scholarly journals DEVELOPMENT OF THE TECHNOLOGY OF SOYA FLOUR ENRICHED WITH IODINE

2020 ◽  
Vol 14 (2) ◽  
Author(s):  
Ya. Beletska ◽  
R. Plotnikova ◽  
M. Bakirov ◽  
O. Vereshchynskyi

A research on developing a technology of iodine-enriched soya flour has been conducted. The technology developed will allow the body to receive organic forms of this micronutrient, the deficiency in which causes thyroid disorders in 40% of Ukrainians and 35% of people throughout Europe. The research has shown that promising soya bean varieties to be enriched with iodine are the early-ripening varieties Almaz, Anzhelika, Kyivska 98, Faeton, Medeya, PSV 808, Podyaka, Khortytsya, Yug 30, Rusa. They are the highest in protein (42.75% on average), the maximum content of which is necessary for iodine accumulation. Besides, their cropping period is short (up to 95–105 days), which is cost-effective for a manufacturing enterprise, because there is no overlapping with the winter crops sowing time and thus, there are no periods when cultivation areas remain idle. The following parameters of steeping soya beans have been found rational: the iodine concentration in the solution 98-100 μg/g, the duration of steeping 48 hours. The mass fraction of iodine in the steeped soya beans is 126 μg/g. Longer steeping leads to microbiological spoilage of sprouted soya beans. It has been determined how iodine is distributed in cotyledons, sprouts, seed coats, and whole sprouted soya beans. This has allowed establishing that in a whole sprouted soya bean of the early-ripening soya variety Almaz, the iodine content is 126 μg/g, of which 123 μg/g is accumulated in the cotyledons of a seed, and 3 μg/g in the sprouts and the seed coats. This indicates a high level of iodine conversion into the organic form when soya seeds are steeped in potassium iodide solution. A technology of manufacturing iodine-enriched flour from sprouted soya beans has been developed. It differs from the control one in that soya seeds, washed and disinfected, are soaked in potassium iodide solution (with the iodine concentration 98–100 μg/g and the hydromodulus 1:2) for 48 hours at the solution temperature 14-16°С. Flour from sprouted soya beans contains 126 μg/g of iodine. The technology suggested can be used at hotel and catering enterprises, in sanatoria and health centres, to treat iodine-deficiency disorders, and to make food for people who need special dietetic nutrition.

2021 ◽  
Author(s):  
Hiroto Matsuura ◽  
Nguyen Tran Trung ◽  
Bounyang Ouanthavinsak ◽  
Jin Sakamoto ◽  
Yuichiro Takemura ◽  
...  

2016 ◽  
Vol 38 (2) ◽  
pp. 67-70
Author(s):  
A. V. Mamaenko ◽  
A. O. Samsoni Todorov ◽  
O. V. Zui ◽  
V. A. Yaremenko ◽  
V. V. Goncharuk

1993 ◽  
Vol 76 (2) ◽  
pp. 292-296 ◽  
Author(s):  
Kumiko Sasaki ◽  
Keiji Kijima ◽  
Mitsuharu Takeda ◽  
Shigeo Kojima

Abstract A simple specific determination method was developed for ethylene oxide (EO) and ethylene chlorohydrin (ECH) in cosmetics and surfactants. EO is desorbed from samples by using a nitrogen stream and absorbed into acidic potassium iodide solution, where it is converted to ethylene iodohydrin (EIH). Any remaining ECH in the samples is converted to EO by the addition of sodium hydroxide, and the desorption procedure is repeated with a fresh acidic potassium iodide absorbing solution. EIH is extracted with benzene and determined by gas chromatography with electron capture detection. EO and ECH contents in the samples are calculated from EIH results. Recoveries from water and shampoo samples were 70.3 ± 5.4 and 58.9 ± 1.2%, respectively, for EO and 66.3 ± 4.0 and 64.5 ± 4.6%, respectively, for ECH. Detection limits in 0.2-2.0 g samples were in the 0.005-0.03 μg/g range for EO and 0.01-0.07 μg/g for ECH. High levels of EO (30-394 μg/g as ECH) were found in 5 of 18 polyoxyethylated surfactant samples, but only small amounts (0.07-4.0 μg/g) of ECH were detected in the samples. EO was not detected in cosmetic samples tested, but ECH was present in small quantities (≤1.11 μg/g).


1970 ◽  
Vol 48 (18) ◽  
pp. 2847-2852 ◽  
Author(s):  
Digby D. MacDonald ◽  
G. A. Wright

Dissolution of bismuth metal by tri-iodide ion in acidified potassium iodide medium has been studied using a rotating disc technique. The rate constant for the dissolution process, kT, in solutions 0.5 M in potassium iodide at 25.0 °C has been shown to be related to the square root of the disc angular velocity, ω, by the following expression[Formula: see text]The activation energy for this reaction was found to be 4.7 kcal mole−1. These data clearly establish that the rate of dissolution is determined by the rate at which tri-iodide ion is transported to the metal surface. In solutions of [KI] = 0.10 M, however, the rate determining step appears to involve diffusion of tri-iodide ion through a layer of BiI3 which forms on the bismuth metal surface as the reaction proceeds.


2008 ◽  
Vol 20 (20) ◽  
pp. 2265-2270 ◽  
Author(s):  
Mei-Hsin Chiu ◽  
Jyh-Myng Zen ◽  
Annamalai Senthil Kumar ◽  
Dhananjayan Vasu ◽  
Ying Shih

AIHAJ ◽  
1992 ◽  
Vol 53 (10) ◽  
pp. 672-672 ◽  
Author(s):  
M. Hekmat ◽  
P. Fung ◽  
R. Smith

1964 ◽  
Vol 10 (7) ◽  
pp. 575-580 ◽  
Author(s):  
Lee Kum-Tatt ◽  
P C Leong

Abstract A simple method for the determination of ascorbic acid in urine was developed. The method is based on the quantitative reduction of mercuric chloride to mercurous chloride at pH 3.5-5.0. The insoluble mercurous chloride was separated by centrifugation, dissolved in excess standard iodine-potassium iodide solution and back-titrated with standard sodium thiosulphate. The method has precision, and as little as 1.0 mg. of ascorbic acid per 100 ml. of urine can be determined with an accuracy of ± 3%. Common substances found in urine do not interfere.


Sign in / Sign up

Export Citation Format

Share Document