scholarly journals Application of in-plastic catalysis for extraction of hard-to-recover hydrocarbons

2021 ◽  
Vol 6 (3(62)) ◽  
pp. 6-10
Author(s):  
Ivan Zezekalo ◽  
Viktor Kovalenko ◽  
Iryna Lartseva ◽  
Olexandr Dubyna

The object of research is the catalytic effect (hydrocracking) for the production of hard-to-recover hydrocarbons, the subject of the study is the change in the physicochemical properties of hydrocarbons by partial gasification, and the lightening of the fractional composition of hydrocarbons. One of the most problematic areas is the lack of studies of the catalytic effect on hard-to-recover hydrocarbons in reservoir conditions. Although processes such as catalytic cracking, reforming, isomerization, aromatization and alkylation of hydrocarbons are known and used in petroleum refining. The research used the methods of scientific knowledge – experiment and measurement. In the course of laboratory work, an effective catalyst was developed, the effect of temperature on the fractional composition and physicochemical properties of oil, oil products and gas condensate was investigated. To simulate formation conditions, hermetic metal retorts were used, in which oil and gas condensate samples were subjected to different temperature regimes. In the process of testing cores saturated with gas condensate, the dependence of filtration on physical parameters – temperature and pressure, fractional composition, specific gravity and viscosity was studied. Laboratory studies have shown a decrease in density and viscosity of hydrocarbons, an increase in core permeability. The effect of catalysis on oil made it possible to increase the volume of light ends distillation from 30 to 60 %, for gas condensate – up to 50 %, which confirms the effectiveness of the method of catalysis of hard-to-recover hydrocarbons. This is due to the fact that the correct formulation and solution of the problem provided adequate results. In contrast to the existing processes of hydrocracking of petroleum products, the proposed method allows you to extract heavy and low-mobile hydrocarbons in reservoir conditions at lower temperatures of 120–150 °С. At the same time, the technology for catalytic hydrogenation of hard-to-recover hydrocarbons will be similar to a typical treatment of a formation with an acid or surfactants. This will make it possible to intensify the commercial reserves of hydrocarbons in the fields that are now classified as hard-to-recover and which account for more than 50 %.

2020 ◽  
pp. 140-146
Author(s):  
S. I. Chelombitko ◽  
V. V. Piven

During the development of oil and gas fields and transportation of hydrocarbons, the ecology of regions is subject to various negative impacts. The most severe consequences for the environment are caused by accidental spills of oil or petroleum products, which occur due to through damage to pipelines. Polluted territories are subject to mandatory reclamation in accordance with government regulations and industry regulations. However, despite the measures taken by the administrations of the northern regions to increase the rate of reclamation of damaged territories in recent years, there has been a trend of growth of areas contaminated with hydrocarbons.Various remediation technologies that have been tested in warm and temperate climates are not very effective in regions with permafrost. Pollution of the daytime surface with oil or petroleum products leads to an increase in the absorption of the sun's radiant energy, the growth of the seasonal thaw layer and the development of destructive processes for the territory. To achieve a positive effect as a result of rehabilitation measures, it is necessary to take into account the individual characteristics of the territory and the extent of its pollution.


2017 ◽  
Vol 11 (12) ◽  
pp. 2793-2808 ◽  
Author(s):  
Julien Tremblay ◽  
Etienne Yergeau ◽  
Nathalie Fortin ◽  
Susan Cobanli ◽  
Miria Elias ◽  
...  

