scholarly journals Sensing Glucose Concentration Using Symmetric Metasurfaces under Oblique Incident Terahertz Waves

Crystals ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 1578
Author(s):  
Ibraheem Al-Naib

In this article, a planar metamaterial sensor designed at terahertz (THz) frequencies is utilized to sense glucose concentration levels that cover hypoglycemia, normal, and hyperglycemia conditions that vary from 54 to 342 mg/dL. The sensor was developed using a symmetric complementary split rectangular resonator at an oblique incidence angle. The resonance frequency shift was used as a measure of the changes in the glucose level of the samples. The increase in the glucose concentration level exhibited clear and noticeable redshifts in the resonance frequency. For instance, a 67.5 GHz redshift has been observed for a concentration level of 54 mg/dL and increased up to 122 GHz for the 342 mg/dL concentration level. Moreover, a high sensitivity level of 75,700 nm/RIU was observed for this design. In the future, the proposed THz sensors may have potential applications in diagnosing hypocalcemia and hyperglycemia cases.

2020 ◽  
Vol 11 (1) ◽  
pp. 103
Author(s):  
Yadgar I. Abdulkarim ◽  
Fahmi F. Muhammadsharif ◽  
Mehmet Bakır ◽  
Halgurd N. Awl ◽  
Muharrem Karaaslan ◽  
...  

In this work, a new design for a real-time noninvasive metamaterial sensor, based on a corona-shaped resonator, is proposed. The sensor was designed numerically and fabricated experimentally in order to be utilized for efficient detection of glucose in aqueous solutions such as water and blood. The sensor was inspired by a corona in-plane-shaped design with the presumption that its circular structure might produce a broader interaction of the electromagnetic waves with the glucose samples. A clear shift in the resonance frequency was observed for various glucose samples, which implies that the proposed sensor has a good sensitivity and can be easily utilized to distinguish any glucose concentration, even though their dielectric coefficients are close. Results showed a superior performance in terms of resonance frequency shift (1.51 GHz) and quality factor (246) compared to those reported in the literature. The transmission variation level ∆|S21| was investigated for glucose concentration in both water and blood. The sensing mechanism was elaborated through the surface current, electric field and magnetic field distributions on the corona resonator. The proposed metamaterials sensor is considered to be a promising candidate for biosensor and medicine applications in human glycaemia monitoring.


Nanophotonics ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Shulei Li ◽  
Lidan Zhou ◽  
Mingcheng Panmai ◽  
Jin Xiang ◽  
Sheng Lan

Abstract We investigate numerically and experimentally the optical properties of the transverse electric (TE) waves supported by a dielectric-metal heterostructure. They are considered as the counterparts of the surface plasmon polaritons (i.e., the transverse magnetic (TM) waves) which have been extensively studied in the last several decades. We show that TE waves with resonant wavelengths in the visible light spectrum can be excited in a dielectric-metal heterostructure when the optical thickness of the dielectric layer exceeds a critical value. We reveal that the electric and magnetic field distributions for the TE waves are spatially separated, leading to higher quality factors or narrow linewidths as compared with the TM waves. We calculate the thickness, refractive index and incidence angle dispersion relations for the TE waves supported by a dielectric-metal heterostructure. In experiments, we observe optical resonances with linewidths as narrow as ∼10 nm in the reflection or scattering spectra of the TE waves excited in a Si3N4/Ag heterostructure. Finally, we demonstrate the applications of the lowest-order TE wave excited in a Si3N4/Ag heterostructure in optical display with good chromaticity and optical sensing with high sensitivity.


Micromachines ◽  
2021 ◽  
Vol 12 (6) ◽  
pp. 641
Author(s):  
Yuan Zhai ◽  
Yi Xiang ◽  
Weiqing Yuan ◽  
Gang Chen ◽  
Jinliang Shi ◽  
...  

