scholarly journals Reconstruction of the ZnAl Mixed Oxides Into the Layered Double Hydroxide Catalysts Active in the Aldol Condensation of Furfural: The Role of ZnO Particles

2022 ◽  
Vol 9 ◽  
Author(s):  
Lada Dubnová ◽  
Rostislav Daňhel ◽  
Vendula Meinhardová ◽  
Valeriia Korolova ◽  
Lucie Smoláková ◽  
...  

A memory effect is the ability to restore the original, lamellar layered double hydroxide structure. Herein, we have described 1) the changes in the structural and basic properties of ZnAl mixed oxides during their transformation into ZnAl-reconstructed LDHs (RE-LDHs); 2) the extraordinary properties of ZnAl RE-LDHs compared to the original ZnAl LDHs; and 3) the changes of basic properties during the interaction of ZnAl RE-LDHs with atmospheric CO2. Aldol condensation was selected as probe reaction to prove the catalytic potential of ZnAl RE-LDHs. We have described a target method for preparing ZnAl RE-LDHs with a large number of basic sites. ZnAl RE-LDHs possess significantly higher furfural conversion in the aldol condensation of furfural than MOs. The structural, textural, and basic properties of the studied materials were described by temperature-programmed analysis, X-ray diffraction, N2 adsorption, temperature-programmed desorption of CO2, and in-situ diffuse reflectance spectroscopy.

Catalysts ◽  
2020 ◽  
Vol 10 (8) ◽  
pp. 870
Author(s):  
Hadi Dib ◽  
Rebecca El Khawaja ◽  
Guillaume Rochard ◽  
Christophe Poupin ◽  
Stéphane Siffert ◽  
...  

CuAlCe oxides were obtained from hydrotalcite-type precursors by coprecipitation using a M2+/M3+ ratio of 3. The collapse of the layered double hydroxide structure following the thermal treatment leads to the formation of mixed oxides (CuO and CeO2). The catalytic performance of the copper-based catalysts was evaluated in the total oxidation of two Volatile Organic Compounds (VOCs): ethanol and toluene. XRD, SEM Energy-Dispersive X-ray Spectrometry (EDX), H2-temperature programmed reduction (TPR) and XPS were used to characterize the physicochemical properties of the catalysts. A beneficial effect of combining cerium with CuAl-O oxides in terms of redox properties and the abatement of the mentioned VOCs was demonstrated. The sample with the highest content of Ce showed the best catalytic properties, which were mainly related to the improvement of the reducibility of the copper species and their good dispersion on the surface. The presence of a synergetic effect between the copper and cerium elements was also highlighted.


2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Abdullah Ahmed Ali Ahmed ◽  
Zainal Abidin Talib ◽  
Mohd Zobir Hussein ◽  
Moayad Husein Flaifel ◽  
Naif Mohammed Al-Hada

The coprecipitation method has been used to synthesize layered double hydroxide (Zn-Fe-LDH) nanostructure at different Zn2+/Fe3+molar ratios. The structural properties of samples were studied using powder X-ray diffraction (PXRD). LDH samples were calcined at 600°C to produce mixed oxides (ZnO and ZnFe2O4). The crystallite size of mixed oxide was found in the nanometer scale (18.1 nm for ZnFe2O4and 43.3 nm for ZnO). The photocatalytic activity of the calcination products was investigated using ultraviolet-visible-near infrared (UV-VIS-NIR) diffuse reflectance spectroscopy. The magnetic properties of calcined LDHs were investigated using a vibrating sample magnetometer (VSM). The calcined samples showed a paramagnetic behavior for all Zn2+/Fe3+molar ratios. The effect of molar ratio on magnetic susceptibility of the calcined samples was also studied.


2013 ◽  
Vol 342 ◽  
pp. 38-46 ◽  
Author(s):  
Angélica C. Heredia ◽  
Marcos I. Oliva ◽  
Ulises Agú ◽  
Carlos I. Zandalazini ◽  
Sergio G. Marchetti ◽  
...  

2012 ◽  
Vol 2012 ◽  
pp. 1-6 ◽  
Author(s):  
Xianlu Cui ◽  
Yaogang Li ◽  
Qinghong Zhang ◽  
Hongzhi Wang

Flaky layered double hydroxide (FLDH) was prepared by the reconstruction of its oxide in alkali solution. The composites with FLDH/Ag3PO4mass ratios at 1.6 : 1 and 3 : 1 were fabricated by the coprecipitation method. The powders were characterized by X-ray diffraction, field-emission scanning electron microscopy, transmission electron microscope, and UV-vis diffuse reflectance spectroscopy. The results indicated that the well-distributed Ag3PO4in a fine crystallite size was formed on the surface of FLDH. The photocatalytic activities of the Ag3PO4immobilized on FLDH were significantly enhanced for the degradation of acid red G under visible light irradiation compared to bare Ag3PO4. The composite with the FLDH/Ag3PO4mass ratio of 3 : 1 showed a higher photocatalytic efficiency.


