Use of an Internal Standard with Differential X-ray Diffraction Analysis for Iron Oxides

1983 ◽  
Vol 47 (1) ◽  
pp. 168-173 ◽  
Author(s):  
R. B. Bryant ◽  
N. Curi ◽  
C. B. Roth ◽  
D. P. Franzmeier
Keyword(s):  
Diffraction Analysis ◽  
Iron Oxides ◽  
Internal Standard ◽  
X Ray Diffraction ◽  
X Ray

Quantitative X-ray diffraction analysis using clay mineral standards extracted from the samples to be analysed

Clay Minerals ◽  
1967 ◽  
Vol 7 (1) ◽  
pp. 79-90 ◽  
Author(s):  
Ronald J. Gibbs
Keyword(s):  
Diffraction Analysis ◽  
Clay Minerals ◽  
Clay Mineral ◽  
Internal Standard ◽  
Ethanol Solution ◽  
X Ray Diffraction ◽  
X Ray ◽  
Density Separation ◽  
Calibration Curves ◽  
Differential Settling

AbstractIn the quantitative X-ray diffraction analysis of a series of samples, the problems arising from the variable compositions and degrees of crystallinity of clay minerals were overcome to a great extent by the use of standards extracted from the samples. Procedures are given for separation of the montmorillonite standard by differential settling of Na-montmorillonite solvated in an ethanol solution and for isolation of the kaolinite, mica, and chlorite standards by density separation of their Na-forms in thallous formate.Calibration curves were prepared from the X-ray diffractograms obtained for series of known mixtures of Ca-forms of the standards and the internal standard boehmite using both powder and smear-oriented mounting techniques.

Refined ettringite (Ca6Al2(SO4)3(OH)12∙26H2O) structure for quantitative X-ray diffraction analysis

2006 ◽  
Vol 21 (1) ◽  
pp. 4-11 ◽  
Author(s):  
F. Goetz-Neunhoeffer ◽  
J. Neubauer
Keyword(s):  
Diffraction Analysis ◽  
Material Science ◽  
Internal Standard ◽  
Thermal Parameter ◽  
Quantitative Phase Analysis ◽  
American Ceramic Society ◽  
Structure Model ◽  
Special Volume ◽  
X Ray Diffraction ◽  
X Ray

A revised structure model of ettringite is presented, in order to provide quantitative X-ray diffraction (QXRD) of this mineral in cement pastes. The model is derived from two different existing structure models, both of which are suitable for restricted use but are inferior to the refined ettringite structure presented. In the first published ettringite structure proposed by Moore and Taylor [Acta Crystallogr. B 26, 386–393 (1970)], none of the 128 positions for H are given in the unit cell, which results in reduced scattering power for use of this model for quantification purposes. For the precise quantification of ettringite in samples together with anhydrous phases, the scattering factors of all atoms including the H positions are indispensable. The revised structure model is based on the data of Moore and Taylor, supplemented by the H positions determined by Berliner (Material Science of Concrete Special Volume, The Sydney Diamond Symposium, American Ceramic, Society, 1998, pp. 127–141) on the basis of a neutron diffraction structural investigation of deuterated ettringite at 20 K. Berliner’s (Material Science of Concrete Special Volume, The Sydney Diamond Symposium, American Ceramic Society, 1998, pp. 127–141) thermal parameter should not, however, be used, since a normal application is at room temperature. In order further to improve the structure model of ettringite, Rietveld refinement with the rigid body approach for OH and H2O molecules and SO4 tetrahedra was employed. The refined and improved ettringite structure model was tested for quantitative phase analysis by the determination of actual ettringite contents in mixtures with an internal standard. Synthesized and orientation-free prepared ettringite powders were investigated by X-ray powder diffraction analysis and quantified in four different blends with zircon. The quantification results with the new structure model demonstrate the superior quality of the revised ettringite structure.