High sensitivity detection of terahertz waves can be achieved with a graphene nanomesh as grating to improve the coupling efficiency of the incident terahertz waves and using a graphene nanostructure energy gap to enhance the excitation of plasmon. Herein, the fabrication process of the FET THz detector based on the rectangular GNM (r-GNM) is designed, and the THz detector is developed, including the CVD growth and the wet-process transfer of high quality monolayer graphene films, preparation of r-GNM by electron-beam lithography and oxygen plasma etching, and the fabrication of the gate electrodes on the Si3N4 dielectric layer. The problem that the conductive metal is easy to peel off during the fabrication process of the GNM THz device is mainly discussed. The photoelectric performance of the detector was tested at room temperature. The experimental results show that the sensitivity of the detector is 2.5 A/W (@ 3 THz) at room temperature.


Author(s):  
Reza Harirforoush ◽  
Siamak Arzanpour

This paper investigates primary stability of dental implant that indicates the process of bone-implant integration. This integration is known to happen at the boundary of the bone and dental implant contact surface. The resonance frequency of dental implant is used as the parameter for this investigation due to its high sensitivity to boundary condition variations. In this study, resonance frequency analysis (RFA) of the jaw-implant structure is carried out using finite element modeling. The FEM analyses are conducted in ANSYS modal analysis simulation environment. The FEM model of the structure includes titanium implant, Cancellous and cortical bone. Different implant-bone interface conditions are studied for this investigation. Various boundary conditions were studied to identify natural frequencies of jaw-implant structure. Our analysis shows that the resonance frequency of the implant increases during the healing period and reaches a plateau when the implant-bone interface was fully integrated. The results show that RFA could be suggested as a non-invasive, reliable and accurate diagnostic method for early assessment of the healing stages.


Materials ◽  
2019 ◽  
Vol 12 (14) ◽  
pp. 2328
Author(s):  
Luran Zhang ◽  
Dandan Gao ◽  
Huan Liu ◽  
Jiyang Xie ◽  
Wanbiao Hu

A series of FeCoN films were successfully deposited on glass substrates in a magnetron sputtering system. Using oblique incidence method and FeCoN/Ru/FeCoN synthetic antiferromagnetic (SAF) structure, two additional anisotropies energy were introduced: oblique incidence anisotropy and exchange anisotropy energy, which marked enhancement of the effective magnetic anisotropy (Hk). The increment of Hk results in a significant improvement in the roll-off frequency of these films. The roll-off frequency of FeCoN/Ru/FeCoN films with SAF structure can reach up to 8.6 GHz. A feasible approach to conveniently controlling Hk of soft magnetic thin films by using oblique deposition and SAF structure can further improve their properties for the potential applications in the high frequency region.


2013 ◽  
Vol 737 ◽  
pp. 176-182 ◽  
Author(s):  
Ratno Nuryadi ◽  
Arko Djajadi ◽  
Reyhan Adiel ◽  
Lia Aprilia ◽  
Nuning Aisah

Microcantilever-based sensors have attracted interest in the last decade because of their small size, rapid detection and high sensitivity. This sensor can be applied in the many fields, i.e. physics, chemistry, biology, biochemistry, medical, and environment. In this paper, we describe microcantilever-based sensor for environmental monitoring, especially for a humidity detection. This sensor was operated in dynamic mode where a change in mass or spring constant of the microcantilever provides the resonance frequency change. Here, a change of humidity is detected by the resonance frequency and the amplitude changes. It is found that the increase in the humidity causes the decreasing the resonance frequency but increasing the amplitude. This result opens up the possibility of the humidity detection using microcantilever-based sensor.


