scholarly journals Construction of a mathematical model of the film absorber for sulfating two-component mixtures of organic substances

2021 ◽  
Vol 6 (6 (114)) ◽  
Author(s):  
Oleksandr Dzevochko ◽  
Mykhaylo Podustov ◽  
Alona Dzevochko ◽  
Vladimir Panasenko
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Mathematical Model ◽  
Sulfur Trioxide ◽  
Coconut Oil ◽  
Molar Ratio ◽  
Organic Substances ◽  
Two Component ◽  
Gaseous Sulfur ◽  
The Mathematical Model

The processes that occur in film absorbers during the sulfation of two-component mixtures of organic substances are quite complex and require mathematical modeling. This paper reports the construction of a mathematical model that makes it possible to adequately describe the process of sulfation involving gaseous sulfur trioxide in the production of surfactants. Based on the model, it became possible to investigate this process for higher alcohols of fractions С12–С14 and monoethanolamides of higher fatty acids of coconut oil. The data are given on the comparison of mathematical modeling results based on the mathematical model built with known experimental data and results of alternative mathematical modeling for different ratios of the length of the reaction pipe to its diameter (l/d). It is shown that the error in comparing the experimental data was 4.8–9.6 % at l l/d=29; 1.1–8.7 % at l/d=70; 3.9–12.3 % at l/d=144. The error in comparing known results of alternative mathematical modeling was, respectively, 6.3–7.2 %, 0.1–6.5 %, 0–1.0 %. These results were obtained for the molar ratio in the range of 1.0–1.15 and the SO3 concentration in the stream of 4.0–6.0 %. Such findings suggest that the established dependences of the basic parameters for the sulfation process are adequate in terms of the absorber length and its radial direction. Therefore, the mathematical model built does hold within the considered ranges of input variables. Consequently, it could be used in the theoretical study of the process of sulfation of two-component mixtures of organic substances by gaseous sulfur trioxide in a film absorber with a downward flow of phases. The results obtained could be used in practice, in particular in the manufacture of high-quality products for the cosmetic industry.

scholarly journals Experimental studies of the method of mutual load of induction motors

2020 ◽  
pp. 44-49
Author(s):  
V. V. Kharlamov ◽  
◽  
D. I. Popov ◽  
P. S. Sokolov ◽  
L. E. Serkova ◽  
...  
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Mathematical Model ◽  
Induction Motors ◽  
Experimental Studies ◽  
Electromechanical System ◽  
Experimental Equipment ◽  
Frequency Converters ◽  
Parameter Values ◽  
The Mathematical Model

The article presents the results of comparison of experimental studies and mathematical modeling of the stand for testing induction motors by the method of mutual load. A detailed description of the composition of the experimental equipment, which is based on a pair of frequency converters and connected to them a pair of engines of the АИС71В4 type with a nominal power of 0,75 kW, the shafts of which are rigidly connected by a coupling. The mathematical model of the electromechanical system used in the calculations is presented, and its main assumptions are listed. A table of parameter values and graphs obtained from calculated and experimental data are presented. The analysis of the obtained data shows the possibility of using the considered mathematical model with the existing assumptions in the design of electrical complexes intended for testing induction motors by the method of mutual load

scholarly journals The Mathematical Modeling of Ca And Fe Distribution In Peat Layers

2015 ◽  
Vol 2 ◽  
pp. 40
Author(s):  
Ērika Teirumnieka ◽  
Ilmārs Kangro ◽  
Edmunds Teirumnieks ◽  
Harijs Kalis ◽  
Aigars Gedroics
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Mathematical Model ◽  
Trace Elements ◽  
Mathematical Models ◽  
Organic Material ◽  
Low Concentrations ◽  
The Mathematical Model ◽  
Research Show

Bogs have been formed by an accumulation of peat - a light brown-to-black organic material, built up from partial decomposition of mosses and other bryophytes, sedges, grasses, shrubs, or trees under waterlogged conditions. The total peatlands area in Latvia covers 698 918 ha or 10.7% of the entire territory. Knowledge’s of peat metals content are important for any kind of peat using. Experimental determination of metals in peat is very long and expensive work. Using experimental data mathematical model for calculation of concentrations of metals in different points for different layers can help to very easy and fast to find approximately concentration of metals or trace elements. The results of the research show that concentrations of trace elements in peat are generally low. Concentrations differ between the superficial, middle and bottom peat layers, but the significance decreases depending on the type of mire. The mathematical model for calculation of concentration of metals in different points for different 3 layers in peat blocks is developed. As an example, mathematical models for calculation of Ca and Fe concentrations have been analyzed.

