scholarly journals Tuning light transmission with smart fluids based on 1D carbon nanomaterials

2019 ◽  
Vol 6 (11) ◽  
pp. 115086
Author(s):  
A P Franco-Bacca ◽  
F Cervantes-Alvarez ◽  
C Glorieux ◽  
G Rodríguez-Gattorno ◽  
J J Alvarado-Gil
Keyword(s):  
Carbon Nanomaterials ◽  
Light Transmission ◽  
Smart Fluids

Advanced TEM sample preparation techniques for submicron Si devices

1995 ◽  
Vol 53 ◽  
pp. 516-517 ◽  
Author(s):  
P. B. Basham ◽  
H. L. Tsai
Keyword(s):  
Sample Preparation ◽  
Process Development ◽  
Light Transmission ◽  
Specific Area ◽  
Turnaround Time ◽  
Small Hole ◽  
Area Of Interest ◽  
Transmission Electron ◽  
Polished Side ◽  
Preparation Techniques

The use of transmission electron microscopy (TEM) to support process development of advanced microelectronic devices is often challenged by a large amount of samples submitted from wafer fabrication areas and specific-spot analysis. Improving the TEM sample preparation techniques for a fast turnaround time is critical in order to provide a timely support for customers and improve the utilization of TEM. For the specific-area sample preparation, a technique which can be easily prepared with the least amount of effort is preferred. For these reasons, we have developed several techniques which have greatly facilitated the TEM sample preparation.For specific-area analysis, the use of a copper grid with a small hole is found to be very useful. With this small-hole grid technique, TEM sample preparation can be proceeded by well-established conventional methods. The sample is first polished to the area of interest, which is then carefully positioned inside the hole. This polished side is placed against the grid by epoxy Fig. 1 is an optical image of a TEM cross-section after dimpling to light transmission.

Role of the exosporial membrane in attachment and germination of C. sporogenes

1993 ◽  
Vol 51 ◽  
pp. 38-39
Author(s):  
B.J. Panessa-Warren ◽  
G.T. Tortora ◽  
J.B. Warren
Keyword(s):  
Enzymatic Degradation ◽  
Light Transmission ◽  
Extended Period ◽  
Growth Conditions ◽  
Clostridium Sporogenes ◽  
Radiation Chemical ◽  
Physical Trauma ◽  
Extended Contact ◽  
Cold Pressure

Some bacteria are capable of forming highly resistant spores when environmental conditions are not adequate for growth. Depending on the genus and species of the bacterium, these endospores are resistant in varying degrees to heat, cold, pressure, enzymatic degradation, ionizing radiation, chemical sterilants,physical trauma and organic solvents. The genus Clostridium, responsible for botulism poisoning, tetanus, gas gangrene and diarrhea in man, produces endospores which are highly resistant. Although some sporocides can kill Clostridial spores, the spores require extended contact with a sporocidal agent to achieve spore death. In most clinical situations, this extended period of treatment is not possible nor practical. This investigation examines Clostridium sporogenes endospores by light, transmission and scanning electron microscopy under various dormant and growth conditions, cataloging each stage in the germination and outgrowth process, and analyzing the role played by the exosporial membrane in the attachment and germination of the spore.

High-performance light transmission based on graphene plasmonic waveguides

2020 ◽  
Vol 8 (20) ◽  
pp. 6832-6838 ◽  
Author(s):  
Da Teng ◽  
Kai Wang ◽  
Qiongsha Huan ◽  
Weiguang Chen ◽  
Zhe Li
Keyword(s):  
High Performance ◽  
Light Transmission ◽  
Optical Field ◽  
Plasmonic Waveguides ◽  
Rib Waveguide

Tunable ultra-deep subwavelength optical field confinement is reported by using a graphene-coated nanowire-loaded silicon nano-rib waveguide.

Platelet Hypersensitivity in Acute Malaria (Plasmodium falciparum) Infection in Man

1981 ◽  
Vol 46 (02) ◽  
pp. 547-549 ◽  
Author(s):  
E M Essien ◽  
M I Ebhota
Keyword(s):  
Plasmodium Falciparum ◽  
Malaria Infection ◽  
Light Transmission ◽  
Human Platelet ◽  
Platelet Rich Plasma ◽  
Wave Pattern ◽  
Falciparum Infection ◽  
Secondary Wave ◽  
Control Subjects ◽  
The Mean

