PPT research at AFRL - Material probes to measure the magnetic field distribution in a pulsed plasma thruster

1998 ◽  
Author(s):  
Gregory Spanjers ◽  
Ronald Spores
Keyword(s):  
Magnetic Field ◽  
Field Distribution ◽  
Magnetic Field Distribution ◽  
Pulsed Plasma ◽  
Pulsed Plasma Thruster ◽  
Plasma Thruster ◽  
The Magnetic Field

Investigation of the Magnetic Field in a Pulsed Plasma Thruster

AIAA Journal ◽  
2008 ◽  
Vol 46 (11) ◽  
pp. 2881-2889 ◽  
Author(s):  
Anuscheh Nawaz ◽  
Matthias Lau ◽  
Georg Herdrich ◽  
Monika Auweter-Kurtz
Keyword(s):  
Magnetic Field ◽  
Pulsed Plasma ◽  
Pulsed Plasma Thruster ◽  
Plasma Thruster ◽  
The Magnetic Field

COMPARISON OF CARDIAC MAGNETIC FIELD DISTRIBUTIONS DURING DEPOLARIZATION AND REPOLARIZATION

2003 ◽  
Vol 13 (12) ◽  
pp. 3783-3789 ◽  
Author(s):  
F. E. SMITH ◽  
P. LANGLEY ◽  
L. TRAHMS ◽  
U. STEINHOFF ◽  
J. P. BOURKE ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Field Strength ◽  
Magnetic Field Strength ◽  
Field Distribution ◽  
Normal Subjects ◽  
The Body ◽  
Magnetic Field Distribution ◽  
T Wave ◽  
High Magnetic Field Strength ◽  
The Magnetic Field

Multichannel magnetocardiography measures the magnetic field distribution of the human heart noninvasively from many sites over the body surface. Multichannel magnetocardiogram (MCG) analysis enables regional temporal differences in the distribution of cardiac magnetic field strength during depolarization and repolarization to be identified, allowing estimation of the global and local inhomogeneity of the cardiac activation process. The aim of this study was to compare the spatial distribution of cardiac magnetic field strength during ventricular depolarization and repolarization in both normal subjects and patients with cardiac abnormalities, obtaining amplitude measurements by magnetocardiography. MCGs were recorded at 49 sites over the heart from three normal subjects and two patients with inverted T-wave conditions. The magnetic field intensity during depolarization and repolarization was measured automatically for each channel and displayed spatially as contour maps. A Pearson correlation was used to determine the spatial relationship between the variables. For normal subjects, magnetic field strength maps during depolarization (R-wave) showed two asymmetric regions of magnetic field strength with a high positive value in the lower half of the chest and a high negative value above this. The regions of high R-wave amplitude corresponded spatially to concentrated asymmetric regions of high magnetic field strength during repolarization (T-wave). Pearson-r correlation coefficients of 0.7 (p<0.01), 0.8 (p<0.01) and 0.9 (p<0.01) were obtained from this analysis for the three normal subjects. A negative correlation coefficient of -0.7 (p<0.01) was obtained for one of the subjects with inverted T-wave abnormalities, suggesting similar but inverted magnetic field and current distributions to normal subjects. Even with the high correlation values in these four subjects, the MCG was able to identify differences in the distribution of magnetic field strength, with a shift in the T-wave relative to the R-wave. The measurement of cardiac magnetic field distribution during depolarization and repolarization of normal subjects and patients with clinical abnormalities should enable the improvement of theoretical models for the explanation of the cardiac depolarization and repolarization processes.

scholarly journals Measurement of the Magnetic Field Distribution in Railguns Using CMR-B-Scalar Sensors

2009 ◽  
Vol 115 (6) ◽  
pp. 1125-1127 ◽  
Author(s):  
O. Liebfried ◽  
M. Schneider ◽  
M.J. Loeffler ◽  
S. Balevičius ◽  
N. Žurauskienė ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Field Distribution ◽  
Magnetic Field Distribution ◽  
The Magnetic Field

scholarly journals Numerical simulation of induction heating thick-walled tubes

2018 ◽  
Vol 168 ◽  
pp. 02004
Author(s):  
Richard Lenhard ◽  
Milan Malcho ◽  
Katarína Kaduchová
Keyword(s):  
Magnetic Field ◽  
Numerical Simulation ◽  
Field Distribution ◽  
Induction Heating ◽  
Electromagnetic Induction ◽  
Magnetic Field Distribution ◽  
The Magnetic Field ◽  
Heated Material ◽  
Ansys Workbench