2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Li Jin ◽  
Shi-Yang Qin ◽  
Rui Zhang ◽  
Meng-Wei Li

Abstract Micro-electro-mechanical system (MEMS) gyroscopes have numerous potential applications including guidance, robotics, tactical-grade navigation, and automotive applications fields. The methods with ability of the weak Coriolis force detection are critical for MEMS gyroscopes. In this paper, we presented a design of MEMS gyroscope based on the tunneling magneto-resistance effect with higher detection sensitivity. Of all these designed parameters, the structural, magnetic field, and magneto-resistance sensitivity values reach to 21.6 nm/°/s, 0.0023 Oe/nm, and 29.5 mV/Oe, thus, with total sensitivity of 1.47 mV/°/s. Multi-bridge circuit method is employed to suppress external magnetic interference and avoid the integration error of the TMR devices effectively. The proposed tunneling magneto-resistive micro-gyroscope shows a possibility to make an inertial grade MEMS gyroscope in the future.


2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Javad Shabanpour ◽  
Sina Beyraghi ◽  
Homayoon Oraizi

Abstract Ultrawide-angle electromagnetic wave absorbers with excellent mechanical properties are required in many diverse applications such as sensing, and stealth technologies. Here, a novel 3D reconfigurable metamaterial absorber (MMA) consisting of honeycomb and VO2 films is proposed. The proposed MMA exhibits a strong absorptivity above 90% in the widest incident angle up to $$87^\circ $$ 87 ∘ for TM- and TE polarized oblique incidences for THz wave propagating in yoz-plane. Under normal incidence, when VO2 films are in the insulating state, the proposed absorber exhibits high absorptivity in the frequency band of 1–4 THz. By increasing the temperature of the whole structure, the structural transformation of VO2 occurs and turns into the metallic phase. We have shown that under oblique incidence, the ohmic losses of VO2 films especially those parallel to the direction of the incident electric field are the most important absorption principles of the proposed MMA. Due to the ultra wide-angle absorption (angular stability) and mechanical performance, it is expected that the presented MMA may find potential applications, such as camouflage technologies, electromagnetic interference, imaging, and sensing. To the best knowledge of authors, the proposed MMA configuration exhibits the absorptivity in the widest incident angle ever reported.


2010 ◽  
Vol 10 ◽  
pp. 535-545
Author(s):  
Ehsanul Kabir ◽  
Ki-Hyun Kim

In this study, the removal capacity of deionized water was investigated against five gaseous carbonyl compounds (i.e., acetaldehyde, propionaldehyde, butyraldehyde, valeraldehyde, and isovaleraldehyde) by means of the gas stripping method. To determine the trapping behavior of these odorants by water, gaseous working standards prepared at three different concentration levels (i.e., for acetaldehyde around 300, 500, and 1,000 ppb) were forced through pure water contained in an impinger at room temperature. The removal efficiency of the target compounds was inspected in terms of two major variables: (1) concentration levels of gaseous standard and (2) impinger water volume (20, 50, 100, and 150 mL). Although the extent of removal was affected fairly sensitively by changes in water volume, this was not the case for standard concentration level changes. Considering the efficiency of sorption media, gas stripping with aqueous solution can be employed as an effective tool for the removal of carbonyl odorants.


2020 ◽  
Vol 13 (03) ◽  
pp. 2030005
Author(s):  
Zhao Lei ◽  
Yun Zeng ◽  
Xiaofen Zhang ◽  
Xiaoyong Wang ◽  
Gang Liu

Noninvasive molecular imaging makes the observation and comprehensive understanding of complex biological processes possible. Photoacoustic imaging (PAI) is a fast evolving hybrid imaging technology enabling in vivo imaging with high sensitivity and spatial resolution in deep tissue. Among the various probes developed for PAI, genetically encoded reporters attracted increasing attention of researchers, which provide improved performance by acquiring images of a PAI reporter gene’s expression driven by disease-specific enhancers/promoters. Here, we present a brief overview of recent studies about the existing photoacoustic reporter genes (RGs) for noninvasive molecular imaging, such as the pigment enzyme reporters, fluorescent proteins and chromoproteins, photoswitchable proteins, including their properties and potential applications in theranostics. Furthermore, the challenges that PAI RGs face when applied to the clinical studies are also examined.


Sign in / Sign up

Export Citation Format

Share Document