On the Polarisation of Radio Relics

Radio relics are extended radio emission features which trace shock waves in the periphery of galaxy clusters originating from cluster mergers. Some radio relics show a highly polarised emission, which make relics an excellent probe for the magnetisation of the intra-cluster medium. The origin of the relic polarisation is still debated. It could be a result of tangentially stretching the magnetic field at the shock surface. This scenario would naturally explain the alignment of the polarisation (E-vectors) with the shock normal. We have implemented a toy model for the relic polarisation according to this scenario. We find that the magnetic field strength itself crucially affects the fractional polarisation. Moreover, we find that the shock strength has surprisingly little effect on the overall polarisation fraction. Finally, we find that the fractional polarisation may decrease downstream depending on the magnetic field strength. Our results demonstrates that the shock compression scenario provides a very plausible explanation for the radio relic polarisation which specific features permitting to test the origin of radio relic polarisation.

Download Full-text

Implications of the Low-frequency Turnover in the Spectrum of Radio Knot C in DG Tau

The Astrophysical Journal ◽

10.3847/1538-4357/ac2b26 ◽

2021 ◽

Vol 923 (1) ◽

pp. 61

Author(s):

C.-I. Björnsson

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Radio Emission ◽

Magnetic Field Strength ◽

Spectral Index ◽

Low Frequency ◽

Relativistic Electrons ◽

Fermi Acceleration ◽

Emission Volume ◽

The Magnetic Field

Abstract The synchrotron spectrum of radio knot C in the protostellar object DG Tau has a low-frequency turnover. This is used to show that its magnetic field strength is likely to be at least 10 mG, which is roughly two orders of magnitude larger than previously estimated. The earlier, lower value is due to an overestimate of the emission volume together with an omission of the dependence of the minimum magnetic field on the synchrotron spectral index. Since the source is partially resolved, this implies a low volume-filling factor for the synchrotron emission. It is argued that the high pressure needed to account for the observations is due to shocks. In addition, cooling of the thermal gas is probably necessary in order to further enhance the magnetic field strength as well as the density of relativistic electrons. It is suggested that the observed spectral index implies that the energy of the radio-emitting electrons is below that needed to take part in first-order Fermi acceleration. Hence, the radio emission gives insights to the properties of its pre-acceleration phase. Attention is also drawn to the similarities between the properties of radio knot C and the shock-induced radio emission in supernovae.

Download Full-text

On the Configuration of the Magnetic Field of β CrB

International Astronomical Union Colloquium ◽

10.1017/s0252921100080933 ◽

1976 ◽

Vol 32 ◽

pp. 613-622

Author(s):

I.A. Aslanov ◽

Yu.S. Rustamov

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Radial Velocity ◽

Magnetic Field Strength ◽

Complex Shape ◽

Rotation Period ◽

Field Variation ◽

Magnetic Field Variation ◽

Secular Variations ◽

The Magnetic Field

SummaryMeasurements of the radial velocities and magnetic field strength of β CrB were carried out. It is shown that there is a variability with the rotation period different for various elements. The curve of the magnetic field variation measured from lines of 5 different elements: FeI, CrI, CrII, TiII, ScII and CaI has a complex shape specific for each element. This may be due to the presence of magnetic spots on the stellar surface. A comparison with the radial velocity curves suggests the presence of a least 4 spots of Ti and Cr coinciding with magnetic spots. A change of the magnetic field with optical depth is shown. The curve of the Heffvariation with the rotation period is given. A possibility of secular variations of the magnetic field is shown.

Download Full-text

The effects of magnetic field strength on the properties of wind generated from hot accretion flow

Astronomy and Astrophysics ◽

10.1051/0004-6361/201832985 ◽

2018 ◽

Vol 615 ◽

pp. A35 ◽

Cited By ~ 10

Author(s):

