Numerical study of the effect of tip-speed ratio on hydrokinetic turbine wake recovery

2021 ◽  
Author(s):  
Oumnia El Fajri ◽  
Joshua Bowman ◽  
Shanti Bhushan ◽  
David Thompson ◽  
Tim O'Doherty
Keyword(s):  
Numerical Study ◽  
Speed Ratio ◽  
Tip Speed Ratio ◽  
Hydrokinetic Turbine ◽  
Turbine Wake

scholarly journals Modeling and performance calculation of a horizontal axis wind and hydrokinetic turbine: Numerical study

2018 ◽  
Vol 2 (2) ◽  
pp. 70-79
Author(s):  
Anastas Todorov Yangyozov ◽  
Damjanka Stojanova Dimitrova ◽  
Lazar Georgiev Panayotov
Keyword(s):  
Numerical Study ◽  
Numerical Calculations ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Tip Speed Ratio ◽  
Ansys Cfx ◽  
Hydrokinetic Turbine ◽  
Wide Range ◽  
And Performance ◽  
Performance Calculation

A small turbine, working with air and water to generate electricity, was designed and its performance was reported in this paper. The rotor diameter is 150mm. The numerical calculations of the power coefficient, torque, and tip speed ratio of turbine were carried out for a wide range of inlet velocities. The flow passing through the turbine was investigated with commercial CFD code ANSYS CFX 18

Large Eddy Simulations of Ventilated Micro Hydrokinetic Turbine

2017 ◽  
Author(s):  
Cosan Daskiran ◽  
Bashar Attiya ◽  
I-Han Liu ◽  
Jacob Riglin ◽  
Alparslan Oztekin
Keyword(s):  
Axial Direction ◽  
Large Eddy Simulations ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Multiphase Model ◽  
Thrust Coefficient ◽  
Tip Speed Ratio ◽  
Hydrokinetic Turbine ◽  
Large Eddy ◽  
Aeration Process

Large eddy simulations of pre-designed micro-hydrokinetic turbine were conducted to investigate the oxygen transfer from air to water. Simulations were performed in extreme conditions having a tip-speed ratio of 3.8 that is higher than the tip-speed ratio at turbine’s design point. Air was injected from the turbine hub downstream in axial direction. Both single phase and multiphase simulations were performed to reveal the influence of air admission on the flow structures and the turbine performance. The mixture multiphase model was employed in multiphase simulation. The results indicated that turbine power generation was reduced roughly 10.5% by air admission, however the torque applied on turbine surface in axial direction did not vary significantly by aeration. The aeration assisted in the suppression of vortices within the flow field. The deviation of the power coefficient and the thrust coefficient was reduced roughly 32% through the inclusion of aeration process.

scholarly journals Design and Pitch Angle Optimisation of Horizontal Axis Hydrokinetic Turbine with Constant Tip Speed Ratio

2017 ◽  
Vol 95 ◽  
pp. 06004 ◽  
Author(s):  
Suyash Nigam ◽  
Shubham Bansal ◽  
Tanmay Nema ◽  
Vansh Sharma ◽  
Raj Kumar Singh
Keyword(s):  
Pitch Angle ◽  
Horizontal Axis ◽  
Speed Ratio ◽  
Tip Speed Ratio ◽  
Hydrokinetic Turbine

scholarly journals Numerical Study of Flow Field and Aerodynamic Performance of Straight Bladed VAWT at Variable Tip Speed Ratios

2015 ◽  
Vol 9 (1) ◽  
pp. 1017-1024 ◽  
Author(s):  
Mei Yi ◽  
Qu Jianjun
Keyword(s):  
Flow Field ◽  
Unsteady Flow ◽  
Vortex Shedding ◽  
Numerical Study ◽  
Aerodynamic Performance ◽  
Wake Flow ◽  
Speed Ratio ◽  
Power Performance ◽  
Tip Speed Ratio ◽  
And Diffusion

This paper studies the relationship between unsteady flow features and instantaneous torque and power performance of straight bladed vertical axis wind turbine at variable tip speed ratios. The rotor unsteady flow field simulation was carried out by using computational fluid dynamics method. The flow physics and the principle of changing flow field acting on torque performance and power performance have been analyzed where the rotating rotor was the major concern. The results show that the flow feature alters from periodical blade dynamic stall vortexes generation, development and shedding at low tip speed ratio to cyclical formation, evolution and diffusion of blade wake flow with the rising tip speed ratio. Both vortex shedding around the blade and interaction of blade wakes degrade the rotor aerodynamic performance. It is suggested that, to absorb maximum wind energy, delay the blade vortex shedding and reduce the range of blade wake, evolution and diffusion should be included in the rotor aerodynamic design.