In the paper is shown the connection of two toolboxes in an Ansys Workbench solution for induction heating. In Ansys Workbench, Maxwell electromagnetism programs and Fluent have been linked. In Maxwell, a simulation of electromagnetic induction was performed, where data on the magnetic field distribution in the heated material was obtained and then transformed into the Fluent program in which the induction heating simulation was performed.

Uticaj armirano betonskog stuba na raspodelu magnetskog polja mešovitog voda

2020 ◽  
Vol 22 (1-2) ◽  
pp. 58-64
Author(s):  
Teodora Gavrilov ◽  
◽  
Karolina Kasaš-Lažetić ◽  
Kristian Haška ◽  
Miroslav Prša
Keyword(s):  
Magnetic Field ◽  
Field Distribution ◽  
Magnetic Field Distribution ◽  
Magnetic Flux Density ◽  
Reinforcing Bars ◽  
Magnitude Distribution ◽  
Calculation Results ◽  
Mixed Power ◽  
The Impact ◽  
The Magnetic Field

In this paper, the analysis of magnetic field distribution of overhead mixed power line (20 kV/0.4 kV) supported by reinforced concrete towers, named MNL-12 is presented. The impact of ferromagnetic, conductive parts of the pylons (reinforcing bars, billets and cross arm beams) on magnetic field distribution is investigated. The numerical calculations were performed in COMSOL Multiphysics program package on simplified 2D model. The main goal of the calculations was to examine the impact of currents induced in ferromagnetic conductive parts on magnetic field produced by currents in the power system’s conductors. The calculation results are presented graphically, as the diagrams of the magnetic flux density magnitude distribution in the tower plan, normal to the system’s axe. The calculation results demonstrated that the magnetic field of induced currents decreases the magnetic field produced by the currents of overhead power system.

Investigation on the Improvement of Surface Quality by the Magnetic Plate-Assisted Magnetic Abrasive Finishing Process

2021 ◽  
Vol 1018 ◽  
pp. 111-116
Author(s):  
Yan Hua Zou ◽  
Hui Jun Xie
Keyword(s):  
Magnetic Field ◽  
Surface Quality ◽  
Field Distribution ◽  
Magnetic Field Distribution ◽  
Magnetic Flux Density ◽  
Magnetic Pole ◽  
Magnetic Abrasive Finishing ◽  
Abrasive Finishing ◽  
Glass Lens ◽  
The Magnetic Field

The traditional magnetic abrasive finishing (MAF) process, the magnetic flux density at the bottom of the magnetic pole is unevenly distributed, resulting in poor uniformity of the finished surface. Therefore, it is proposed to improve the surface quality by attaching a magnetic plate at the bottom of the workpiece to improve the magnetic field distribution. It is confirmed by simulation that the magnetic field distribution at the bottom of the magnetic pole is effectively improved after the magnetic plate is attached. It is proved through experiments that the magnetic plate-assisted MAF process can obtain a smoother surface. The experimental results show that the surface roughness of the glass lens improves from 246 nm Ra to 3 nm Ra through the magnetic plate-assisted MAF process within 45min.

Visualization of the Magnetic Field Distribution for a Direct Current by Using the Magneto-optical Effect

2016 ◽  
Vol 66 (2) ◽  
pp. 231-234
Author(s):  
Sunghoon JEON ◽  
Shant ARAKELYAN ◽  
Yeonsub LEE ◽  
Yongjae KIM ◽  
Hyeji HAN ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Field Distribution ◽  
Direct Current ◽  
Magnetic Field Distribution ◽  
Optical Effect ◽  
Magneto Optical Effect ◽  
The Magnetic Field
Sign in / Sign up

Export Citation Format

Share Document