scholarly journals Influence of environmental change, harvest exposure, and human disturbance on population trends of greater sage-grouse

PLoS ONE ◽  
2021 ◽  
Vol 16 (9) ◽  
pp. e0257198
Author(s):  
Jonathan B. Dinkins ◽  
Kirstie J. Lawson ◽  
Jeffrey L. Beck

Hunter harvest of greater sage-grouse (Centrocercus urophasianus; hereafter “sage-grouse”) has been regulated by wildlife agencies during most of the past century. Hunting season regulations were maintained with the intention of providing sustainable hunting opportunities. Sage-grouse populations oscillate over time, and population growth can be influenced by seasonal weather and habitat disturbance. From 1995–2013, we compared sage-grouse lek trends from 22 relatively distinct sage-grouse population segments in 9 western U.S. states and 2 Canadian provinces. We stratified these populations into 3 broad categories (non-hunted [n = 8], continuously hunted [n = 10], and hunting season discontinued between 1996–2003 [n = 4]) with 8 different regulation histories to evaluate the potential impact of harvest on sage-grouse populations. Concomitantly, we assessed the effects of proportion burned, forested and cropland habitat; winter, spring, and summer precipitation; and human population, road, and oil and gas well densities on initial and time-varying lek counts. Density-dependent models fit lek trend data best for all regulation histories. In general, higher proportions of burnt, forested, and cropland habitat; and greater human population and oil and gas well densities were associated with lower equilibrium abundance (K). We found mixed results regarding the effect of hunting regulations on instantaneous growth rate (r). The cessation of harvest from 1996–2001 in approximately half of the largest sage-grouse population in our analysis was associated with higher r. Continuously harvested sage-grouse populations with permit hunting seasons had higher r during years with higher proportion of area exposed to permitted hunting rather than general upland game seasons. However, more liberal hunting regulations were positively associated with higher r in populations continuously harvested under general upland game hunts. Our results suggest that discontinuing harvest in the largest population resulted in greater population growth rates; however, this was not consistently the case for smaller populations. To no surprise, not all sage-grouse populations were influenced by the same environmental change or human disturbance factors. Our results will assist managers to understand factors associated with K, which provides the best targets for conservation efforts.

PLoS ONE ◽  
2021 ◽  
Vol 16 (10) ◽  
pp. e0253635
Author(s):  
Jonathan B. Dinkins ◽  
Courtney J. Duchardt ◽  
Jacob D. Hennig ◽  
Jeffrey L. Beck

Hunter harvest is a potential factor contributing to population declines of sage-grouse (Centrocercus spp.). As a result, wildlife agencies throughout western North America have set increasingly more conservative harvest regulations over the past 25 years to reduce or eliminate hunter success and concomitant numbers of harvested greater (C. urophasianus) and Gunnison (C. minimus) sage-grouse. Sage-grouse hunting has varied widely over time and space, which has made a comprehensive summary of hunting management challenging. We compiled data on harvest regulations among 11 western U.S. states and 2 Canadian provinces from 1870–2019 to create a timeline representative of hunting regulations. We compared annual harvest boundaries and area-weighted average hunting regulations, 1995–2018, relative to administrative boundaries and areas of high probability of sage-grouse occupation. We also summarized estimated numbers of birds harvested and hunters afield, 1995–2018, across both species’ ranges. From 1995–2018, there was a 30% reduction in administrative harvest boundaries across the greater sage-grouse range compared to a 16.6% reduction in area open to harvest within 8 km from active leks. Temporary closures occurred in response to wildfires, disease outbreaks, low population numbers, and two research projects; whereas, permanent closures primarily occurred in small populations and areas on the periphery of the species distribution. Similarly, area-weighted possession limits and season length for greater sage-grouse decreased 52.6% and 61.0%, respectively, while season start date stayed relatively stable (mean start date ~259 [mid-September]). In contrast, hunting of the now federally-threatened Gunnison sage-grouse ended after 1999. While restrictions in harvest regulations were large in area, closures near areas of high greater sage-grouse occupancy were relatively smaller with the same trend for Gunnison sage-grouse until hunting ceased. For greater sage-grouse, most states reduced bag and possession limits and appeared to adhere to recommendations for later and shorter hunting seasons, reducing potential for additive mortality.


2021 ◽  
Vol 1064 (1) ◽  
pp. 012059
Author(s):  
R R Gazizov ◽  
A P Chizhov ◽  
V E Andreev ◽  
A V Chibisov ◽  
V V Mukhametshin ◽  
...  

2013 ◽  
Vol 423-426 ◽  
pp. 2035-2039
Author(s):  
Long Cang Huang ◽  
Yin Ping Cao ◽  
Yang Yu ◽  
Yi Hua Dou

In the process of oil and gas well production, tubing connection stand the axial alternating load during open well, shut well and fluid flow. In order to know premium connection seal ability under the loading, two types of P110 88.9mmx6.45mm premium tubing connections which called A connection and B connection are performed with finite element analysis, in which contact pressures and their the regularities distribution on sealing surface are analyzed. The results show that with the increasing of cycle number, the maximum contact pressures on sealing surface of both A connection and B connection are decreased. The decreasing of the maximum contact pressures on B connection is greater than those on A connection. With the increasing of cycle number of axial alternating compression load, the maximum contact pressure on sealing surface of A connection is decreased, and the maximum contact pressure on sealing surface of B connection remains constant. Compared the result, it shows that the seal ability of A connection is better than B connection under axial alternating tension load, while the seal ability of B connection is better than type A connection under axial alternating compression load.


Sign in / Sign up

Export Citation Format

Share Document