A Numerical Study on the Effects of Unsteady Wind on Vertical Axis Wind Turbine Performance

2013 ◽  
Author(s):  
Louis Angelo Danao ◽  
Jonathan Edwards ◽  
Okeoghene Eboibi ◽  
Robert Howell
Keyword(s):  
Wind Speed ◽  
Wind Turbine ◽  
Numerical Study ◽  
Angle Of Attack ◽  
Vertical Axis ◽  
Power Coefficient ◽  
Peak Performance ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbine ◽  
Tip Speed Ratio

Numerical simulations using RANS–based CFD have been utilised to carry out investigations on the effects of unsteady wind in the performance of a wind tunnel vertical axis wind turbine. Using a validated CFD model, unsteady wind simulations revealed a fundamental relationship between instantaneous VAWT CP and wind speed. CFD data shows a CP variation in unsteady wind that cuts across the steady CP curve as wind speed fluctuates. A reference case with mean wind speed of 7m/s, wind speed amplitude of ±12%, fluctuating frequency of 0.5Hz and mean tip speed ratio of 4.4 has shown a wind cycle mean power coefficient of 0.33 that equals the steady wind maximum. Increasing wind speed causes the instantaneous tip speed ratio to fall which leads to higher effective angle of attack and deeper stalling on the blades. Stalled flow and rapid changes in angle of attack of the blade induce hysteresis loops in both lift and drag. Decreasing wind speeds limit the perceived angle of attack seen by the blades to near static stall thus reducing the positive effect of dynamic stall on lift generation. Three mean tip speed ratio cases were tested to study the effects of varying conditions of VAWT operation on the overall performance. As the mean tip speed ratio increases, the peak performance also increases.

scholarly journals Performance assessment and optimization of a helical Savonius wind turbine by modifying the Bach’s section

2021 ◽  
Vol 3 (8) ◽  
Author(s):  
M. Niyat Zadeh ◽  
M. Pourfallah ◽  
S. Safari Sabet ◽  
M. Gholinia ◽  
S. Mouloodi ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Performance Assessment ◽  
Turbulent Flows ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Tip Speed Ratio ◽  
Basic Model ◽  
Turbine Performance ◽  
Primary Model ◽  
Savonius Wind Turbine

AbstractIn this paper, we attempted to measure the effect of Bach’s section, which presents a high-power coefficient in the standard Savonius model, on the performance of the helical Savonius wind turbine, by observing the parameters affecting turbine performance. Assessment methods based on the tip speed ratio, torque variation, flow field characterizations, and the power coefficient are performed. The present issue was stimulated using the turbulence model SST (k- ω) at 6, 8, and 10 m/s wind flow velocities via COMSOL software. Numerical simulation was validated employing previous articles. Outputs demonstrate that Bach-primary and Bach-developed wind turbine models have less flow separation at the spoke-end than the simple helical Savonius model, ultimately improving wind turbines’ total performance and reducing spoke-dynamic loads. Compared with the basic model, the Bach-developed model shows an 18.3% performance improvement in the maximum power coefficient. Bach’s primary model also offers a 12.4% increase in power production than the initial model’s best performance. Furthermore, the results indicate that changing the geometric parameters of the Bach model at high velocities (in turbulent flows) does not significantly affect improving performance.

Numerical Research on the Characteristics of Lift-Drag Type Vertical Axis Wind Turbine

2012 ◽  
Vol 189 ◽  
pp. 448-452
Author(s):  
Yan Jun Chen ◽  
Guo Qing Wu ◽  
Yang Cao ◽  
Dian Gui Huang ◽  
Qin Wang ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Vertical Axis ◽  
Chord Length ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbine ◽  
Tip Speed Ratio ◽  
Middle Range ◽  
Parabolic Form ◽  
Cfd Method

Numerical studies are conducted to research the performance of a kind of lift-drag type vertical axis wind turbine (VAWT) affected by solidity with the CFD method. Moving mesh technique is used to construct the model. The Spalart-Allmaras one equation turbulent model and the implicit coupled algorithm based on pressure are selected to solve the transient equations. In this research, how the tip speed ratio and the solidity of blade affect the power coefficient (Cp) of the small H-VAWT is analyzed. The results indicate that Cp curves exhibit approximate parabolic form with its maximum in the middle range of tip speed ratio. The two-blade wind turbine has the lowest Cp while the three-blade one is more powerful and the four-blade one brings the highest power. With the certain number of blades, there is a best chord length, and too long or too short chord length may reduce the Cp.

Performance study of twisted Darrieus hydrokinetic turbine with novel blade design

2021 ◽  
pp. 1-37
Author(s):  
Mabrouk Mosbahi ◽  
Mouna Derbel ◽  
Mariem Lajnef ◽  
Bouzid Mosbahi ◽  
Zied Driss ◽  
...  
Keyword(s):  
Three Dimensional ◽  
Maximum Power ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Small Scale ◽  
Performance Study ◽  
Hydrokinetic Turbine ◽  
Blade Shape ◽  
Water Turbine ◽  
Water Canals

Abstract Twisted Darrieus water turbine is receiving growing attentiveness for small-scale hydropower generation. Accordingly, the need for raised water energy conversion incentivizes researchers to focalise on the blade shape optimization of twisted Darrieus turbine. In view of this, an experimental analysis has been performed to appraise the efficiency of a spiral Darrieus water rotor in the present work. To better the performance parameters of the studied water rotor with twisted blades, three novel blade shapes, namely U-shaped blade, V-shaped blade and W-shaped blade, have been numerically tested using a computational fluid dynamics three-dimensional numerical model. Maximum power coefficient of Darrieus rotor reaches 0.17 at 0.63 tip-speed ratio using twisted blades. Using V-shaped blades, maximum power coefficient has been risen up to 0.185. The current study could be practically applied to provide more effective employment of twisted Darrieus turbines and to improve the generated power from flowing water such as river streams, tidal currents, or other man made water canals.

Sign in / Sign up

Export Citation Format

Share Document