2014 ◽  
Author(s):  
R.. Hosein ◽  
R.. Mayrhoo ◽  
W. D. McCain

Abstract Bubble-point and dew-point pressures of oil and gas condensate reservoir fluids are used for planning the production profile of these reservoirs. Usually the best method for determination of these saturation pressures is by visual observation when a Constant Mass Expansion (CME) test is performed on a sample in a high pressure cell fitted with a glass window. In this test the cell pressure is reduced in steps and the pressure at which the first sign of gas bubbles is observed is recorded as bubble-point pressure for the oil samples and the first sign of liquid droplets is recorded as the dew-point pressure for the gas condensate samples. The experimental determination of saturation pressure especially for volatile oil and gas condensate require many small pressure reduction steps which make the observation method tedious, time consuming and expensive. In this study we have extended the Y-function which is often used to smooth out CME data for black oils below the bubble-point to determine saturation pressure of reservoir fluids. We started from the initial measured pressure and volume and by plotting log of the extended Y function which we call the YEXT function, with the corresponding pressure, two straight lines were obtained; one in the single phase region and the other in the two phase region. The point at which these two lines intersect is the saturation pressure. The differences between the saturation pressures determined by our proposed YEXT function method and the observation method was less than ± 4.0 % for the gas condensate, black oil and volatile oil samples studied. This extension of the Y function to determine dew-point and bubble-point pressures was not found elsewhere in the open literature. With this graphical method the determination of saturation pressures is less tedious and time consuming and expensive windowed cells are not required.


Author(s):  
M. O. Fedorovich ◽  
◽  
A. Yu. Kosmacheva ◽  

The present paper describes the DIONISOS software package (Beicip-Technologies), where the reconstruction of the accumulation conditions and facies modeling of sand reservoirs Yu10, Yu9, Yu8, Yu7 and Yu6 of the Tyumenskaya Formation and carbonaceous-clay members acting as fluid seals within the Gerasimovskoye oil and gas condensate field located in the south of the Parabel district of the Tomsk region. Reconstructions of facies environments make it possible to consistently restore conditions and create a general principled model of the accumulation of sandy-argillaceous deposits of the Middle Jurassic PP in a given territory. Polyfacies deposits of the Bajocian are represented by sands of distributaries and stream-mouth bars, underwater slope of delta, above-water and underwater delta plains, argillaceous-carbonaceous sediments of floodplain lakes, bogs, marshes and lagoons, clays formed at the border of the above-water and underwater deltaic plains, silt deposits of above-water and underwater delta plains, prodelta clays. As a result of the 3D facies model construction, it is shown that the subcontinental sedimentary environments of sand reservoirs Yu10–Yu8 are replaced by deltaic and floodplain-lacustrine-boggy ones, and the formation of Yu7–Yu6 reservoirs occurs in conditions of coastal plain, periodically flooded by the sea. In total, 5 lithotypes of sand deposits have been identified, 1 – argillaceous-carbonaceous, 2 – argillaceous and 1 – silty. Computer facies 3D modeling of the sand bodies assemblage (hydrocarbon reservoirs) of the Bajocian age for the Gerasimovskoye oil and gas condensate field has been performed.


2021 ◽  
Vol 66 (1) ◽  
pp. 72-79
Author(s):  
Thuoc Doan Van ◽  
Hung Nguyen Phuc

The effect of physical parameters such as temperature and pH on the production, activity, and stability of α-amylase from Bacillus subtilis V37 was investigated. The results indicated that the optimum culture conditions for enzyme activity were pH 7.0 and 35 oC. The optimum pH and temperature for enzyme activity were 6.0 and 70 oC. The crude enzyme was found to be stable in the pH range of 5.0 to 7.0. The enzyme was stable for 1 h at a temperature from 30 to 80 oC; nearly 100% of enzyme activity remained at temperatures of 30 - 40 oC, and about 34% of original activity remained at a temperature of 80 oC. These features demonstrated that α-amylase from B. subtilis V37 can be applied in many areas such as the food, fermentation, and animal feed industries.


2021 ◽  
pp. 127-139
Author(s):  
E. A. Gromova ◽  
S. A. Zanochuev

The article highlights the relevance of reliable estimation of the composition and properties of reservoir gas during the development of gas condensate fields and the complexity of the task for reservoirs containing zones of varying condensate content. The authors have developed a methodology that allows monitoring the composition of gas condensate well streams of similar reservoirs. There are successful examples of the approach applied in Achimov gas condensate reservoirs at the Urengoy oil and gas condensate field. The proposed approach is based on the use of the so-called fluid factors, which are calculated on the basis of the known component compositions of various flows of the studied hydrocarbon system. The correlation between certain "fluid factors" and the properties of reservoir gas (usually determined by more labor-consuming methods) allows one to quickly obtain important information necessary to solve various development control tasks.


Sign in / Sign up

Export Citation Format

Share Document