scholarly journals Study on the Strength Performance of Recycled Aggregate Concrete with Different Ages under Direct Shearing

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2312
Author(s):  
Xin Liang ◽  
Fang Yan ◽  
Yuliang Chen ◽  
Huiqin Wu ◽  
Peihuan Ye ◽  
...  
Keyword(s):  
Shear Strength ◽  
Shear Force ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Displacement Curve ◽  
Direct Shear ◽  
Replacement Ratio ◽  
Aggregate Concrete ◽  
Concrete Failure ◽  
Load Displacement

In order to study the mechanical properties of recycled aggregate concrete (RAC) at different ages, 264 standard cubes were designed to test its direct shear strength and cube compressive strength while considering the parameters of age and recycled aggregate replacement ratio. The failure pattern and load–displacement curve of specimens at direct shearing were obtained; the direct shear strength and residual shear strength were extracted from the load–displacement curves. Experimental results indicate that the influence of the replacement ratio for the front and side cracks of RAC is insignificant, with the former being straight and the latter relatively convoluted. At the age of three days, the damaged interface between aggregate and mortar is almost completely responsible for concrete failure; in addition to the damage of coarse aggregates, aggregate failure is also an important factor in concrete failure at other ages. The load–displacement curve of RAC at direct shearing can be divided into elasticity, elastoplasticity, plasticity, and stabilization stages. The brittleness of concrete decreases with its age, which is reflected in the gradual shortening of the elastoplastic stage. At 28 days of age, the peak direct shear force increases with the replacement ratio, while the trend is opposite at ages of 3 days, 7 days, and 14 days, respectively. The residual strength of RAC decreases inversely to the replacement ratio, with the rate of decline growing over time. A two-parameter RAC direct shear strength calculation formula was established based on the analysis of age and replacement rate to peak shear force of RAC. The relationship between cube compressive strength and direct shear strength of recycled concrete at various ages was investigated.

Study on the Basic Mechanical Properties of Recycled Concrete Hollow Block Masonry

2013 ◽  
Vol 438-439 ◽  
pp. 749-755 ◽  
Author(s):  
Tong Hao ◽  
Dong Li
Keyword(s):  
Mechanical Properties ◽  
Shear Strength ◽  
Shear Behavior ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Test Results ◽  
Aggregate Concrete ◽  
Mortar Strength ◽  
Hollow Block

By the experimental studying on the basic mechanical properties of recycled concrete hollow block masonry, the compressive and shear behavior of recycled aggregate concrete hollow block masonry under different mortar strength were analyzed. Research indicated that the compressive and shear behavior of recycled aggregate concrete hollow block masonry was similar to that of ordinary concrete hollow block masonry. The normal formula was recommended to calculate the compressive strength of the masonry. The shear strength of the masonry was affected by the mortar strength. The shear strength calculation formula of recycled concrete hollow block masonry was proposed according to the formula of masonry design code. The calculating results were in good agreement with the test results.

Shear strength of interfaces in natural and in recycled aggregate concrete

2017 ◽  
Vol 44 (3) ◽  
pp. 212-222
Author(s):  
Shakeel Ahmad Waseem ◽  
Bhupinder Singh
Keyword(s):  
Shear Strength ◽  
Shear Plane ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Failure Envelope ◽  
Interface Shear ◽  
Aggregate Concrete ◽  
Normal Strength ◽  
Strength Models

Shear strength of interfaces in natural aggregate concrete and in recycled aggregate concrete has been investigated using initially uncracked push-off specimens by varying the following parameters: replacement level of the recycled aggregates (0%, 50%, and 100%), concrete grade (normal-strength and medium-strength), and clamping force on the shear plane. Development of truss action for resisting interface shear was indicated by the observed crack patterns in the tested specimens and a truss-based analysis recommended in the literature in combination with a simplified failure envelope for concrete subjected to biaxial stresses has been used for shear strength predictions of the tested specimens. The proposed methodology, which is considered to be more rational than the empirical shear strength models available in the literature was calibrated for both the concrete types and gave conservative and reasonably accurate shear strength predictions for selected experiments taken from the literature.

Experimental Study on Compressive Strength of Recycled Aggregate Concrete with Different Replacement Ratios

2012 ◽  
Vol 174-177 ◽  
pp. 1277-1280 ◽  
Author(s):  
Hai Yong Cai ◽  
Min Zhang ◽  
Ling Bo Dang
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Failure Mode ◽  
Failure Process ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Replacement Ratio ◽  
Aggregate Concrete

Compressive strengths of recycled aggregate concrete(RAC) with different recycled aggregates(RA) replacement ratios at 7d, 28d, 60d ages are investigated respectively. Failure process and failure mode of RAC are analyzed, influences on compressive strength with same mix ratio and different RA replacement ratios are analyzed, and the reason is investigated in this paper. The experimental results indicate that compressive strength of recycled concrete at 28d age can reach the standard generally, it is feasible to mix concrete with recycled aggregates, compressive strength with 50% replacement ratio is relatively high.

