Multiwave Seismic Survey under Conditions of Salt-Dome Tectonics of the South of Cis-Ural Trough

Author(s):  
B.Y. Meltchouk ◽  
S.M. Karnaukhov ◽  
I.A. Chirkin ◽  
S.L. Aroutunov ◽  
A.E. Suntsov ◽  
...  
Keyword(s):  
1965 ◽  
Vol 5 (1) ◽  
pp. 188
Author(s):  
E. W. Vind ◽  
C. R. Harwood

Torres Strait is the narrow waterway on the Continental Shelf which connects the Arafura Sea to the Coral Sea and separates the Cape York Peninsula from South-western Papua. Within Torres Strait and the Arafura Sea the marine seismic survey area specifically discussed here covers the north-western part of Authority to Prospect 104P held by Marathon Petroleum Australia Ltd. Except for a few small islands this area is covered by a shallow tropical sea not more than 160 feet deep which is studded with coral reefs.Four regional structural features influence the area. These are the Cape York-Oriomo Ridge to the east, the Carpentaria Basin to the south and the Morehead and Papuan Basins to the north. These features are indicated by regional geology and have been confirmed by the combined interpretations of reconnaissance geophysical surveys conducted by various exploration organisations during the past 30 years.The A.T.P. 104P (West) Marine Seismic Survey, consisting of 618 miles of subsurface coverage, was carried out for Marathon between November 8 and November 28, 1964.Several operational problems prevented completion of the survey as originally planned. Shallow water and reefing prevented shooting in the north-east portion of the proposed area.Shooting 300 per cent subsurface coverage commenced in the south-eastern part of the survey area, but, due to shallow basement at less than one second, multiple coverage was not feasible. Production shooting which gave 100 per cent subsurface coverage on the short spreads was continued throughout the remainder of the survey.Two reflection horizons and a resultant isochron were mapped in the area. A "deep" reflector is interpreted as originating from granitic basement, while a "shallow" reflector is tentatively correlated with a horizon in the Cretaceous section.The "shallow" horizon mapped is essentially conformable with the "deep" horizon. Both show a regional west dip with thinning of section to the east. Some north and south components of the regional west dip are established. The resultant isochron comparisons based on this work appear too limited in scope to establish any definite local structural control of deposition.


2019 ◽  
Vol 59 (2) ◽  
pp. 869
Author(s):  
Sally Edwards ◽  
Behnam Talebi

The Georgina and South Nicholson basins and the Isa Superbasin of North West Queensland (NWQ), represent frontier basins earmarked for examination of resource potential under the Strategic Resources Exploration Program. Little exploration has occurred for petroleum resources in these basins although a proven petroleum system exists in both the Isa Superbasin and the Georgina Basin with demonstrated flow at sub-commercial rates. To increase knowledge of the petroleum system, define the extent of the South Nicholson Basin and examine basin architecture, Geoscience Australia acquired deep (to 20-s listening time) seismic data across the South Nicholson Basin and northern Isa Superbasin area in 2017. However, this survey focused on broader structural architecture definition across the Proterozoic Isa Superbasin and South Nicholson and McArthur basins. Little is understood of the petroleum system in the southern Isa Superbasin, or even if this structure is part of the Isa Superbasin, where Proterozoic gas is inferred from mineral boreholes and oil stained Cambrian-aged carbonates exist. To increase understanding of this southern region, the Queensland Government acquired a new NWQ SEEBASE® (depth to basement) model in 2018, and will be undertaking a 2D deep seismic survey within the Camooweal region to better understand the structural architecture, sediment thicknesses and seismic characteristic of packages of this southern area. The seismic survey is centred on the Georgina Basin and will tie into the South Nicholson survey – extending knowledge further south across major structures featured in the SEEBASE® model.


