An Experimental and Computational Correlation Study for Fluid-Thermal-Structural Interaction of a Control Surface in Hypersonic Flow

2022 ◽  
Author(s):  
Aravinth Sadagopan ◽  
Daning Huang ◽  
Adam Jirasek ◽  
Jürgen Seidel ◽  
Anshuman Pandey ◽  
...  
2018 ◽  
Vol 32 (12n13) ◽  
pp. 1840045
Author(s):  
Tian-Peng Yang ◽  
Jiang-Feng Wang ◽  
Fa-Ming Zhao ◽  
Xiao-Feng Fan ◽  
Yu-Han Wang

The interaction effect between jet and control surface in supersonic and hypersonic flow is one of the key problems for advanced flight control system. The flow properties of exhaust jet secondary combustion in a hypersonic compression ramp flow field were studied numerically by solving the Navier–Stokes equations with multi-species and combustion reaction effects. The analysis was focused on the flow field structure and the force amplification factor under different jet conditions. Numerical results show that a series of different secondary combustion makes the flow field structure change regularly, and the temperature increases rapidly near the jet exit.


2018 ◽  
Vol 122 (1257) ◽  
pp. 1673-1696 ◽  
Author(s):  
M. Khalid ◽  
K. A. Juhany

ABSTRACTA numerical simulation has been carried out to investigate the effects of leading edge blowing upon heat alleviation on the surface of hypersonic vehicles. The initial phase of this work deals with the ability of the present CFD-based techniques to solve hypersonic flow field past blunt-nosed vehicles at hypersonic speeds. Towards this end, the authors selected three re-entry vehicles with published flow field data against which the present computed results could be measured. With increasing confidence on the numerical simulation techniques to accurately resolve the hypersonic flow, the boundary condition at the solid blunt surface was then equipped with the ability to blow the flow out of the solid boundary at a rate of at least 0.01–0.1 times the free stream (ρ∞u∞) mass flow rate. The numerical iterative procedure was then progressed until the flow at the surface matched this new ‘inviscid like’ boundary condition. The actual matching of the flow field at the ejection control surface was achieved by iterating the flow on the adjacent cells until the flow conformed to the conditions prescribed at the control surface. The conditions at the surface could be submitted as a ρ∞u∞at the surface or could be equipped as a simple static pressure condition providing the desired flow rate. The comparison between the present engineering approach and the experimental data presented in this study demonstrate its ability to solve complex problems in hypersonic.


Author(s):  
L. S. Lin ◽  
K. P. Gumz ◽  
A. V. Karg ◽  
C. C. Law

Carbon and temperature effects on carbide formation in the carburized zone of M50NiL are of great importance because they can be used to control surface properties of bearings. A series of homogeneous alloys (with M50NiL as base composition) containing various levels of carbon in the range of 0.15% to 1.5% (in wt.%) and heat treated at temperatures between 650°C to 1100°C were selected for characterizations. Eleven samples were chosen for carbide characterization and chemical analysis and their identifications are listed in Table 1.Five different carbides consisting of M6C, M2C, M7C3 and M23C6 were found in all eleven samples examined as shown in Table 1. M6C carbides (with least carbon) were found to be the major carbide in low carbon alloys (<0.3% C) and their amounts decreased as the carbon content increased. In sample C (0.3% C), most particles (95%) encountered were M6C carbide with a particle sizes range between 0.05 to 0.25 um. The M6C carbide are enriched in both Mo and Fe and have a fee structure with lattice parameter a=1.105 nm (Figure 1).


1979 ◽  
Vol 40 (11) ◽  
pp. 1085-1088 ◽  
Author(s):  
B. Herpigny ◽  
J.-P. Boon

2020 ◽  
Vol 5 (1) ◽  
pp. 33-37
Author(s):  
Zahra Sina ◽  
Nadia Abdullahi

Personal hygiene products are used on a daily basis by many people. Many are comparable to the Trojan horse. On the outside, they appear to be harmless. They are contained in attractive bottles and they rely on misleading ads to attract consumers. However, these products may contain potentially harmful chemicals and many people are unaware of how individuals, societies and environments are affected in the various stages of the life cycle of many personal hygiene products. Our STSE issue deals with an everyday product that falls under the Trojan horse analogy–lotion. We are concerned that our peers and other young adults are purchasing lotions without the knowledge of how they came to stand on the shelves of a store. We conducted a correlation study between gender and popular lotion brands among teenagers and the reasons behind their choices. We came to the conclusion that more females than males were interested in popular lotion brands due to enticing features that targets mainly feminine interests (e.g. scent is an aspect of lotion that more females than males consider when purchasing the brand). For our actions, we prepared an educational mind-map on our issue and a video compilation where we interviewed female students on their reactions to various lotion brand commercials. Our actions are meant to inform the public about the controversies surrounding our issue and the techniques companies use to gain the attention of potential consumers.


Sign in / Sign up

Export Citation Format

Share Document