scholarly journals Methodology for predicting oily mixture properties in the mathematical modeling of molecular distillation

2017 ◽  
Vol 68 (2) ◽  
pp. 193 ◽  
Author(s):  
M. F. Gayol ◽  
M. C. Pramparo ◽  
S. M. Miró Erdmann
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Mathematical Model ◽  
Molecular Distillation ◽  
Computer Code ◽  
Deodorizer Distillate ◽  
System Of Differential Equations ◽  
Prediction Of Properties ◽  
Implicit Finite Difference ◽  
The Mathematical Model

A methodology for predicting the thermodynamic and transport properties of a multi-component oily mixture, in which the different mixture components are grouped into a small number of pseudo components is shown. This prediction of properties is used in the mathematical modeling of molecular distillation, which consists of a system of differential equations in partial derivatives, according to the principles of the Transport Phenomena and is solved by an implicit finite difference method using a computer code. The mathematical model was validated with experimental data, specifically the molecular distillation of a deodorizer distillate (DD) of sunflower oil. The results obtained were satisfactory, with errors less than 10% with respect to the experimental data in a temperature range in which it is possible to apply the proposed method.

scholarly journals Impact Force Magnitude Analysis of an Impact Pendulum Suspended in a Vibrating Structure

2012 ◽  
Vol 19 (6) ◽  
pp. 1359-1372 ◽  
Author(s):  
R.R. Aguiar ◽  
H.I. Weber
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Mathematical Model ◽  
Impact Force ◽  
Experimental Measurements ◽  
Force Magnitude ◽  
Force Profile ◽  
The Rich ◽  
The Impact ◽  
The Mathematical Model

The purpose of this work is the experimental investigation and the mathematical modeling of the impact force behavior in a vibro-impact system, where an impact pendulum is mounted on a cart that moves with a prescribed displacement. The dynamics of the system will be evaluated considering different excitation frequencies and changing the impact gap. Experimental data are used to validate the mathematical model. The mathematical model allows a detailed nonlinear analysis, showing the rich response of the system, which includes dynamical jumps, bifurcations and chaos. In impact systems, discrepancies between numerical results and experimental measurements are common due to the difficulty in describing all factors that influence the resulting impact force profile. The use of wires to suspend the impacting body has the purpose to limit these uncertainties.

Application of a Bubble-Induced Turbulence Model to Subcooled Boiling in a Vertical Pipe

1999 ◽  
Author(s):  
Mahmut D. Mat ◽  
Yüksel Kaplan ◽  
Olusegun J. Ilegbusi
Keyword(s):  
Experimental Data ◽  
Mathematical Model ◽  
Liquid Phase ◽  
Turbulence Model ◽  
Transport Equations ◽  
Subcooled Boiling ◽  
Vertical Pipe ◽  
Void Fractions ◽  
Turbulence Production ◽  
The Mathematical Model

Abstract Subcooled boiling of water in a vertical pipe is numerically investigated. The mathematical model involves solution of transport equations for vapor and liquid phase separately. Turbulence model considers the turbulence production and dissipation by the motion of the bubbles. The radial and axial void fractions, temperature and velocity profiles in the pipe are calculated. The estimated results are compared to experimental data available in the literature. It is found that while present study satisfactorily agrees with experimental data in the literature, it improves the prediction at lower void fractions.

Methods of Mathematical Modeling of the Leaching Process of Cobalt-Containing Solutions

2021 ◽  
Vol 316 ◽  
pp. 661-666
Author(s):  
Nataliya V. Mokrova
Keyword(s):  
Mathematical Modeling ◽  
Mathematical Model ◽  
Chemical Kinetics ◽  
Group Method ◽  
Data Handling ◽  
Multistage Processes ◽  
Leaching Process ◽  
Proposed Model ◽  
Simulation Results ◽  
The Mathematical Model

Current cobalt processing practices are described. This article discusses the advantages of the group argument accounting method for mathematical modeling of the leaching process of cobalt solutions. Identification of the mathematical model of the cascade of reactors of cobalt-producing is presented. Group method of data handling is allowing: to eliminate the need to calculate quantities of chemical kinetics; to get the opportunity to take into account the results of mixed experiments; to exclude the influence of random interference on the simulation results. The proposed model confirms the capabilities of the group method of data handling for describing multistage processes.