AAPG Bulletin ◽  
2011 ◽  
Vol 95 (7) ◽  
pp. 1257-1291 ◽  
Author(s):  
Tat Banga ◽  
Regina M. Capuano ◽  
Kadry K. Bissada

2003 ◽  
Vol 1 ◽  
pp. 367-402 ◽  
Author(s):  
Peter N. Johannessen

Paralic and shallow marine sandstones were deposited in the Danish Central Graben during Late Jurassic rifting when half-grabens were developed and the overall eustatic sea level rose. During the Kimmeridgian, an extensive plateau area consisting of the Heno Plateau and the Gertrud Plateau was situated between two highs, the Mandal High to the north, and the combined Inge and Mads Highs to the west. These highs were land areas situated on either side of the plateaus and supplied sand to the Gertrud and Heno Plateaus. Two graben areas, the Feda and Tail End Grabens, flanked the plateau area to the west and east, respectively. The regressive–transgressive succession consists of intensely bioturbated shoreface sandstones, 25–75 m thick. Two widespread unconformities (SB1, SB2) are recognised on the plateaus, forming the base of sequence 1 and sequence 2, respectively. These unconformities were created by a fall in relative sea level during which rivers may have eroded older shoreface sands and transported sediment across the Heno and Gertrud Plateaus, resulting in the accumulation of shoreface sandstones farther out in the Feda and Tail End Grabens, on the south-east Heno Plateau and in the Salt Dome Province. During subsequent transgression, fluvial sediments were reworked by high-energy shoreface processes on the Heno and Gertrud Plateaus, leaving only a lag of granules and pebbles on the marine transgressive surfaces of erosion (MTSE1, MTSE2). The sequence boundary SB1 can be traced to the south-east Heno Plateau and the Salt Dome Province, where it is marked by sharp-based shoreface sandstones. During low sea level, erosion occurred in the southern part of the Feda Graben, which formed part of the Gertrud and Heno Plateaus, and sedimentation occurred in the Norwegian part of the Feda Graben farther to the north. During subsequent transgression, the southern part of the Feda Graben began to subside, and a succession of backstepping back-barrier and shoreface sediments, 90 m thick, was deposited. In the deep Tail End and Feda Grabens and the Salt Dome Province, sequence boundary SB2 is developed as a conformity, indicating that there was not a significant fall in relative sea level in these grabens, probably as a result of high subsidence rates. Backstepping lower shoreface sandstones overlie SB2 and show a gradual fining-upwards to offshore claystones that are referred to the Farsund Formation. On the plateaus, backstepping shoreface sandstones of sequence 2 are abruptly overlain by offshore claystones, indicating a sudden deepening and associated cessation of sand supply, probably caused by drowning of the sediment source areas on the Mandal, Inge and Mads Highs. During the Volgian, the Gertrud Plateau began to subside and became a graben. During the Late Kimmeridgian – Ryazanian, a long-term relative sea-level rise resulted in deposition of a thick succession of offshore claystones forming highstand and transgressive systems tracts on the Heno Plateau, and in the Gertrud, Feda and Tail End Grabens.


Geophysics ◽  
1992 ◽  
Vol 57 (11) ◽  
pp. 1453-1462 ◽  
Author(s):  
Dave Hale ◽  
N. Ross Hill ◽  
Joe Stefani

Turning seismic waves, which first travel downward and then upward before (and after) reflection, have been recorded in a 3-D seismic survey conducted over an overhanging salt dome. Careful processing of these turning waves enables the imaging of the underside of the salt dome and of intrusions of salt into vertical faults radiating from the dome. When seismic wave velocity increases with depth, waves that initially travel downward are reflected and may turn so as to travel upward before reflection. A simple geometrical argument suggests that these turning waves are likely to exhibit abnormal moveout in common‐midpoint (CMP) gathers, in that reflection time decreases with increasing source‐receiver offset. This abnormal moveout and the attenuation of turning waves by most migration methods suggest that conventional seismic processing does not properly image turning waves. The most important step in imaging turning waves, assuming that they have been recorded, is the migration process. Simple and inexpensive modifications to the conventional phase‐shift migration method enable turning waves to be imaged for little additional computational cost. The examples provided in this paper suggest that these and other such modifications to conventional processing should be used routinely when imaging salt domes.


2017 ◽  
Author(s):  
Minghui Zhao* ◽  
Qiang Wang ◽  
Longtao Sun ◽  
Zhen Sun ◽  
Xuelin Qiu ◽  
...  

2020 ◽  
Author(s):  
C.J. Carson ◽  
P. Henson ◽  
M.P. Doublier ◽  
B. Williams ◽  
J. Simmons ◽  
...  

2014 ◽  
Author(s):  
Fuming Ruan* ◽  
Kai Yang ◽  
Qiuyun Wu ◽  
Yaoqiang Zhu ◽  
Lie Li

Sign in / Sign up

Export Citation Format

Share Document