The Role of Acid Concentration on Band Gap Shrinkage in Cellulose Nanocrystals Fabricated from Water Hyacinth

In this study, the fingerprint of the acid concentration during the hydrolysis process on the optical band gap of cellulose nanocrystals (CNCs) has been systematically studied. The CNCs have been prepared using hydrochloric acid at a hydrolysis temperature of 50°C and at a constant hydrolysis time of 4 hours but with varying hydrochloric cid concentrations of 5%, 10% and 15%. The crystalline structure and phase identification of the CNCs have been studied using XRD technique. UV-Vis Spectroscopy has been done and the optical band gap energy calculated by performing the Tauc’s plot. From the study, the grain size has been found to decrease with acid concentration while the band gap energy has been found to increase with increasing acid concentration. Further, the optical band gaps of the CNCs have been found to decrease with the increase in crystallite size. This shrinkage of the band gap has been attributed to the increased impurity concentration leading to the narrowing of the band gap due to the emerging of the impurity band formed by the overlapped impurity states

Download Full-text

Optical Properties of Undoped and Dy3+-Doped Boro-Tellurite Glass

Advanced Materials Research ◽

10.4028/www.scientific.net/amr.895.194 ◽

2014 ◽

Vol 895 ◽

pp. 194-199 ◽

Cited By ~ 2

Author(s):

Atiqah Ab Rasid ◽

Husin Wagiran ◽

Suhairul Hashim ◽

Rosli Hussin ◽

Zuhairi Ibrahim

Keyword(s):

Optical Properties ◽

Band Gap ◽

Tellurite Glass ◽

Optical Band Gap ◽

Band Gap Energy ◽

Excitation Wavelength ◽

Absorption Bands ◽

Gap Energy ◽

Vis Spectroscopy ◽

Doped Glasses

A series of undoped and Dy3+-doped boro-tellurite glasses were prepared, and their optical properties have been studied through XRD, absorption, optical band gap energy and photoluminescence. The XRD pattern has been used to confirm the amorphous nature of the prepared glass. The optical absorption spectra showed eight absorption bands which corresponded to 4I15/2, 4F9/2, 6F3/2, 6F5/2, 6F7/2, 6F9/2, 6F11/2 and 6H11/2 transitions from the ground state, 6H15/2. The optical band gap energy, Eopt for undoped glass was 3.08 eV and the Dy3+-doped glasses Eopt values varied from 3.16 3.24 eV. The emission spectra from photoluminescence spectroscopy showed two dominant emission peaks at 483 nm and 574 nm with an excitation wavelength of 325 nm (3.82 eV). Keywords: X-ray diffraction, boro-tellurite glass, photoluminescence, absorption spectrum, UV-Vis spectroscopy, energy band gap.

Download Full-text

Modification of optical properties of PC-PBT/Cr2O3 and PC-PBT/CdS nanocomposites by gamma irradiation

The European Physical Journal Applied Physics ◽

10.1051/epjap/2020200201 ◽

2020 ◽

Vol 92 (2) ◽

pp. 20402

Author(s):

Kaoutar Benthami ◽

Mai ME. Barakat ◽

Samir A. Nouh

Keyword(s):