2013 ◽  
Vol 591 ◽  
pp. 138-141
Author(s):  
Zhi Dong Han ◽  
Xin Ke Zhang ◽  
Yue Wang ◽  
Zheng Quan Jiang ◽  
Peng Wang

Mg-Al layered double hydroxide (LDH) was modified with sodium dodecyl sulfate (SDS) by regeneration method. The structure of modified LDH (SDS-LDH) was investigated by X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR). The composites of SDS-LDH and polyethylene (PE) were prepared by melt blending and solution mixing method with maleated PE (PEgMA) as compatibilizer. The structure of the composites and the dispersion of SDS-LDH in the matrix were investigated by XRD and transmission electron microscopy (TEM), respectively. The results reveal that SDS was successfully intercalated into the interlayer space of LDH. SDS-LDH was hardly exfoliated in PE/PEgMA by melt blending. The nanocomposites of PE/(PEgMA/SDS-LDH) were successfully prepared by melt blending PE with SDS-LDH/PEgMA master-batch obtained by solution mixing. Homogeneous dispersion of SDS-LDH in the matrix was observed by TEM.


Materials ◽  
2019 ◽  
Vol 12 (11) ◽  
pp. 1771 ◽  
Author(s):  
Stefan Neatu ◽  
Mihaela M. Trandafir ◽  
Adelina Stănoiu ◽  
Ovidiu G. Florea ◽  
Cristian E. Simion ◽  
...  

This study presents the synthesis and characterization of lanthanum-modified alumina supported cerium–manganese mixed oxides, which were prepared by three different methods (coprecipitation, impregnation and citrate-based sol-gel method) followed by calcination at 500 °C. The physicochemical properties of the synthesized materials were investigated by various characterization techniques, namely: nitrogen adsorption-desorption isotherms, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM) and H2–temperature programmed reduction (TPR). This experimental study demonstrated that the role of the catalytic surface is much more important than the bulk one. Indeed, the incipient impregnation of CeO2–MnOx catalyst, supported on an optimized amount of 4 wt.% La2O3–Al2O3, provided the best results of the catalytic combustion of methane on our catalytic micro-convertors. This is mainly due to: (i) the highest pore size dimensions according to the Brunauer-Emmett-Teller (BET) investigations, (ii) the highest amount of Mn4+ or/and Ce4+ on the surface as revealed by XPS, (iii) the presence of a mixed phase (Ce2MnO6) as shown by X-ray diffraction; and (iv) a higher reducibility of Mn4+ or/and Ce4+ species as displayed by H2–TPR and therefore more reactive oxygen species.


2012 ◽  
Vol 407 (16) ◽  
pp. 3125-3127
Author(s):  
M.I. Oliva ◽  
A. Heredia ◽  
C.I. Zandalazini ◽  
M. Crivello ◽  
E. Corchero

2012 ◽  
Vol 557-559 ◽  
pp. 371-374
Author(s):  
Lian Liu ◽  
Teng Yu ◽  
Pei Wang ◽  
Guang Shuo Wang

Nanocomposites of poly(ε-caprolactone) (PCL) and layered double hydroxide (LDH) were prepared by in situ polymerization at low LDHs loadings in this work. The resultants were characterized by FTIR spectroscopy, X-ray diffraction (XRD), differential scanning calorimeter (DSC) and UV-visible spectroscopy (UV-vis). FTIR showed that the PCL/LDHs nanocomposites were prepared successfully by in situ polymerization and XRD spectra showed that the crystal structure did not change greatly in the presence of LDHS. DSC results confirmed that LDHs could act as nucleating agents. UV-vis spectra showed that LDHs had stronger absorbance peak than LDH. Moreover, the PCL/LDHs nanocomposites had strong anti-ultraviolet effect by introduction of LDHs into polymer matrix.


2012 ◽  
Vol 567 ◽  
pp. 127-130
Author(s):  
Jian Ye Song ◽  
Ming Zhe Leng ◽  
Xing Qi Fu ◽  
Jian Qiang Liu

Single-phase ZnAl2O4 spinel has been prepared by a novel simple route using layered double hydroxide as a precursor. ZnAl2O4 spinel is directly obtained by calcination of zinc aluminum layered double hydroxide (Zn/Al molar radio is 0.5) without further chemical treatment. The key feature of this method is that it affords uniform distribution of all metal cations on an atomic level in the precursor. The structural characteristics of the as-synthesized precursor and the resulted calcined products are obtained by X-ray diffraction and scanning electron microscope.


Sign in / Sign up

Export Citation Format

Share Document