De-Fu Bu ◽

Amin Mosallanezhad

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Pressure Gradient ◽

Magnetic Field Strength ◽

Magnetic Pressure ◽

Gas Pressure ◽

Accretion Flow ◽

Accretion Flows ◽

Black Hole Accretion ◽

The Magnetic Field

Context. Observations indicate that wind can be generated in hot accretion flow. Wind generated from weakly magnetized accretion flow has been studied. However, the properties of wind generated from strongly magnetized hot accretion flow have not been studied. Aims. In this paper, we study the properties of wind generated from both weakly and strongly magnetized accretion flow. We focus on how the magnetic field strength affects the wind properties. Methods. We solve steady-state two-dimensional magnetohydrodynamic equations of black hole accretion in the presence of a largescale magnetic field. We assume self-similarity in radial direction. The magnetic field is assumed to be evenly symmetric with the equatorial plane. Results. We find that wind exists in both weakly and strongly magnetized accretion flows. When the magnetic field is weak (magnetic pressure is more than two orders of magnitude smaller than gas pressure), wind is driven by gas pressure gradient and centrifugal forces. When the magnetic field is strong (magnetic pressure is slightly smaller than gas pressure), wind is driven by gas pressure gradient and magnetic pressure gradient forces. The power of wind in the strongly magnetized case is just slightly larger than that in the weakly magnetized case. The power of wind lies in a range PW ~ 10−4–10−3 Ṁinc2, with Ṁin and c being mass inflow rate and speed of light, respectively. The possible role of wind in active galactic nuclei feedback is briefly discussed.

Download Full-text

COMPARISON OF CARDIAC MAGNETIC FIELD DISTRIBUTIONS DURING DEPOLARIZATION AND REPOLARIZATION

International Journal of Bifurcation and Chaos ◽

10.1142/s0218127403008971 ◽

2003 ◽

Vol 13 (12) ◽

pp. 3783-3789 ◽

Cited By ~ 4

Author(s):

F. E. SMITH ◽

P. LANGLEY ◽

L. TRAHMS ◽

U. STEINHOFF ◽

J. P. BOURKE ◽

...

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Magnetic Field Strength ◽

Field Distribution ◽

Normal Subjects ◽

The Body ◽

Magnetic Field Distribution ◽

T Wave ◽

High Magnetic Field Strength ◽

The Magnetic Field

Multichannel magnetocardiography measures the magnetic field distribution of the human heart noninvasively from many sites over the body surface. Multichannel magnetocardiogram (MCG) analysis enables regional temporal differences in the distribution of cardiac magnetic field strength during depolarization and repolarization to be identified, allowing estimation of the global and local inhomogeneity of the cardiac activation process. The aim of this study was to compare the spatial distribution of cardiac magnetic field strength during ventricular depolarization and repolarization in both normal subjects and patients with cardiac abnormalities, obtaining amplitude measurements by magnetocardiography. MCGs were recorded at 49 sites over the heart from three normal subjects and two patients with inverted T-wave conditions. The magnetic field intensity during depolarization and repolarization was measured automatically for each channel and displayed spatially as contour maps. A Pearson correlation was used to determine the spatial relationship between the variables. For normal subjects, magnetic field strength maps during depolarization (R-wave) showed two asymmetric regions of magnetic field strength with a high positive value in the lower half of the chest and a high negative value above this. The regions of high R-wave amplitude corresponded spatially to concentrated asymmetric regions of high magnetic field strength during repolarization (T-wave). Pearson-r correlation coefficients of 0.7 (p<0.01), 0.8 (p<0.01) and 0.9 (p<0.01) were obtained from this analysis for the three normal subjects. A negative correlation coefficient of -0.7 (p<0.01) was obtained for one of the subjects with inverted T-wave abnormalities, suggesting similar but inverted magnetic field and current distributions to normal subjects. Even with the high correlation values in these four subjects, the MCG was able to identify differences in the distribution of magnetic field strength, with a shift in the T-wave relative to the R-wave. The measurement of cardiac magnetic field distribution during depolarization and repolarization of normal subjects and patients with clinical abnormalities should enable the improvement of theoretical models for the explanation of the cardiac depolarization and repolarization processes.

Download Full-text

Transport of hyperpolarized samples in dissolution-DNP experiments

Physical Chemistry Chemical Physics ◽

10.1039/c9cp02600b ◽

2019 ◽

Vol 21 (25) ◽

pp. 13696-13705 ◽

Cited By ~ 4

Author(s):

Alexey S. Kiryutin ◽

Bogdan A. Rodin ◽

Alexandra V. Yurkovskaya ◽

Konstantin L. Ivanov ◽

Dennis Kurzbach ◽

...

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Magnetic Field Strength ◽

Dynamic Nuclear Polarization ◽

Nuclear Polarization ◽

Sample Transfer ◽

The Magnetic Field ◽

Dissolution Dynamic Nuclear Polarization

The magnetic field strength during sample transfer in dissolution dynamic nuclear polarization influences the resulting spectra.