Shear strength of reinforced concrete beams with recycled aggregates

2019 ◽  
Vol 22 (8) ◽  
pp. 1938-1951 ◽  
Author(s):  
George Wardeh ◽  
Elhem Ghorbel
Keyword(s):  
Tensile Strength ◽  
Shear Strength ◽  
Strain Softening ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Opening Displacement ◽  
Aggregate Concrete ◽  
Natural Aggregate ◽  
Hinge Model

This article presents an experimental program on the shear behavior of beams without transversal reinforcement manufactured with natural aggregate concrete and 100% recycled aggregate concrete. The beams were tested under four-point bending for a shear span-to-depth ratio ( a/ d) equal to 1.5 and 3.0. The mechanical properties of two mixes were characterized in terms of compressive strength, splitting tensile strength, and elastic modulus. Three-point bending tests were performed on plain pre-notched samples in order to determine the fracture properties by an inverse analysis of experimental force–crack mouth opening displacement curves using the analytical nonlinear hinge model and a power law strain-softening relationship. The strain-softening law is described by two parameters being, respectively, the power n and the critical crack opening displacement wc. The experimental results show that, for the same class of compressive strength, tensile strength, fracture energy, and the shear strength of recycled aggregate concrete are lower than natural aggregate concrete. The decrease in the fracture energy and the shear strength is consistent with the decrease in the splitting tensile strength of the recycled aggregate concrete mixes compared to the natural aggregate concrete. Critical shear crack theory was adopted to model the shear behavior of beams tested with a/ d = 3.0. For an accurate evaluation of the deformation capacity of tested beams, the nonlinear hinge model for recycled concrete members was extended to recycled concrete sections. For deep beams ( a/ d = 1.5), the strut-and-tie model was used. Finally, comparisons of prediction models to a wide range of experimental data are presented.

scholarly journals Reliability-Based Analysis of Recycled Aggregate Concrete under Carbonation

2018 ◽  
Vol 2018 ◽  
pp. 1-11 ◽  
Author(s):  
Flora Faleschini ◽  
Mariano Angelo Zanini ◽  
Lorenzo Hofer
Keyword(s):  
Prediction Models ◽  
Probabilistic Method ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Replacement Ratio ◽  
Carbonation Depth ◽  
Aggregate Concrete ◽  
Carbonation Resistance ◽  
Environmental Actions ◽  
Experimental Works

Durability represents a crucial issue for evaluating safety and serviceability of reinforced concrete structures. Many studies have already focused on carbonation-induced corrosion of natural aggregate concrete (NAC) structures, leading to several prediction models to estimate carbonation depth. Less research is devoted instead on recycled aggregate concrete (RAC), about which limited experimental works exist aimed at assessing the carbonation coefficient in accelerated tests. Additionally, deteriorating processes are subject to uncertainty, when defining materials, geometry, and environmental actions during the service life of structures. This work presents a reliability-based analysis of carbonation resistance of RACs, using experimental carbonation coefficients derived from the literature, and applied in the full-probabilistic method prosed in fib Bulletin 34. Results demonstrate how aggregates replacement ratio and w/c ratio influence the reliability of RAC carbonation resistance.

Axial behavior of carbon fiber-reinforced polymer–confined recycled aggregate concrete-filled steel tube slender square columns

2021 ◽  
pp. 136943322110339
Author(s):  
Jiongfeng Liang ◽  
Siqi Lin ◽  
Mizan Ahmed
Keyword(s):  
Steel Tube ◽  
Recycled Aggregate Concrete ◽  
Fiber Reinforced Polymer ◽  
Recycled Aggregate ◽  
Fiber Reinforced ◽  
Replacement Ratio ◽  
Aggregate Concrete ◽  
Concrete Filled Steel Tube ◽  
Reinforced Polymer ◽  
Axial Behavior

The behavior of fiber-reinforced polymer (FRP)–confined recycled aggregate concrete-filled steel tube (RACFT) columns is barely studied. Especially, that of slender specimens has not been investigated so far. In this article, an experimental test of FRP-confined RACFT slender square columns was conducted to study the influences of recycled aggregate (RA) replacement ratios, FRP thicknesses, and wrapping schemes on their axial behavior. Results in this article suggest that the RA replacement ratio barely affects the initial stiffness of load-deflection curves of specimens. Moreover, the specimen with a higher RA replacement ratio has a lower axial stress but larger strain at the peak point. The external FRP jackets (either partial or full wrap) can effectively improve the performance of axially loaded RACFT columns, and the improvement of ductility due to the increase of the FRP thickness is more significant than that of axial compressive strength. Additionally, it was found that the axial strength and ultimate axial strain decrease with increasing slenderness ratios. Furthermore, the influences of slenderness ratios on the behavior of such columns are more significant for the column with a larger length-to-width ratio. Finally, a design model for FRP-confined RACFT slender square columns is developed, which can predict the results of the present test accurately.

Compressive Behaviour of Recycle Concrete Cubes after Freeze-Thaw Cycles

2013 ◽  
Vol 671-674 ◽  
pp. 1865-1868
Author(s):  
Tao Long ◽  
Shi Hai Dong ◽  
Shi Ming Cui ◽  
Qing Yuan Wang
Keyword(s):  
Carrying Capacity ◽  
Coarse Aggregate ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Replacement Ratio ◽  
Aggregate Concrete ◽  
Freeze Thaw ◽  
Recycle Concrete ◽  
Ultimate Carrying Capacity

It is widely considered that crushed construction aggregate waste creates a lower compressive strength kind of concrete. This paper presents experimental investigation on axial compression strength of 18 recycled aggregate concrete cubes under the freeze-thaw test. The research has focused on the effect of the freezing-thawing test on the ultimate carrying capacity of recycled concrete cubes with different coarse aggregate replacement ratio. This study confirms that freezing-thawing cycles have a greater effect on the ultimate bearing capacity of recycled concrete cubes. Some measures should be taken to prevent the recycle concrete from the freeze-thaw damage, for example add air entraining agent to concrete.

Sign in / Sign up

Export Citation Format

Share Document