scholarly journals Analysis and Experiential Verification of Power Loss in Joint Area of Laminated Transformer Core

2021 ◽  
Author(s):  
Yevgeniy Kalinin ◽  
Alexandr Chivenkov ◽  
Yuriy Vagapov ◽  
Alecksey Anuchin
Keyword(s):  
Power Loss ◽  
Joint Area ◽  
Transformer Core

Building Factor of Grain-Oriented Silicon Iron (3% SiFe) with Different Thickness on 100kVA Three Phase Distribution Transformer Core

2012 ◽  
Vol 488-489 ◽  
pp. 537-541
Author(s):  
N. Ashbahani ◽  
I. Daut ◽  
Mohd Irwan Yusoff
Keyword(s):  
Power Loss ◽  
Phase Distribution ◽  
Operation Mode ◽  
Load Test ◽  
Core Material ◽  
Distribution Transformer ◽  
Silicon Iron ◽  
Three Phase ◽  
Transformer Model ◽  
Transformer Core

The power loss in laminated transformer cores is always greater than the nominal loss of the electrical steel laminations, by a factor known as the building factor. This paper discussed result of an investigation towards the effect of using two different Grain-Oriented Silicon Iron (3%SiFe) materials to the 100kVA three phase distribution transformer. The thicknesses of the material that have been used in this research are 0.23mm and 0.27mm. The transformer core will be assembled with 60o T-joint with 5mm mitred corner overlap length. Power loss has been measured using no-load test with 29 layer of lamination while nominal loss measured using Epstein test frame. At the operation mode flux density, 1.5T, the building factor of the transformer model core material with 0.23mm thickness is 1.219 while with the building factor for 0.27mm thickness is 1.250. This shows that thinner transformer core lamination is better than the other one by 2.5% during operation mode.

Effect of Artificial Burrs on the Total Power Loss of a Three-Phase Transformer Core

2010 ◽  
Vol 46 (2) ◽  
pp. 638-641 ◽  
Author(s):  
Rafal Mazurek ◽  
Philip Marketos ◽  
Anthony Moses ◽  
Jean-NoËl Vincent
Keyword(s):  
Power Loss ◽  
Total Power ◽  
Three Phase ◽  
Transformer Core
Sign in / Sign up

Export Citation Format

Share Document