Download Full-text

Zero-Field Level Crossing in the Helium Atom

Canadian Journal of Physics ◽

10.1139/p72-021 ◽

1972 ◽

Vol 50 (2) ◽

pp. 116-118 ◽

Cited By ~ 9

Author(s):

C. W. T. Chien ◽

R. E. Bardsley ◽

F. W. Dalby

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Magnetic Field Strength ◽

Helium Atom ◽

Cross Sections ◽

Zero Field ◽

Level Crossing ◽

Field Level ◽

Collision Cross Sections ◽

The Magnetic Field

Zero-field level-crossing techniques have been used to measure some upper-state lifetimes of the helium atom. The half-widths of curves obtained by plotting the polarization against the magnetic field strength for the n1D–21D transitions yielded lifetimes of 2.03 × 10−8 s for the 31D state, 3.36 × 10−8 s for the 41D state, and 7.44 × 10−8 s for the 51D state. Collision cross sections for these 1D levels were also determined.

Download Full-text

Study on Fluidization Characteristics of Magnetically Fluidized Beds for Microfine Particles

Minerals ◽

10.3390/min12010061 ◽

2022 ◽

Vol 12 (1) ◽

pp. 61

Author(s):

Yakun Tian ◽

Shulei Song ◽

Xuan Xu ◽

Xinyu Wei ◽

Shanwen Yan ◽

...

Keyword(s):

Magnetic Field ◽

Field Strength ◽

Fluidized Bed ◽

Magnetic Field Strength ◽

Fluidized Beds ◽

Expansion Rate ◽

Gas Velocity ◽

Bed Height ◽

Bed Expansion ◽

The Magnetic Field

The bed pressure drop, minimum fluidized gas velocity, bed density, and bed expansion rate are important parameters characterizing the fluidization characteristics of gas-solid fluidized beds. By analyzing these parameters, the advantages and disadvantages of the fluidization state can be known. In this study, experiments were conducted to study the fluidization characteristics of a gas-solid magnetically fluidized bed for microfine particles by changing the magnetic field strength, magnetic field addition sequence, and static bed height. The experimental results show that when the magnetic field strength increased from 0 KA/m to 5 KA/m, the minimum fluidized gas velocity of particles increased from 4.42 cm/s to 10.32 cm/s, while the bed pressure drop first increased and then decreased. When the magnetic field strength is less than 3.4 KA/m, the microfine particles in the bed are mainly acted on by the airflow; while when the magnetic field strength is greater than 3.4 KA/m, the microfine particles are mainly dominated by the magnetic field. The magnetic field addition sequence affects the fluidization quality of microfine particles. The fluidized bed with ‘adding magnetic field first’ shows a more stable fluidization state than ‘adding magnetic field later’. Increasing of the static bed height reduces the bed expansion rate. The bed expansion rate is up to 112.5% at a static bed height of h0 = 40 mm and H = 5 KA/m. This will broaden the range of density regulation of a single magnetic particle and lay the advantage of gas-solid magnetically fluidized bed for microfine particles in the field of separation of fine coal.

Download Full-text

Research on convective heat transfer characteristics of Fe3O4magnetic nanofluids under vertical magnetic field

Thermal Science ◽

10.2298/tsci201215151z ◽

2021 ◽

pp. 151-151

Author(s):

Ruihao Zhang ◽

Sixian Wang ◽

Shan Qing ◽

Zhumei Luo ◽

Zhang Xiaohui

Keyword(s):

Magnetic Field ◽

Heat Transfer ◽

Reynolds Number ◽

Field Strength ◽

Convective Heat Transfer ◽

Magnetic Field Strength ◽

Convective Heat ◽

Heat Transfer Characteristics ◽

Magnetic Nanofluids ◽

The Magnetic Field

This paper focuses on the convective heat transfer characteristics of Fe3O4 /Water magnetic nanofluids under laminar and turbulent conditions. After verifying the accuracy of the experimental apparatus, the effects of magnetic field strength, concentration, Reynolds number and temperature on the convective heat transfer coefficient have been studied. The convective heat transfer characteristics of nanofluids under laminar and turbulent flow conditions were studied in depth, and the influence of each factor on the heat transfer coefficient was analyzed by orthogonal experimental design method. Under the laminar flow conditions, the convective heat transfer of magnetic nanofluids performed best when the Reynolds number was 2000, the magnetic field strength was 600, the temperature was 30? and the concentration was 2%. And the convective heat transfer coefficient (h) increased by 3.96% than the distilled water in the same conditions. In turbulent state, the convective heat transfer of magnetic nanofluids performed the best when the Re was 6000, the magnetic field strength was 600, the temperature was 40? and the concentration was 2%. The h increased by 11.31% than the distilled water in the same Reynolds number and the magnetic field strength conditions.

Download Full-text