◽  
Characteristic Curve ◽  
Loess Soil ◽  
Northwest China ◽  
Water Infiltration ◽  
Dry Density ◽  
Particle Distributions ◽  
Water Characteristics ◽  
Compacted Loess

Abstract Compacted loess soil is used as a geo-material in many engineering projects such as building foundations and highway embankments. Water infiltration characteristics and post settlement of the compacted loess in large construction projects of Northwest China have received increasing attention from researchers and investors. These behaviors are closely related to the soil water characteristics. This study aims to investigate the soil water characteristic curves (SWCCs) of compacted loess soil with different dry densities and to reveal the responsible micro-mechanisms for soil water characteristics. Loess soil collected from the new district of Yan'an City, China, is prepared into five dry density groups. The SWCC of each group in the suction range of 0–100,000 kPa is measured using the filter paper method (FPM). Two-dimensional (2D) images and the pore size distribution (PSD) curves of the specimens are tested by scanning electron microscopy (SEM) and the mercury pressure method (MIP), respectively. The results of this study highlight that the compaction behavior mainly influences the pores with a radius ( r ) in the range of 1–10 μm, and has no influence on the pores of r < 0.5 μm. The particle shapes among the five dry densities groups are similar. The characteristics of the PSD curves of the compacted loess soil correspond well to the SWCCs. The suction of the SWCCs increases with increasing dry density in the lower suction range of 0–100 kPa. In contrast, suction among the five dry density groups is almost identical in the suction range exceeding 100 kPa. The results of the study are helpful to understand the SWCC and microstructure characteristics of compacted loess with different dry densities.

Comparative study of the impact of two mechanical perforation densities on the behavior of a sandy soil

2012 ◽  
Vol 8 (1) ◽  
pp. 37-48
Author(s):  
S. Chehaibi ◽  
K. Abrougui ◽  
F. Haouala
Keyword(s):  
Soil Water ◽  
Sandy Soil ◽  
Water Infiltration ◽  
Cone Penetration ◽  
Initial State ◽  
Soil Water Infiltration ◽  
Good Improvement ◽  
The Impact ◽  
Positive Effect ◽  
Resistance To Penetration

The effects of mechanical perforation densities by extracting soil cores through an aerator Vertidrain with a working width of 1.6 m and equipped with hollow tines spaced of 65 mm, were studied on a sandy soil of a grassy sward in the Golf Course El Kantaoui in Sousse (Tunisia). The mechanical aeration was performed at two densities: 250 and 350 holes/m2. The cone penetration resistance and soil water infiltration were measured. These parameters were performed at initial state before aeration (E0) and then on the 10th, 20th and 30th day after aeration. These results showed that perforation density of 350 holes/m2 had a positive effect on the soil by reducing its cone resistance to penetration compared to the initial state (Rp = 14.8 daN/cm2). At 5 cm depth the decrease in resistance to penetration was 34% and 43% on the 10th and 20th day after aeration, respectively. However, on the 30th day after aeration the soil resistance to penetration tended to grow and its value compared to the initial state decreased only by 21 and 26%, respectively, at 5 and 15 cm of depth only by 10% and 9% with 250 holes/m2 density. The soil water infiltration made a good improvement after aeration compared to the initial state. This parameter increased from 4.8 cm/h to 8.3, 10.9 and 13.1 cm/h with 250 holes/m2 density and to 10, 12.9 and 14.8 cm/h with 350 holes/m2 density on the 10th, 20th and 30th day following the aeration.

Effect of Chemical and Tillage Summer Fallow upon Water‐Infiltration Rates

1955 ◽  
Vol 47 (5) ◽  
pp. 235-236 ◽  
Author(s):  
O. K. Barnes ◽  
D. W. Bohmont ◽  
Frank Rauzi
Keyword(s):  
Water Infiltration ◽  
Infiltration Rates ◽  
Summer Fallow

Study of Rheological Properties of Modified Concrete Mixtures at Vibration

2019 ◽  
Vol 968 ◽  
pp. 96-106
Author(s):  
Oleksandr Pshinko ◽  
Olena Hromova ◽  
Dmytro Rudenko
Keyword(s):  
Mechanical Properties ◽  
Rheological Properties ◽  
Physical Nature ◽  
Concrete Mixture ◽  
Practical Significance ◽  
Vibration Displacement ◽  
Concrete Mixtures ◽  
Variable Quantity ◽  
Vibration Compaction ◽  
Mechanism Of Interaction

Study of rheological properties of concrete mixtures based on modified cement systems in order to determine process parameters. Methodology. To study structural-mechanical properties of modified concrete mixtures of different consistency at their horizontal vibrating displacement an oscillatory viscometer was designed. Results. The optimization of the process of vibration displacement of concrete mixtures with the specification of parameters of vibration impacts taking into account structural-mechanical properties of the mixture is performed. It has been established that the viscosity of the modified cement system of the concrete mixture is a variable quantity, which depends on the parameters of the vibration impacts. Scientific novelty. The mechanism of interaction of the modified concrete mixture with the form and the table vibrator during its vibration compaction is determined. On the basis of this, a model of concrete laying process control is proposed, that allows to predict the ability to form a dense concrete structure. Practical significance. Disclosed physical nature of the process of vibrating displacement of modified concrete mixtures using the principles of physical-chemical mechanics of concrete allows reasonably choose the best options for vibration impacts.

Sign in / Sign up

Export Citation Format

Share Document