A LOW DROPOUT REGULATOR WITH LOW QUIESCENT CURRENT AND HIGH POWER SUPPLY REJECTION OVER WIDE RANGE OF FREQUENCY FOR SOC

2011 ◽  
Vol 20 (01) ◽  
pp. 1-13 ◽  
Author(s):  
CHENCHANG ZHAN ◽  
WING-HUNG KI

A CMOS low quiescent current low dropout regulator (LDR) with high power supply rejection (PSR) and without large output capacitor is proposed for system-on-chip (SoC) power management applications. By cascoding a power NMOS with the PMOS pass transistor, high PSR over a wide frequency range is achieved. The gate-drive of the cascode NMOS is controlled by an auxiliary LDR that draws only 1 μA from a small charge pump, thus helping in reducing the quiescent current. Adaptive biasing is employed for the multi-stage error amplifier of the core LDR to achieve high loop gain hence high PSR at low frequency, low quiescent current at light load and high bandwidth at heavy load. A prototype of the proposed high-PSR LDR is fabricated using a standard 0.35 μm CMOS process, occupying an active area of 0.066 mm2. The lowest supply voltage is 1.6 V and the preset output voltage is 1.2 V. The maximum load current is 10 mA. The measured worst-case PSR at full load without using large output capacitor is -22.7 dB up to 60 MHz. The line and load regulations are 0.25 mV/V and 0.32 mV/mA, respectively.

2011 ◽  
Vol 483 ◽  
pp. 481-486 ◽  
Author(s):  
Xiao Wei Liu ◽  
Bing Jun Lv ◽  
Peng Fei Wang ◽  
Liang Yin ◽  
Na Xu

The reference is an important part in the accelerometer system. With the development of science and technology, the request of the performance of accelerometers is increasingly higher and the precision of reference directly affects the performance of accelerometers. Therefore, a reference voltage applicable to accelerometers is presented based on the analysis of basic principles of conventional bandgap reference (BGR) in this paper. A high-order curvature compensation technique, which uses a temperature dependent resistor ratio generated by a high poly resistor and a nwell resistor, effectively serves to reduce temperature coefficient of proposed reference voltage circuit and to a large extent improve its performance. To achieve a high power supply rejection ratio (PSRR) over a broad frequency range, a pre-regulator is introduced to remain the supply voltage of the core circuit of BGR relatively independent of the global supply voltage. The proposed circuitry is designed in standard 2.0μm CMOS process. The simulated result shows that the average temperature coefficient is less than 2ppm/°C in the temperature range from -40 to 120°C. The improvement on temperature coefficient (TC) is about 10 times reduction compared to the conventional approach. And the PSR at DC frequency and 1kHz achieves -107 and -71dB respectively at 9.0V supply voltage.


Energies ◽  
2019 ◽  
Vol 12 (2) ◽  
pp. 211 ◽  
Author(s):  
Jihoon Park ◽  
Woong-Joon Ko ◽  
Dong-Seok Kang ◽  
Yoonmyung Lee ◽  
Jung-Hoon Chun

An output capacitor-less low-dropout (OCL-LDO) regulator with a wide range of load currents is proposed in this study. The structure of the proposed regulator is based on the flipped-voltage-follower LDO regulator. The feedback loop of the proposed regulator consists of two stages. The second stage is turned on or off depending on the variation in the output load current. Hence, the regulator can retain a phase margin at a wide range of load currents. The proposed regulator exhibits a better regulation performance compared to the ones in previous studies. The test chip is fabricated using a 65-nm CMOS process.


Sign in / Sign up

Export Citation Format

Share Document