Differential tolerance of Zymoseptoria tritici to altered optimal moisture conditions during the early stages of wheat infection

Author(s):  
Anne-Lise Boixel ◽  
Sandrine Gélisse ◽  
Thierry C. Marcel ◽  
Frédéric Suffert
2019 ◽  
Author(s):  
Anne-Lise Boixel ◽  
Sandrine Gélisse ◽  
Thierry C. Marcel ◽  
Frédéric Suffert

AbstractFoliar plant pathogens require liquid or vapour water for at least part of their development, but their response and their adaptive tolerance to moisture conditions have been much less studied than other meteorological factors to date. We examined the impact on the wheat-Zymoseptoria tritici interaction of altering optimal moisture conditions conducive to infection. We assessed the responses in planta of 48 Z. tritici strains collected in two climatologically distinct locations (Ireland and Israel) to four high moisture regimes differing in the timing and the duration of uninterrupted exposure to saturated relative humidity (100% RH) during the first three days of infection. Individual- and population-level moisture reaction norms expressing how the sporulating area of a lesion change with the RH conditions were established based on visual assessments of lesion development at 14, 17 and 20 days post-inoculation (dpi). Our findings highlighted: (i) a critical time-dependent effect on lesion development of uninterrupted periods of exposure to 100% RH during these earliest infection stages; (ii) a marked interindividual variation in the sensitivity to RH conditions both in terms of strain average moisture response and plasticity; (iii) a higher tolerance – expressed at 14 dpi, not later – of the Israeli population to early interruption of optimal moisture conditions. By indicating that sensitivity to sub-optimal moisture conditions may vary greatly between Z. tritici individuals and populations, this study highlights the evidence of moisture adaptation signature in a plant pathogen. This suggests that understanding such variation will be critical to predict their response to changing climatic conditions.


2014 ◽  
Vol 60 (2) ◽  
pp. 241-256 ◽  
Author(s):  
Józef Jasiczak ◽  
Paweł Szymański ◽  
Piotr Nowotarski

AbstractArticle presents the results of the effect of humidity on early shrinkage of normal concrete with variable W/C ratio. As known for a long time, shrinkage is dependent of many factors. One of them is the W/C ratio and the quantity of water which is located in the concrete mix. In article there were discussed changes taking place in the concrete mix, the methods of research and the partial results obtained by the authors of the paper. Shrinkage is a phenomenon well known and studied by various research centers. The total amount of shrinkage may depend on various factors such as humidity, temperature, composition of the concrete mix, the W/C ratio, the size of the item. The study was conducted to determine the amount of shrinkage in its early stages. It is very important for concrete floors contractors, precast manufacturers to start at the right time finishing work and prevent the formation of shrinkage cracks.


Author(s):  
George G. Cocks ◽  
Louis Leibovitz ◽  
DoSuk D. Lee

Our understanding of the structure and the formation of inorganic minerals in the bivalve shells has been considerably advanced by the use of electron microscope. However, very little is known about the ultrastructure of valves in the larval stage of the oysters. The present study examines the developmental changes which occur between the time of conception to the early stages of Dissoconch in the Crassostrea virginica(Gmelin), focusing on the initial deposition of inorganic crystals by the oysters.The spawning was induced by elevating the temperature of the seawater where the adult oysters were conditioned. The eggs and sperm were collected separately, then immediately mixed for the fertilizations to occur. Fertilized animals were kept in the incubator where various stages of development were stopped and observed. The detailed analysis of the early stages of growth showed that CaCO3 crystals(aragonite), with orthorhombic crystal structure, are deposited as early as gastrula stage(Figuresla-b). The next stage in development, the prodissoconch, revealed that the crystal orientation is in the form of spherulites.


Author(s):  
S. Mahajan

The evolution of dislocation channels in irradiated metals during deformation can be envisaged to occur in three stages: (i) formation of embryonic cluster free regions, (ii) growth of these regions into microscopically observable channels and (iii) termination of their growth due to the accumulation of dislocation damage. The first two stages are particularly intriguing, and we have attempted to follow the early stages of channel formation in polycrystalline molybdenum, irradiated to 5×1019 n. cm−2 (E > 1 Mev) at the reactor ambient temperature (∼ 60°C), using transmission electron microscopy. The irradiated samples were strained, at room temperature, up to the macroscopic yield point.Figure 1 illustrates the early stages of channel formation. The observations suggest that the cluster free regions, such as A, B and C, form in isolated packets, which could subsequently link-up to evolve a channel.


Sign in / Sign up

Export Citation Format

Share Document