scholarly journals A Tri-Band Cooled Receiver for Geodetic VLBI

Sensors ◽  
2021 ◽  
Vol 21 (8) ◽  
pp. 2662
Author(s):  
José A. López-Pérez ◽  
Félix Tercero-Martínez ◽  
José M. Serna-Puente ◽  
Beatriz Vaquero-Jiménez ◽  
María Patino-Esteban ◽  
...  

This paper shows a simultaneous tri-band (S: 2.2–2.7 GHz, X: 7.5–9 GHz and Ka: 28–33 GHz) low-noise cryogenic receiver for geodetic Very Long Baseline Interferometry (geo-VLBI) which has been developed at Yebes Observatory laboratories in Spain. A special feature is that the whole receiver front-end is fully coolable down to cryogenic temperatures to minimize receiver noise. It was installed in the first radio telescope of the Red Atlántica de Estaciones Geodinámicas y Espaciales (RAEGE) project, which is located in Yebes Observatory, in the frame of the VLBI Global Observing System (VGOS). After this, the receiver was borrowed by the Norwegian Mapping Autorithy (NMA) for the commissioning of two VGOS radiotelescopes in Svalbard (Norway). A second identical receiver was built for the Ishioka VGOS station of the Geospatial Information Authority (GSI) of Japan, and a third one for the second RAEGE VGOS station, located in Santa María (Açores Archipelago, Portugal). The average receiver noise temperatures are 21, 23, and 25 Kelvin and the measured antenna efficiencies are 70%, 75%, and 60% in S-band, X-band, and Ka-band, respectively.

Author(s):  
José A. López-Pérez ◽  
Félix Tercero-Martínez ◽  
José M. Serna-Puente ◽  
Beatriz Vaquero-Jiménez ◽  
María Patino-Esteban ◽  
...  

This paper shows the development of a simultaneous tri-band (S: 2.2 - 2.7 GHz, X: 7.5 - 9 GHz and Ka: 28 - 33 GHz) low-noise cryogenic receiver for geodetic Very Long Baseline Interferometry (geo-VLBI) which has been developed by the technical staff of Yebes Observatory (IGN) laboratories in Spain. The receiver was installed in the first radio telescope of the Red Atlántica de Estaciones Geodinámicas y Espaciales (RAEGE) project, which is located in Yebes Observatory, in the frame of the VLBI Global Observing System (VGOS). After this, the receiver was borrowed by the Norwegian Mapping Autorithy (NMA) for the commissioning of two VGOS radiotelescopes in Svalbard (Norway). A second identical receiver was built for the Ishioka VGOS station of the Geospatial Information Authority (GSI) of Japan, and a third one for the second RAEGE VGOS station, located in Santa María (Açores Archipelago, Portugal). The average receiver noise temperatures are 21, 23 and 25 Kelvin and the measured antenna efficiencies are 70%, 75% and 60% in S-band, X-band and Ka-band, respectively.


2020 ◽  
Author(s):  
Dirk Behrend ◽  
Axel Nothnagel ◽  
Johannes Böhm ◽  
Chet Ruszczyk ◽  
Pedro Elosegui

<p>The International VLBI Service for Geodesy and Astrometry (IVS) is a globally operating service that coordinates and performs Very Long Baseline Interferometry (VLBI) activities through its constituent components. The VLBI activities are associated with the creation, provision, dissemination, and archiving of relevant VLBI data and products. The operational station network of the IVS currently consists of about 40 radio telescopes worldwide, subsets of which participate in regular 24-hour and 1-hour observing sessions. This legacy S/X observing network dates back in large part to the 1970s and 1980s. Because of highly demanding new scientific requirements such as sea-level change but also due to the aging infrastructure, the larger IVS community planned and started to implement a new VLBI system called VGOS (VLBI Global Observing System) at existing and new sites over the past several years. In 2020, a fledgling network of 8 VGOS stations started to observe in operational IVS sessions. We anticipate that the VGOS network will grow over the next couple of years to a global network of 25 stations and will eventually replace the legacy S/X system as the IVS production system. We will provide an overview of the recent developments and anticipated evolution of the geodetic VLBI station infrastructure.</p>


2015 ◽  
Vol 5 (1) ◽  
Author(s):  
N. Kareinen ◽  
R. Haas

AbstractThe Onsala Space Observatory has installed a modern digital backend for geodetic and astronomical Very Long Baseline Interferometry (VLBI). This system consists of a Digital Base-Band Converter (DBBC) and a Mark 5B+ recorder. From 2011 until late 2014 this new system was run for geodetic VLBI observations in parallel with the old system consisting of a Mark 4 rack and Mark 5A recording system. Several of these observed sessions were correlated at the correlator in Bonn including both data sets. We present results from the analysis and comparison of these sessions. Both the original observed delays and corresponding geodetic parameters are compared. No significant differences are detected, for either the raw observations or for the geodetic parameters. This shows that the digital backend can be used operationally for geodetic VLBI observations.


