scholarly journals Shared-Aperture 24–28 GHz Waveguide Antenna Array

Electronics ◽  
2021 ◽  
Vol 10 (23) ◽  
pp. 2976
Author(s):  
Pavel Hazdra ◽  
Jan Kracek ◽  
Tomas Lonsky ◽  
Vaclav Kabourek ◽  
Zdenek Hradecky

A compact three-element shared-aperture waveguide antenna array for the 24–28 GHz microwave-frequency band is presented as a proof-of-concept of an array with steerable directional beam suitable for 5G telecommunication systems. The array is intended for use in a microwave photonic link and is sufficiently steerable only with the progressively phased excitation signals of equal magnitudes. The mutual interactions between the array elements are minimized to maintain the properties of the individual elements, even if they are embedded and closely spaced in the array. The proposed concept could be simply extended by adding more elements to further increase the directivity and enhance the steering properties of the array.

Coatings ◽  
2021 ◽  
Vol 11 (10) ◽  
pp. 1243
Author(s):  
Yuxia Zhu ◽  
Hongwei Yang

In this paper, defective microwave photonic crystals (MPCs) are designed to sense the salinity of aqueous solutions. The defective MPC sensors are constructed by two kinds of microwave dielectric layers and one defective salt solution layer. Transfer matrix method (TMM) for lossy medium is developed to calculate the transmittance spectra of the sensors. It is found that the peak transmittance of both the defective resonance within the microwave band gap (MBG) and transmitting modes outside the MBG monotonously decrease with the increase of salinity, while the resonant and transmitting mode frequencies remain unchanged. By comparing the four MPC sensor structures, the first transmitting mode in the upper frequency band outside the MBG of the 15-layer MPC sensor has the largest salinity sensing range from 0 to 40‰ with relative stable detecting sensitivity. The sensing principle is based on the fact that the dielectric loss factor of saline solution is much more sensitive to salinity than the dielectric constant in the microwave frequency band. The sensitivity, quality factor, and salinity detection range of the MPC sensors are calculated and compared. The reported defective MPC sensors are suitable to be used for non-contact salinity detection.


2021 ◽  
Vol 11 (11) ◽  
pp. 4824
Author(s):  
Bilal Hammu-Mohamed ◽  
Ángel Palomares-Caballero ◽  
Cleofás Segura-Gómez ◽  
Francisco G. Ruiz ◽  
Pablo Padilla

This paper presents a cavity-backed antenna array in substrate integrated waveguide (SIW) technology in the millimeter-wave frequency band. The proposed antenna design uses double slots as radiating elements instead of conventional single slots. The double slots allow better control in the design of the operating frequency bands of the cavity-backed antenna. The performance of the cavity-backed antennas with single and double slots is compared to assess the enhanced behavior of the double slots. As a proof of concept, a 2 × 2 array of cavity-backed antennas is designed, manufactured, and measured. Each cavity-backed antenna contains 2 × 2 double slots; thus, a 4 × 4 antenna array is considered. The experimental operating frequency band of the proposed antenna array ranges from 35.4 to 37 GHz. There is a good agreement between the simulated and measured results. The measured gain is around 17 dBi in the whole operating frequency band with a 75% total antenna efficiency.


2020 ◽  
Vol 20 (4) ◽  
pp. 801-807
Author(s):  
Lars Arendt-Nielsen ◽  
Jesper Bie Larsen ◽  
Stine Rasmussen ◽  
Malene Krogh ◽  
Laura Borg ◽  
...  

AbstractBackground and aimsIn recent years, focus on assessing descending pain modulation or conditioning pain modulation (CPM) has emerged in patients with chronic pain. This requires reliable and simple to use bed-side tools to be applied in the clinic. The aim of the present pilot study was to develop and provide proof-of-concept of a simple clinically applicable bed-side tool for assessing CPM.MethodsA group of 26 healthy volunteers participated in the experiment. Pressure pain thresholds (PPT) were assessed as test stimuli from the lower leg before, during and 5 min after delivering the conditioning tonic painful pressure stimulation. The tonic stimulus was delivered for 2 min by a custom-made spring-loaded finger pressure device applying a fixed pressure (2.2 kg) to the index finger nail. The pain intensity provoked by the tonic stimulus was continuously recorded on a 0–10 cm Visual Analog Scale (VAS).ResultsThe median tonic pain stimulus intensity was 6.7 cm (interquartile range: 4.6–8.4 cm) on the 10 cm VAS. The mean PPT increased significantly (P = 0.034) by 55 ± 126 kPa from 518 ± 173 kPa before to 573 ± 228 kPa during conditioning stimulation. When analyzing the individual CPM responses (increases in PPT), a distribution of positive and negative CPM responders was observed with 69% of the individuals classified as positive CPM responders (increased PPTs = anti-nociceptive) and the rest as negative CPM responders (no or decreased PPTs = Pro-nociceptive). This particular responder distribution explains the large variation in the averaged CPM responses observed in many CPM studies. The strongest positive CPM response was an increase of 418 kPa and the strongest negative CPM response was a decrease of 140 kPa.ConclusionsThe present newly developed conditioning pain stimulator provides a simple, applicable tool for routine CPM assessment in clinical practice. Further, reporting averaged CPM effects should be replaced by categorizing volunteers/patients into anti-nociceptive and pro-nociceptive CPM groups.ImplicationsThe finger pressure device provided moderate-to-high pain intensities and was useful for inducing conditioning stimuli. Therefore, the finger pressure device could be a useful bed-side method for measuring CPM in clinical settings with limited time available. Future bed-side studies involving patient populations are warranted to determine the usefulness of the method.