Refractive Index ◽

Optical Properties ◽

Band Gap ◽

Color Difference ◽

Band Gap Energy ◽

Polybutylene Terephthalate ◽

Γ Irradiation ◽

Gap Energy ◽

Vis Spectroscopy ◽

Oxygen Atoms

Nanocomposite (NCP) films of polycarbonate-polybutylene terephthalate (PC-PBT) blend as a host material to Cr2O3 and CdS nanoparticles (NPs) were fabricated by both thermolysis and casting techniques. Samples from the PC-PBT/Cr2O3 and PC-PBT/CdS NCPs were irradiated using different doses (20–110 kGy) of γ radiation. The induced modifications in the optical properties of the γ irradiated NCPs have been studied as a function of γ dose using UV Vis spectroscopy and CIE color difference method. Optical dielectric loss and Tauc's model were used to estimate the optical band gaps of the NCP films and to identify the types of electronic transition. The value of optical band gap energy of PC-PBT/Cr2O3 NCP was reduced from 3.23 to 3.06 upon γ irradiation up to 110 kGy, while it decreased from 4.26 to 4.14 eV for PC-PBT/CdS NCP, indicating the growth of disordered phase in both NCPs. This was accompanied by a rise in the refractive index for both the PC-PBT/Cr2O3 and PC-PBT/CdS NCP films, leading to an enhancement in their isotropic nature. The Cr2O3 NPs were found to be more effective in changing the band gap energy and refractive index due to the presence of excess oxygen atoms that help with the oxygen atoms of the carbonyl group in increasing the chance of covalent bonds formation between the NPs and the PC-PBT blend. Moreover, the color intensity, ΔE has been computed; results show that both the two synthesized NCPs have a response to color alteration by γ irradiation, but the PC-PBT/Cr2O3 has a more response since the values of ΔE achieved a significant color difference >5 which is an acceptable match in commercial reproduction on printing presses. According to the resulting enhancement in the optical characteristics of the developed NCPs, they can be a suitable candidate as activate materials in optoelectronic devices, or shielding sheets for solar cells.

Download Full-text

Stability Investigation in the Optical Properties of Thermally Evaporated Ge5Se95-x Znx Thin Films

JOURNAL OF ADVANCES IN PHYSICS ◽

10.24297/jap.v7i3.1581 ◽

2015 ◽

Vol 7 (3) ◽

pp. 1923-1930

Author(s):

Austine Amukayia Mulama ◽

Julius Mwakondo Mwabora ◽

Andrew Odhiambo Oduor ◽

Cosmas Mulwa Muiva ◽

Boniface Muthoka ◽

...

Keyword(s):

Thin Films ◽

Band Gap ◽

Optical Band Gap ◽

Thermal Evaporation ◽

Optical Transition ◽

Bulk Material ◽

Band Gap Energy ◽

Optical Absorbance ◽

Gap Energy ◽

Constituent Elements

Â Selenium-based chalcogenides are useful in telecommunication devices like infrared optics and threshold switching devices. The investigated system of Ge5Se95-xZnx (0.0 â‰¤ x â‰¤ 4 at.%) has been prepared from high purity constituent elements. Thin films from the bulk material were deposited by vacuum thermal evaporation. Optical absorbance measurements have been performed on the as-deposited thin films using transmission spectra. The allowed optical transition was found to be indirect and the corresponding band gap energy determined. The variation of optical band gap energy with the average coordination number has also been investigated based on the chemical bonding between the constituents and the rigidity behaviour of the systemâ€™s network.

Download Full-text

Polymer Thermal Treatment Production of Cerium Doped Willemite Nanoparticles: An Analysis of Structure, Energy Band Gap and Luminescence Properties

Materials ◽

10.3390/ma14051118 ◽

2021 ◽

Vol 14 (5) ◽

pp. 1118

Author(s):

Ibrahim Mustapha Alibe ◽

Khamirul Amin Matori ◽

Mohd Hafiz Mohd Zaid ◽

Salisu Nasir ◽

Ali Mustapha Alibe ◽

...

Keyword(s):

Solid State ◽

Thermal Treatment ◽

Band Gap ◽

Optical Band Gap ◽

Dopant Concentration ◽

Blue Emission ◽

Green Emission ◽

Band Gap Energy ◽

Solid State Lighting ◽

Gap Energy

The contemporary market needs for enhanced solid–state lighting devices has led to an increased demand for the production of willemite based phosphors using low-cost techniques. In this study, Ce3+ doped willemite nanoparticles were fabricated using polymer thermal treatment method. The special effects of the calcination temperatures and the dopant concentration on the structural and optical properties of the material were thoroughly studied. The XRD analysis of the samples treated at 900 °C revealed the development and or materialization of the willemite phase. The increase in the dopant concentration causes an expansion of the lattice owing to the replacement of larger Ce3+ ions for smaller Zn2+ ions. Based on the FESEM and TEM micrographs, the nanoparticles size increases with the increase in the cerium ions. The mean particles sizes were estimated to be 23.61 nm at 1 mol% to 34.02 nm at 5 mol% of the cerium dopant. The optical band gap energy of the doped samples formed at 900 °C decreased precisely by 0.21 eV (i.e., 5.21 to 5.00 eV). The PL analysis of the doped samples exhibits a strong emission at 400 nm which is ascribed to the transition of an electron from localized Ce2f state to the valence band of O2p. The energy level of the Ce3+ ions affects the willemite crystal lattice, thus causing a decrease in the intensity of the green emission at 530 nm and the blue emission at 485 nm. The wide optical band gap energy of the willemite produced is expected to pave the way for exciting innovations in solid–state lighting applications.

