Complementary side chain promotes microphase separation in the membranes for alkali fuel cells

Previous experiments of water vapor penetration into polyelectrolyte membrane (PEM) thin films have indicated the influence of the water concentration gradient and polymer chemistry on the interface evolution, which will eventually affect the efficiency of the fuel cell operation. Moreover, PEMs of different side chains have shown differences in water cluster structure and diffusion. The evolution of the interface between water and polyelectrolyte membranes (PEMs), which are used in fuel cells and flow batteries, of three different side-chain lengths has been studied using dissipative particle dynamics (DPD) simulations. Higher and faster water uptake is usually beneficial in the operation of fuel cells and flow batteries. The simulated water uptake increased with the increasing side chain length. In addition, the water uptake was rapid initially and slowed down afterwards, which is in agreement with the experimental observations. The water cluster formation rate was also found to increase with the increasing side-chain length, whereas the water cluster shapes were unaffected. Water diffusion in the membranes, which affects proton mobility in the PEMs, increased with the side-chain length at all distances from the interface. In conclusion, side-chain length was found to have a strong influence on the interface water structure and water penetration rates, which can be harnessed for the better design of PEMs. Since the PEM can undergo cycles of dehydration and rehydration, faster water uptake increases the efficiency of these devices. We show that the longer side chains with backbone structure similar to Nafion should be more suitable for fuel cell/flow battery usage.

Download Full-text

Design of Thienothiophene-Based Copolymers with Various Side Chain-End Groups for Efficient Polymer Solar Cells

Polymers ◽

10.3390/polym12122964 ◽

2020 ◽

Vol 12 (12) ◽

pp. 2964

Author(s):

Ying-Chieh Chao ◽

Jhe-Han Chen ◽

Yi-Jie Chiou ◽

Po-lin Kao ◽

Jhao-Lin Wu ◽

...

Keyword(s):

Solar Cells ◽

Microphase Separation ◽

Bulk Heterojunction ◽

Polymer Solar Cells ◽

Photophysical Properties ◽

Morphological Properties ◽

Side Chain ◽

Blend Films ◽

End Groups ◽

Thiophene Moiety

Three two-dimensional donor–acceptor conjugated copolymers consisting of a benzo[1,2-b:4,5-b′]dithiophene derivative and thieno[3,2-b]thiophene with a conjugated side chain were designed and synthesized for use in bulk heterojunction (BHJ) or nonfullerene polymer solar cells (PSCs). Through attaching various acceptor end groups to the conjugated side chain on the thieno[3,2-b]thiophene moiety, the electronic, photophysical, and morphological properties of these copolymers were significantly affected. It was found that the intermolecular charge transfer interactions were enhanced with the increase in the acceptor strength on the thieno[3,2-b]thiophene moiety. Moreover, a better microphase separation was obtained in the copolymer: PC71BM or ITIC blend films when a strong acceptor end group on the thieno[3,2-b]thiophene moiety was used. As a result, BHJ PSCs based on copolymer:PC71BM blend films as active layers exhibited power conversion efficiencies from 2.82% to 4.41%, while those of nonfullerene copolymer:ITIC-based inverted PSCs ranged from 6.09% to 7.25%. These results indicate the side-chain engineering on the end groups of thieno[3,2-b]thiophene unit through a vinyl bridge linkage is an effective way to adjust the photophysical properties of polymers and morphology of blend films, and also have a significant influence on devices performance.

Download Full-text