2011 ◽  
Vol 28 (2) ◽  
pp. 107-116 ◽  
Author(s):  
Leonid Petrov ◽  
Chris Phillips ◽  
Tasso Tzioumis ◽  
Bruce Stansby ◽  
Cormac Reynolds ◽  
...  

AbstractWe report the results of a successful 7-hour 1.4 GHz Very Long Baseline Interferometry (VLBI) experiment using two new stations, ASKAP-29 located in Western Australia and WARK12M located on the North Island of New Zealand. This was the first geodetic VLBI observing session with the participation of these new stations. We have determined the positions of ASKAP-29 and WARK12M. Random errors on position estimates are 150–200 mm for the vertical component and 40–50 mm for the horizontal component. Systematic errors caused by the unmodeled ionosphere path delay may reach 1.3 m for the vertical component.


2021 ◽  
Vol 95 (5) ◽  
Author(s):  
Eskil Varenius ◽  
Rüdiger Haas ◽  
Tobias Nilsson

AbstractWe present results from observation, correlation and analysis of interferometric measurements between the three geodetic very long baseline interferometry (VLBI) stations at the Onsala Space Observatory. In total, 25 sessions were observed in 2019 and 2020, most of them 24 h long, all using X band only. These involved the legacy VLBI station ONSALA60 and the Onsala twin telescopes, ONSA13NE and ONSA13SW, two broadband stations for the next-generation geodetic VLBI global observing system (VGOS). We used two analysis packages: $$\nu $$ ν Solve to pre-process the data and solve ambiguities, and ASCOT to solve for station positions, including modelling gravitational deformation of the radio telescopes and other significant effects. We obtained weighted root mean square post-fit residuals for each session on the order of 10–15 ps using group-delays and 2–5 ps using phase-delays. The best performance was achieved on the (rather short) baseline between the VGOS stations. As the main result of this work, we determined the coordinates of the Onsala twin telescopes in VTRF2020b with sub-millimetre precision. This new set of coordinates should be used from now on for scheduling, correlation, as a priori for data analyses, and for comparison with classical local-tie techniques. Finally, we find that positions estimated from phase-delays are offset $$\sim +3$$ ∼ + 3  mm in the up-component with respect to group-delays. Additional modelling of (elevation dependent) effects may contribute to the future understanding of this offset.


1988 ◽  
Vol 129 ◽  
pp. 367-368
Author(s):  
J. L. Davis ◽  
T. A. Herring ◽  
I. I. Shapiro

We have used very-long-baseline interferometry (VLBI) to make twenty-two independent measurements, between September 1984 and December 1986, of the length of the 3900-km baseline between the Mojave site in California and the Haystack/Westford site in Massachusetts. These experiments differ from the typical geodetic VLBI experiments in that a large fraction of observations are obtained at elevation angles between 4° and 10°. Data from these low elevation angles allows the vertical coordinate of site position, and hence the baseline length, to be estimated with greater precision. For the sixteen experiments processed thus far, the weighted root-mean-square scatter of the estimates of the baseline length is 8 mm. We discuss these experiments, the processing of the data, and the resulting baseline length estimates.


2009 ◽  
Vol 1 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Patrick Schuh ◽  
Hardy Sledzik ◽  
Rolf Reber ◽  
Andreas Fleckenstein ◽  
Ralf Leberer ◽  
...  

Amplifiers for the next generation of T/R modules in future active array antennas are realized as monolithically integrated circuits (MMIC) on the basis of novel AlGaN/GaN (is a chemical material description) high electron mobility transistor (HEMT) structures. Both low-noise and power amplifiers are designed for X-band frequencies. The MMICs are designed, simulated, and fabricated using a novel via-hole microstrip technology. Output power levels of 6.8 W (38 dBm) for the driver amplifier (DA) and 20 W (43 dBm) for the high-power amplifier (HPA) are measured. The measured noise figure of the low-noise amplifier (LNA) is in the range of 1.5 dB. A T/R-module front-end with mounted GaN MMICs is designed based on a multi-layer low-temperature cofired ceramic technology (LTCC).


Sign in / Sign up

Export Citation Format

Share Document