Modeling and Control of Grid-Connected Solar-Wind Hybrid Micro-Grid System with Multiple-Input Ćuk DC-DC Converter for Household & High Power Applications

Author(s):  
Peter Anuoluwapo Gbadega ◽  
Olufunke Abolaji Balogun

There is a continuous global need for more energy, which must be cleaner than energy produced from the conventional generation technologies. As such, this need has necessitated the increasing penetration of distributed generation technologies and primarily on renewable energy sources. This paper presents a dynamic modeling and control strategy for a sustainable micro-grid, principally powered by multiple renewable energy sources (solar energy, wind energy and Fuel cell), micro sources (such as diesel generator, micro-gas turbine etc.) and energy storage scheme. More importantly, a current-source-interface, multiple-input dc-dc converter is utilized to coordinate the sustainable power sources to the main dc bus. Thus, for tracking maximum power available in solar energy, maximum power point tracking algorithm is applied. The proposed system is designed to meet load demand, manage power flow from various sources, inject excess power into the grid, and charge the battery from the grid as needed. More so, the proposed converter architecture has reduced number of power conversion stages with less component count, and reduced losses compared to existing grid-connected hybrid systems. This improves the efficiency and reliability of the system. The utilization of energy storage is essential owing to the intermittent nature of the renewable energy sources and the consequent peak power shift between the sources and the load. Following this further, a supervisory control system is designed to handle various changes in power supply and power demand by managing power intermittency, power peak shaving, and long-term energy storage. The entire hybrid system is described given along with comprehensive simulation results that reveal the feasibility of the whole scheme. The system model is designed and simulated in MATLAB SimPowerSystem in order to verify the effectiveness of the proposed scheme.

2017 ◽  
Vol 68 (11) ◽  
pp. 2641-2645
Author(s):  
Alexandru Ciocan ◽  
Ovidiu Mihai Balan ◽  
Mihaela Ramona Buga ◽  
Tudor Prisecaru ◽  
Mohand Tazerout

The current paper presents an energy storage system that stores the excessive energy, provided by a hybrid system of renewable energy sources, in the form of compressed air and thermal heat. Using energy storage systems together with renewable energy sources represents a major challenge that could ensure the transition to a viable economic future and a decarbonized economy. Thermodynamic calculations are conducted to investigate the performance of such systems by using Matlab simulation tools. The results indicate the values of primary and global efficiencies for various operating scenarios for the energy storage systems which use compressed air as medium storage, and shows that these could be very effective systems, proving the possibility to supply to the final user three types of energy: electricity, heat and cold function of his needs.


2021 ◽  
pp. 0309524X2110241
Author(s):  
Nindra Sekhar ◽  
Natarajan Kumaresan

To overcome the difficulties of extending the main power grid to isolated locations, this paper proposes the local installation of a combination of three renewable energy sources, namely, a wind driven DFIG, a solar PV unit, a biogas driven squirrel-cage induction generator (SCIG), and an energy storage battery system. In this configuration one bi-directional SPWM inverter at the rotor side of the DFIG controls the voltage and frequency, to maintain them constant on its stator side, which feeds the load. The PV-battery also supplies the load, through another inverter and a hysteresis controller. Appropriately adding a capacitor bank and a DSTATCOM has also been considered, to share the reactive power requirement of the system. Performance of various modes of operation of this coordinated scheme has been studied through simulation. All the results and relevant waveforms are presented and discussed to validate the successful working of the proposed system.


Sign in / Sign up

Export Citation Format

Share Document