Rietveld quantitative X-ray diffraction analysis of NIST fly ash standard reference materials

2000 ◽  
Vol 15 (3) ◽  
pp. 163-172 ◽  
Author(s):  
Ryan S. Winburn ◽  
Dean G. Grier ◽  
Gregory J. McCarthy ◽  
Renee B. Peterson
Keyword(s):  
Fly Ash ◽  
Diffraction Analysis ◽  
Reference Materials ◽  
Internal Standard ◽  
Standard Reference Materials ◽  
Ratio Method ◽  
X Ray Diffraction ◽  
Crystalline Phases ◽  
X Ray ◽  
High Calcium

Rietveld quantitative X-ray diffraction analysis of the fly ash Standard Reference Materials (SRMs) issued by the National Institute of Standards and Technologies was performed. A rutile (TiO2) internal standard was used to enable quantitation of the glass content, which ranged from 65% to 78% by weight. TheGSASRietveld code was employed. Precision was obtained by performing six replicates of an analysis, and accuracy was estimated using mixtures of fly ash crystalline phases and an amorphous phase. The three low-calcium (ASTM Class F) fly ashes (SRM 1633b, 2689 and 2690) contained four crystalline phases: quartz, mullite, hematite, and magnetite. SRM 1633b also contained a detectable level of gypsum, which is not common for this type of fly ash. The high-calcium (ASTM Class C) fly ash, SRM 2691, had eleven crystalline phases and presented a challenge for the version ofGSASemployed, which permits refinement of only nine crystalline phases. A method of analyzing different groups of nine phases and averaging the results was developed, and tested satisfactorily with an eleven-phase simulated fly ash. The results were compared to reference intensity ratio method semiquantitative analyses reported for most of these SRMs a decade ago.

Ten-Vertex Polyhedral Monocarbaborane Chemistry. The Novel High-Yield Formation of the Ten-Vertex closo Compound [6-(PMe2Ph)-closo-1-CB9H9] from the Thermolysis of [8,8-(PMe2Ph)2-nido-8,7-PtCB9H11]

1993 ◽  
Vol 58 (12) ◽  
pp. 2924-2935 ◽  
Author(s):  
Jane H. Jones ◽  
Bohumil Štíbr ◽  
John D. Kennedy ◽  
Mark Thornton-Pett
Keyword(s):  
Nmr Spectroscopy ◽  
Diffraction Analysis ◽  
High Yield ◽  
Monoclinic Space Group ◽  
The Novel ◽  
X Ray Diffraction ◽  
Metal Centre ◽  
X Ray ◽  
Yield Formation ◽  
Boiling Toluene

Thermolysis of [8,8-(PMe2Ph)2-nido-8,7-PtCB9H11] in boiling toluene solution results in an elimination of the platinum centre and cluster closure to give the ten-vertex closo species [6-(PMe2Ph)-closo-1-CB9H9] in 85% yield as a colourles air stable solid. The product is characterized by NMR spectroscopy and single-crystal X-ray diffraction analysis. Crystals (from hexane-dichloromethane) are monoclinic, space group P21/c, with a = 903.20(9), b = 1 481.86(11), c = 2 320.0(2) pm, β = 97.860(7)° and Z = 8, and the structure has been refined to R(Rw) = 0.045(0.051) for 3 281 observed reflections with Fo > 2.0σ(Fo). The clean high-yield elimination of a metal centre from a polyhedral metallaborane or metallaheteroborane species is very rare.

Bis(μ-carboxylato)dienerhodium(I) Complexes - Synthesis, Characterization and Catalytic Activity

2008 ◽  
Vol 73 (8-9) ◽  
pp. 1205-1221 ◽  
Author(s):  
Jiří Zedník ◽  
Jan Sedláček ◽  
Jan Svoboda ◽  
Jiří Vohlídal ◽  
Dmitrij Bondarev ◽  
...  
Keyword(s):  
Catalytic Activity ◽  
Diffraction Analysis ◽  
Spectroscopic Methods ◽  
X Ray Diffraction ◽  
X Ray

Dinuclear rhodium(I) η2:η2-cycloocta-1,5-diene (series a) and η2:η2-norborna-2,5-diene (series b) complexes with μ-RCOO- ligands, where R is linear C21H43 (complexes 1a, 1b), CH2CMe3 (2a, 2b), 1-adamantyl (3a, 3b) and benzyl (4a, 4b), have been prepared and characterized by spectroscopic methods. Structures of complexes 2b, 3a and 4a were determined by X-ray diffraction analysis. Complexes prepared show low to moderate catalytic activity in polymerization of phenylacetylene in THF giving high-cis-transoid polymers, but they show only oligomerization activity in dichloromethane.

Sign in / Sign up

Export Citation Format

Share Document