scholarly journals Evaluating cross contamination on a shared ventilator

2020 ◽  
pp. emermed-2020-209972
Author(s):  
Donald Joseph Doukas ◽  
Lorenzo Paladino ◽  
Christopher Hanuscin ◽  
Jonathan McMahon ◽  
John Quale ◽  
...  

BackgroundDisasters have the potential to cause critical shortages of life-saving equipment. It has been postulated that during patient surge, multiple individuals could be maintained on a single ventilator. This was supported by a previous trial that showed one ventilator could support four sheep. The goal of our study is to investigate if cross contamination of pathological agents occurs between individuals on a shared ventilator with strategically placed antimicrobial filters.MethodsA multipatient ventilator circuit was assembled using four sterile, parallel standard tubing circuits attached to four 2 L anaesthesia bags, each representing a simulated patient. Each ‘patient’ was attached to a Heat and Moisture Exchange filter. An additional bacterial/viral filter was attached to each expiratory limb. ‘Patient-Lung’ number 1 was inoculated with an isolate of Serratia marcescens, and the circuit was run for 24 hours. Each ‘lung’ and three points in the expiratory limb tubing were washed with broth and cultured. All cultures were incubated for 48 hours with subcultures performed at 24 hours.ResultsWashed cultures of patient 2, 3 and 4 failed to demonstrate growth of S. marcescens. Cultures of the distal expiratory tubing, expiratory limb connector and expiratory limb prefilter tubing yielded no growth of S. marcescens at 24 or 48 hours.ConclusionBased on this circuit configuration, it is plausible to maintain four individuals on a single ventilator for 24 hours without fear of cross contamination.

2019 ◽  
Vol 1382 ◽  
pp. 012081
Author(s):  
A Ch Zandaraev ◽  
R Sh Mansurov ◽  
T A Rafalskaya ◽  
N N Fedorova

2014 ◽  
Vol 96 ◽  
pp. 39-44
Author(s):  
Brais Vazquez ◽  
Alessia Nicosia ◽  
Franco Belosi ◽  
Gianni Santachiara ◽  
Paolo Monticelli ◽  
...  

In recent decades, Heat and Moisture Exchange (HME) devices have been employed increasingly for short-term use in anaesthesia and long-term use in intensive care units. These devices work as heat exchangers, accumulating the patient’s expired heat and moisture and returning them to the patient during the inhalation phase. Porous matrices obtained from freeze-drying of blends of natural polymers exhibit high open and interconnected porosity and water vapour intake characteristics which make them possible candidates for HME devices. Preliminary tests were conducted on specimens made of gelatine blended with chitosan and treated with a non-toxic cross-linking agent. The tests were carried out in cyclic flow conditions with saturated and dried air. Results show water vapour retention comparable with accepted standards for HME devices.


1973 ◽  
Vol 1 (5) ◽  
pp. 428-432 ◽  
Author(s):  
C. A. Shanks ◽  
C., A. Sara

The multiple gauze heat and moisture exchanger was assessed under standardized conditions, at five levels of predetermined fresh gas humidity. As predicted theoretically, the unit functioned best when presented with fresh gases with high water vapour content. The ordinary unit moistened arid gases during inspiration to a level unacceptable for prolonged use. Unheated simple humidification systems dampen anhydrous stored gases and combined with the standard condenser-humidifier produce a microclimate suitable for entry into the trachea during spontaneous or controlled ventilation. Quadrupling the number of gauzes improved heat and moisture exchange with all but the saturated fresh gases. However, there was a considerable increase in weight.


Author(s):  
Anna Jackson ◽  
James Hull ◽  
James Hopker ◽  
William Gowers ◽  
John Dickinson

Sign in / Sign up

Export Citation Format

Share Document