Designing and Modeling of a Municipal Wastewater Treatment Plant With GPS-X

Wastewater treatment is the process used to remove contaminants from wastewater to produce an effluent suitable for discharge to the environment. Several kinds of wastewater are treated based on the concentration of various parameters. Domestic Wastewater/Municipal Wastewater is treated in Sewage Treatment Plants (STP), which involve various types of processes like physical, chemical and biological to treat the wastewater better. The treatment plant involves five steps of the process – preliminary treatment, primary treatment, secondary treatment, tertiary treatment and sludge treatment to meet the safe disposal guidelines of the department of the environment. In this paper, a municipal wastewater treatment plant for Uttara City is designed and modeled with GPS-X. GPS-X is a wastewater treatment plant modeling software package that is used for verify the treatment process. The design calculation of all unit operations is shown with a specification table. The Process Flow Diagram (PFD), Process Block Diagram (PBD) and mass balance of the process are expressed in the article. The design calculation of the STP is performed with a steady-state process. After each unit operation, the concentration of various parameters – TSS, BOD, VSS, TN is analyzed and the removal efficiency for different equipment is calculated. The STP is designed to maintain the guidelines of the Department of Environment, Bangladesh. At the end of the paper, the designing and modeling steps of a sewage treatment plant will be pursued. Finally, some recommendations are done in the conclusion section.