SummaryDuring acute malaria infection, platelets in human platelet-rich plasma are hypersensitive to the addition of ADP between 1.0 uM and 5.0 uM, or adrenaline 0.11 uM as aggregating agents. The mean maximum aggregation amplitude (as % of light transmission) obtained from 8 subjects in response to added ADP (1.0 uM), 39.8 ± 27 (1SD), was significantly greater than the value in 6 controls (5.2±6.7 (1SD); t = 3, 51 P <0.005). A similar pattern of response was obtained with higher ADP concentrations (2.4,4.5 or 5.0 uM) in 22 patients and 20 control subjects (89.9±14.9% vs 77.8±16.5% (1SD) t = 2.45, P <0.02). Addition of 4.5 uM ADP to patient PRP usually evoked only a single aggregation wave (fused primary and secondary waves) while the typical primary and secondary wave pattern was usually obtained from controls.Mean plasma B-thromboglobulin (BTG) concentration in 7 patients (208.3 ± 15.6 ng/ml) was significantly higher than the value in 6 control subjects (59.2±15.7 ng/ml; t = 13.44, P <0.002).

Adenosine Diphosphate (ADP)-Induced ⍺-Granules Release from Platelets of Native Whole Blood Is Reduced by Ticlopidine but Not by Aspirin or Dipyridamole

1986 ◽  
Vol 56 (02) ◽  
pp. 147-150 ◽  
Author(s):  
V Pengo ◽  
M Boschello ◽  
A Marzari ◽  
M Baca ◽  
L Schivazappa ◽  
...  
Keyword(s):  
Whole Blood ◽  
Light Transmission ◽  
Ex Vivo ◽  
Early Stage ◽  
Shape Change ◽  
Adenosine Diphosphate ◽  
Dose Dependent ◽  
Plateletderived Growth Factor ◽  
Platelet Shape

SummaryA brief contact between native whole blood and ADP promotes a dose-dependent release of platelet a-granules without a fall in the platelet number. We assessed the “ex vivo” effect of three widely used antiplatelet drugs, aspirin dipyridamole and ticlopidine, on this system. Aspirin (a single 800 mg dose) and dipyridamole (300 mg/die for four days) had no effect, while ticlopidine (500 mg/die for four days) significantly reduced the a-granules release for an ADP stimulation of 0.4 (p <0.02), 1.2 (p <0.01) and 2 pM (p <0.01). No drug, however, completeley inhibits this early stage of platelet activation. The platelet release of α-granules may be related to platelet shape change of the light transmission aggregometer and may be important “in vivo” by enhancing platelet adhesiveness and by liberating the plateletderived growth factor.

Hybrid Lighting Complex for Combined Lighting Systems Research Into Optical Path Optimization Using the Complex "Solar Led-S" New Modification

2018 ◽  
pp. 122-129
Author(s):  
Alexander T. Ovcharov ◽  
Yuri N. Selyanin ◽  
Yaroslav V. Antsupov
Keyword(s):  
Light Transmission ◽  
Optical Path ◽  
Artificial Light ◽  
Solar Panels ◽  
Shopping Centre ◽  
Systems Research ◽  
Lower Stage ◽  
Input Structure ◽  
Lighting Systems ◽  
Two Stages

A new concept of the architecture of hybrid lighting systems for installations of combined lighting is considered. The cascade principle of constructing the optical path of such complexes is described, in which the design contains two stages of the cascade: the upper and lower stages. The upper (input) structure is made on the basis of the corresponding modification of the hollow tube “Solatube®” (daylight), and the lower one, based on the “Solatube®” fibre of a larger diameter, is combined with LED artificial light block and is designed to transmit mixed light (daylight and artificial light). The results of studies on the efficiency of light transmission made it possible to optimize the solution of the new modification of the hybrid lighting complex “Solar LED”, lower stage of the cascade, and to develop the nomenclature of the production line “S”. The description of the first experience of using this complex in the pilot combined illumination system of the “meeting room” in the shopping centre “IKEA Belaya Dacha” headquarters is given. A completely autonomous power supply system for a lighting installation based on solar panels has been implemented.

Modelling Light Transmission in a Fiber-Optical Reflection System

2004 ◽  
Vol 9 (1) ◽  
pp. 55-63
Author(s):  
V. Kleiza
Keyword(s):  
Optical Sensors ◽  
Light Transmission ◽  
External Cavity ◽  
Linear Displacement ◽  
Fiber System ◽  
Light Emitting ◽  
Optical Media ◽  
Reflected Light ◽  
Fiber Optical ◽  
Fiber Optical Sensors

Light transmission in the reflection fiber system, located in external optical media, has been investigated for application as sensors. The system was simulated by different models, including external cavity parameters such as the distance between light emitting and receiving fibers and mirror positioning distance. The sensitivity to a linear displacement of the sensors was studied as a function of the distance between the tips of the light emitting fiber and the center of the pair reflected light collecting fibers, by positioning a mirror. Physical fundamentals and operating principles of the advanced fiber optical sensors were revealed.

Sign in / Sign up

Export Citation Format

Share Document