Download Full-text

Characterization, Thermal Effect on Optical Band Gap Energy and Photoluminescence in Wurtzite ZnO:Er Nanocrystallites

Materials Today Proceedings ◽

10.1016/j.matpr.2016.01.046 ◽

2016 ◽

Vol 3 (2) ◽

pp. 145-151 ◽

Cited By ~ 4

Author(s):

Anitha ◽

Usha ◽

Jithin ◽

Christy ◽

Varughese

Keyword(s):

Band Gap ◽

Thermal Effect ◽

Optical Band Gap ◽

Band Gap Energy ◽

Gap Energy

Download Full-text

The Optical Performance of Holmium Oxide Doped Tellurite Glass for Potential Optical Fiber

Solid State Phenomena ◽

10.4028/www.scientific.net/ssp.317.95 ◽

2021 ◽

Vol 317 ◽

pp. 95-99

Author(s):

Muhammad Noorazlan Abd Azis ◽

Halimah Mohamed Kamari ◽

Suriani Abu Bakar ◽

Azlina Yahya ◽

Umar Saad Aliyu

Keyword(s):

Refractive Index ◽

Band Gap ◽

Tellurite Glass ◽

Optical Band Gap ◽

Band Gap Energy ◽

X Ray Diffraction ◽

Xrd Pattern ◽

Gap Energy ◽

Xrd Method ◽

Nonlinear Pattern

Borotellurite glass had been widely applied in the field of optical communications and devices. In this work, holmium oxides doped borotellurite glass had been successfully fabricated via conventional melt-quenched technique. The structural properties of holmium doped tellurite glass were found using x-ray diffraction (XRD) method. The nonexistence of sharp peaks in XRD pattern shows that the inclusion of holmium tellurite glass leads to the formation long range of disorderness. The optical properties of the glass system such as refractive index and optical band gap energy are investigated using UV-Vis spectrophotometer. The value of refractive index is found in nonlinear trend along with holmium oxides concentration. It is found that the refractive index is more than 2 at 0.01, 0.03 and 0.04 of holmium concentrations. The optical band gap energy was found in similar trend with refractive index which is in nonlinear pattern.

Download Full-text

Effect of thickness on the optical properties of Gaas thin films

Journal of Bangladesh Academy of Sciences ◽

10.3329/jbas.v37i1.15684 ◽

2013 ◽

Vol 37 (1) ◽

pp. 83-91 ◽

Cited By ~ 13

Author(s):

Chitra Das ◽

Jahanara Begum ◽

Tahmina Begum ◽

Shamima Choudhury

Keyword(s):

Thin Films ◽

Dielectric Constant ◽

Refractive Index ◽

Band Gap ◽

Optical Band Gap ◽

Visible Region ◽

Solar Spectrum ◽

Band Gap Energy ◽

Optical Parameters ◽

Gap Energy

Effect of thickness on the optical and electrical properties of gallium arsenide (GaAs) thin films were studied. The films of different thicknesses were prepared by vacuum evaporation method (~10-4 Pa) on glass substrates at a substrate temperature of 323 K. The film thickness was measured in situ by a frequency shift of quartz crystal. The thicknesses were 250, 300 and 500 nm. Absorption spectrum of this thin film had been recorded using UV-VIS-NIR spectrophotometer in the photon wavelength range of 300 - 2500 nm. The values of some important optical parameters of the studied films (absorption coefficient, optical band gap energy and refractive index; extinction co-efficient and real and imaginary parts of dielectric constant) were determined using these spectra. Transmittance peak was observed in the visible region of the solar spectrum. Here transmittance showed better result when thicknesses were being increased. The optical band gap energy was decreased by the increase of thickness. The refractive index increased by increasing thickness while extinction co-efficient and real and imaginary part of dielectric constant decreased. DOI: http://dx.doi.org/10.3329/jbas.v37i1.15684 Journal of Bangladesh Academy of Sciences, Vol. 37, No. 1, 83-91, 2013

Download Full-text