scholarly journals Electronic, structural and magnetic characterization of bulk (ZnO)1−x(MnO2)xsystem and their PLD synthesized thin films at room temperature

2010 ◽  
Vol 200 (7) ◽  
pp. 072044 ◽  
Author(s):  
S Karamat ◽  
R S Rawat ◽  
M Ghaffari ◽  
P Lee ◽  
T L Tan
Keyword(s):  
Thin Films ◽  
Room Temperature ◽  
Magnetic Characterization

Processing by Pulsed Laser Deposition and Structural, Morphological and Chemical Characterization of Bi-Pb-Sr-Ca-Cu-O and Bi-Pb-Sb-Sr-Ca-Cu-O Thin Films

2010 ◽  
Vol 75 ◽  
pp. 202-207
Author(s):  
Victor Ríos ◽  
Elvia Díaz-Valdés ◽  
Jorge Ricardo Aguilar ◽  
T.G. Kryshtab ◽  
Ciro Falcony
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Room Temperature ◽  
Pulsed Laser ◽  
Chemical Characterization ◽  
Laser Deposition ◽  
Nominal Composition ◽  
Deposition Parameters ◽  
The Relationship

Bi-Pb-Sr-Ca-Cu-O (BPSCCO) and Bi-Pb-Sb-Sr-Ca-Cu-O (BPSSCCO) thin films were grown on MgO single crystal substrates by pulsed laser deposition. The deposition was carried out at room temperature during 90 minutes. A Nd:YAG excimer laser ( = 355 nm) with a 2 J/pulse energy density operated at 30 Hz was used. The distance between the target and substrate was kept constant at 4,5 cm. Nominal composition of the targets was Bi1,6Pb0,4Sr2Ca2Cu3O and Bi1,6Pb0,4Sb0,1Sr2Ca2Cu3OSuperconducting targets were prepared following a state solid reaction. As-grown films were annealed at different conditions. As-grown and annealed films were characterized by XRD, FTIR, and SEM. The films were prepared applying an experimental design. The relationship among deposition parameters and their effect on the formation of superconducting Bi-system crystalline phases was studied.

Characterization of the order-annealing response of nanostructured iron-palladium based ferromagnetic thin-films

2001 ◽  
Vol 703 ◽  
Author(s):  
Huiping Xu ◽  
Adam T. Wise ◽  
Timothy J. Klemmer ◽  
Jörg M. K. Wiezorek
Keyword(s):  
Thin Films ◽  
Grain Growth ◽  
Room Temperature ◽  
Si Substrate ◽  
Ferromagnetic Thin Films ◽  
Precipitation Reactions ◽  
Post Deposition ◽  
Xrd And Tem ◽  
Iron Palladium

ABSTRACTA combination of XRD and TEM techniques have been used to characterize the response of room temperature magnetron sputtered Fe-Pd thin films on Si-susbtrates to post-deposition order-annealing at temperatures between 400-500°C. Deposition produced the disordered Fe-Pd phase with (111)-twinned grains approximately 18nm in size. Ordering occurred for annealing at 450°C and 500°C after 1.8ks, accompanied by grain growth (40-70nm). The ordered FePd grains contained (111)-twins rather than {101}-twins typical of bulk ordered FePd. The metallic overlayers and underlayers selected here produced detrimental dissolution (Pt into Fe-Pd phases) and precipitation reactions between Pd and the Si substrate.

Magnetic characterization of ion-beam sputter deposited permalloy thin films

1992 ◽  
Vol 104-107 ◽  
pp. 1847-1850 ◽  
Author(s):  
Michael A. Russak ◽  
Christopher V. Jahnes ◽  
Erik Klokholm ◽  
Bojan Petek
Keyword(s):  
Thin Films ◽  
Ion Beam ◽  
Magnetic Characterization ◽  
Sputter Deposited ◽  
Permalloy Thin Films

Structural Evolution Upon Annealing of Multi-Layer Si/Fe Thin Films Prepared by Magnetron Sputtering

2007 ◽  
Vol 561-565 ◽  
pp. 1161-1164
Author(s):  
Xiao Na Li ◽  
Bing Hu ◽  
Chuang Dong ◽  
Xin Jiang
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Room Temperature ◽  
Structural Evolution ◽  
Radio Frequency Magnetron Sputtering ◽  
Transmission Electron ◽  
Direct Band ◽  
The Stability ◽  
Sputtering System

Fe/Si multi-layer films were fabricated on Si (100) substrates utilizing radio frequency magnetron sputtering system. Si/β-FeSi2 structure was found in the films after the deposition. Structural characterization of Fe-silicide sample was performed by transmission electron microscopy, to explore the dependence of the microstructure of β-FeSi2 film on the preparation parameters. It was found that β-FeSi2 particles were formed after the deposition without annealing, whose size is less than 20nm ,with a direct band-gap of 0.94eV in room temperature. After annealing at 850°C, particles grow lager, however the stability of thin films was still good.

Silicon Germanium Oxide (SixGeyO1-x-y) Infrared Sensitive Material for Uncooled Detectors

2010 ◽  
Vol 1245 ◽  
Author(s):  
Reza Anvari ◽  
Qi Cheng ◽  
Muhammad Lutful Hai ◽  
Truc Phan Bui ◽  
A. J. Syllaios ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Silicon Germanium ◽  
Room Temperature ◽  
Rf Magnetron Sputtering ◽  
Germanium Oxide ◽  
Temperature Coefficient Of Resistance ◽  
Sensitive Material

AbstractThis paper presents the formation and the characterization of silicon germanium oxide (SixGeyO1-x-y) infrared sensitive material for uncooled microbolometers. RF magnetron sputtering was used to simultaneously deposit Si and Ge thin films in an Ar/O2 environment at room temperature. The effects of varying Si and O composition on the thin film's electrical properties which include temperature coefficient of resistance (TCR) and resistivity were investigated. The highest achieved TCR and the corresponding resistivity at room temperature were -5.41 %/K and 3.16×103 ohm cm using Si0.039Ge0.875O0.086 for films deposited at room temperature.

Characterization of zinc oxide thin films prepared by pulsed laser deposition at room temperature

2008 ◽  
Vol 202 (22-23) ◽  
pp. 5467-5470 ◽  
Author(s):  
Norihiro Sakai ◽  
Yoshihiro Umeda ◽  
Fumiaki Mitsugi ◽  
Tomoaki Ikegami
Keyword(s):  
Thin Films ◽  
Zinc Oxide ◽  
Pulsed Laser Deposition ◽  
Room Temperature ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
Oxide Thin Films
Sign in / Sign up

Export Citation Format

Share Document