Sensors ◽  
2021 ◽  
Vol 21 (11) ◽  
pp. 3656
Author(s):  
Antonio Lazaro ◽  
Marc Lazaro ◽  
Ramon Villarino ◽  
David Girbau ◽  
Pedro de Paco

This work proposes the use of a modulated tag for direct communication between two vehicles using as a carrier the wave emitted by an FMCW radar installed in the vehicle for advanced driver assistance. The system allows for real-time signals detection and classification, such as stop signal, turn signals and emergency lights, adding redundancy to computer video sensors and without incorporating additional communication systems. A proof-of-concept tag has been designed at the microwave frequency of 24 GHz, consisting of an amplifier connected between receiving and transmitting antennas. The modulation is performed by switching the power supply of the amplifier. The tag is installed on the rear of the car and it answers when it is illuminated by the radar by modulating the backscattered field. The information is encoded in the modulation switching rate used. Simulated and experimental results are given showing the feasibility of the proposed solution.


1990 ◽  
Vol 64 (3) ◽  
pp. 888-902 ◽  
Author(s):  
R. Rajan ◽  
L. M. Aitkin ◽  
D. R. Irvine

1. The organization of azimuthal sensitivity of units across the dorsoventral extent of primary auditory cortex (AI) was studied in electrode penetrations made along frequency-band strips of AI. Azimuthal sensitivity for each unit was represented by a mean azimuth function (MF) calculated from all azimuth functions obtained to characteristic frequency (CF) stimuli at intensities 20 dB or more greater than threshold. MFs were classified as contrafield, ipsi-field, central-field, omnidirectional, or multipeaked, according to the criteria established in the companion paper (Rajan et al. 1990). 2. The spatial distribution of three types of MFs was not random across frequency-band strips: for contra-field, ipsi-field, and central-field MFs there was a significant tendency for clustering of functions of the same type in sequentially encountered units. Occasionally, repeated clusters of a particular MF type could be found along a frequency-band strip. In contrast, the spatial distribution of omnidirectional MFs along frequency-band strips appeared to be random. 3. Apart from the clustering of MF types, there were also regions along a frequency-band strip in which there were rapid changes in the type of MF encountered in units isolated over short distances. Most often such changes took the form of irregular, rapid juxtapositions of MF types. Less frequently such changes appeared to show more systematic changes from one type of MF to another type. In contrast to these changes in azimuthal sensitivity seen in electrode penetrations oblique to the cortical surface, much less change in azimuthal sensitivity was seen in the form of azimuthal sensitivity displayed by successively isolated units in penetrations made normal to the cortical surface. 4. To determine whether some significant feature or features of azimuthal sensitivity shifted in a more continuous and/or systematic manner along frequency-band strips, azimuthal sensitivity was quantified in terms of the peak-response azimuth (PRA) of the MFs of successive units and of the azimuthal range over which the peaks occurred in the individual azimuth functions contributing to each MF (the peak-response range). In different experiments shifts in these measures of the peaks in successively isolated units along a frequency-band strip were found generally to fall into one of four categories: 1) shifts across the entire frontal hemifield; 2) clustering in the contralateral quadrant; 3) clustering in the ipsilateral quadrant; and 4) clustering about the midline. In two cases more than one of these four patterns were found along a frequency-band strip.(ABSTRACT TRUNCATED AT 400 WORDS)


2018 ◽  
Vol 67 ◽  
pp. 197-207 ◽  
Author(s):  
Mohamed Hadi Habaebi ◽  
Mohanad Janat ◽  
Md. Rafiqul Islam

2021 ◽  
Author(s):  
Harry Geddes ◽  
Henry D. Hutchinson ◽  
Alex R Ha ◽  
Nicholas P. Funnell ◽  
Andrew Goodwin

<div> <div> <div> <p>Using a non-negative matrix factorisation (NMF) approach, we show how the pair distribution function (PDF) of complex mixtures can be deconvolved into the contributions from the individual phase components and also the interface between phases. Our focus is on the model system Fe||Fe3O4. We establish proof-of-concept using idealised PDF data generated from established theory-driven models of the Fe||Fe3O4 interface. Using X-ray PDF measurements for corroded Fe samples, and employing our newly-developed NMF analysis, we extract the experimental interface PDF (‘iPDF’) for this same system. We find excellent agreement between theory and experiment. The implications of our results in the broader context of interface characterisation for complex functional materials are discussed. </p> </div> </div> </div>


Sign in / Sign up

Export Citation Format

Share Document