A prey–predator model and control of a nematodes pest using control in banana: Mathematical modeling and qualitative analysis

2021 ◽  
pp. 2150089
Author(s):  
Sudhakar Yadav ◽  
Vivek Kumar
Keyword(s):  
Mathematical Modeling ◽  
Mathematical Model ◽  
Local Stability ◽  
Detection Method ◽  
Initial Release ◽  
Pest Detection ◽  
Predator Model ◽  
And Control ◽  
The Mathematical Model ◽  
Theoretical Results

This study develops a mathematical model for describing the dynamics of the banana-nematodes and its pest detection method to help banana farmers. Two criteria: the mathematical model and the type of nematodes pest control system are discussed. The sensitivity analysis, local stability, global stability, and the dynamic behavior of the mathematical model are performed. Further, we also develop and discuss the optimal control mathematical model. This mathematical model represents various modes of management, including the initial release of infected predators as well as the destroying of nematodes. The theoretical results are shown and verified by numerical simulations.

Analytical Study of Hydro-Pneumatic Processes for Gorlov's Power System

1994 ◽  
Vol 208 (1) ◽  
pp. 67-70
Author(s):  
A I Ryazanov
Keyword(s):  
Experimental Data ◽  
Mathematical Model ◽  
Power System ◽  
Analytical Study ◽  
Model Tests ◽  
Air Pressure ◽  
Pneumatic Power ◽  
Time Required ◽  
The Mathematical Model

This paper describes the aerohydrodvnamics of processes in chambers of Gorlov's hydro-pneumatic power system. The mathematical model is developed to determine the main parameters of the processes: water and air velocities, air pressure in the chamber, the periods of time required to fill and empty the chambers and the output of energy during the cycle. The results obtained are in agreement with experimental data and model tests.

scholarly journals MATHEMATICAL MODELING OF LEACHING PROCESS OF RED MUD IN ORDER TO OBTAIN THE KINETICS PARAMETERS

2015 ◽  
Vol 14 (2) ◽  
pp. 90 ◽  
Author(s):  
K. L. M. Dos Passos ◽  
B. M. Viegas ◽  
E. N. Macêdo ◽  
J. A. S. Souza ◽  
E. M. Magalhães
Keyword(s):  
Experimental Data ◽  
Mathematical Model ◽  
Red Mud ◽  
Mineralogical Composition ◽  
Raw Material ◽  
Data Conversion ◽  
Kinetics Parameters ◽  
Leaching Process ◽  
Iron Leaching ◽  
The Mathematical Model

The use of the waste of the Bayer process, red mud, is due to its chemical and mineralogical composition that shows a material rich in oxides of iron, titanium and aluminum. Some studies conducted show that this waste can be applied as a source of alternative raw material for concentration and subsequent recovery of titanium compounds from an iron leaching process, which is present in higher amounts, about 30% by weight. To obtain a greater understanding about the leaching kinetics, the information of the kinetic data of this process is very important. In this context, the main objective of this work is the development of a mathematical model that is able to fit the experimental data (conversion / extraction iron, titanium and aluminum) of the leaching process by which is possible to obtain the main kinetic parameters such as the activation energy and the velocity of chemical reactions as well as the controlling step of the process. The development of the mathematical model was based on the model of core decreasing. The obtained model system of ordinary differential equations was able to fit the experimental data obtained from the leaching process, enabling the determination of the controlling step, the rate constants and the activation energies of the leaching process.

scholarly journals Population Behavior in the Mathematical Model of the Spread of COVID19 Type SEIRS

2021 ◽  
Vol 6 (2) ◽  
pp. 83-88
Author(s):  
Asmaidi As Med ◽  
Resky Rusnanda
Keyword(s):  
Mathematical Modeling ◽  
Numerical Simulation ◽  
Mathematical Model ◽  
Everyday Life ◽  
Applied Mathematics ◽  
Living Things ◽  
Simulation Results ◽  
Parameter Values ◽  
The Mathematical Model ◽  
Disease Free

Mathematical modeling utilized to simplify real phenomena that occur in everyday life. Mathematical modeling is popular to modeling the case of the spread of disease in an area, the growth of living things, and social behavior in everyday life and so on. This type of research is included in the study of theoretical and applied mathematics. The research steps carried out include 1) constructing a mathematical model type SEIRS, 2) analysis on the SEIRS type mathematical model by using parameter values for conditions 1and , 3) Numerical simulation to see the behavior of the population in the model, and 4) to conclude the results of the numerical simulation of the SEIRS type mathematical model. The simulation results show that the model stabilized in disease free quilibrium for the condition  and stabilized in endemic equilibrium for the condition .

Sign in / Sign up

Export Citation Format

Share Document