Eddy current measurement of chemiresistive sensing transients in monolayer graphene

2022 ◽  
Vol 26 ◽  
pp. 101291
Author(s):  
Jie Zhang ◽  
Manasi Doshi ◽  
Eric P. Fahrenthold
2015 ◽  
Vol 659 ◽  
pp. 623-627 ◽  
Author(s):  
Cherdpong Jomdecha ◽  
Isaratat Phung-On

The objective of this paper is an analysis of statistical discreteness and measurement capability of an eddy-current measurement system for residual stress assessment in stainless steel Grade 304 (SS304). Cylindrical specimens with 50 mm in diameter and 12 mm thickness were prepared to generate residual stress by Resistance Spot Welding at which the welding currents were set at 12, 14, and 16 kA. The eddy-current measurement system was including a probe with frequency range of 0.1 to 3 MHz and an eddy current flaw detector. They were performed by contacting the probe on the specimen. The measurements were performed particularly in the vicinity of heat affected zone (HAZ). In order to determine the results of the residual stress measurement, the calibration curves between static tensile stress and eddy current impedance at various frequencies were accomplished. The Measurement System Analysis (MSA) was utilized to evaluate the changed eddy-current probe impedance from residual stress. The results showed that using eddy current technique at 1 MHz for residual stress measurement was the most efficient. It can be achieved the Gauge Repeatability & Reproducibility %GR&R at 16.61479 and Number of Distinct Categories (NDC) at 8. As applied on actual butt welded joint, it could yield the uncertainty of ± 58 MPa at 95 % (UISO).


1996 ◽  
Vol 29 (2) ◽  
pp. 103-109 ◽  
Author(s):  
Benoit de Halleux ◽  
Bruno de Limburg Stirum ◽  
Andrei I'tchelintsev

Author(s):  
Emily K. Sequin ◽  
Joseph West ◽  
Vish V. Subramaniam

Real-time and non-invasive imaging of tissues and detection of diseases on millimeter to centimeter scales can be useful in some clinical applications such as determination of margins during cancer surgery and image-guided pathology. In this paper, we describe an eddy current measurement method for characterizing soft tissues. The device consists of a pair of concentrically wound coils, a primary coil excited by a low frequency (<100 kHz) sinusoidal voltage, inducing a voltage and current in the secondary detecting coil. When a conducting sample is present, eddy currents develop in the sample and alter the induced voltage and phase on the detecting coil. The output voltage and phase of the detecting coil are then monitored using lock-in amplification. Experimental measurements on porcine muscle tissue examine the effects of varying tissue macrostructure and conductivity on the eddy current detector. Three sets of experiments are presented. First, muscle samples cut into different sized grids simulating the restriction of eddy current domains show that morphological structure has a strong influence on the detector signal. Second, eddy current measurements made on porcine muscle samples at varying degrees of dehydration show that as conductivity decreases, eddy current signals also decrease. Finally, measurements on porcine muscle samples soaked overnight in deionized water complement the dehydration experiments and confirm detector voltage and phase changes decrease with decreasing conductivity.


Author(s):  
J. W. Allen ◽  
R. A. Nance ◽  
R. B. Oliver

Sign in / Sign up

Export Citation Format

Share Document