scholarly journals Development of an in situ Acoustic Anemometer to Measure Wind in the Stratosphere for SENSOR

2021 ◽  
Author(s):  
Liang Song ◽  
Xiong Hu ◽  
Feng Wei ◽  
Zhaoai Yan ◽  
Qingchen Xu ◽  
...  
Keyword(s):  
Wind Speed ◽  
Three Dimensional ◽  
Floating Platform ◽  
Humidity Measurements ◽  
Wind Measurements ◽  
Commercial Off The Shelf ◽  
Solar Storms ◽  
Environmental Responses ◽  
Acoustic Anemometer

Abstract. The Stratospheric Environmental respoNses to Solar stORms (SENSOR) campaign investigates the influence of solar storms on the stratosphere. This campaign employs a long-duration zero-pressure balloon as a platform to carry multiple types of payloads during a series of flight experiments in the mid-latitude stratosphere from 2019 to 2022. This article describes the development and testing of an acoustic anemometer for obtaining in situ wind measurements along the balloon trajectory. Developing this anemometer was necessary, as there is no existing commercial off-the-shelf product, to the authors’ knowledge, capable of obtaining in situ wind measurements on a high-altitude balloon or other similar floating platform in the stratosphere. The anemometer is also equipped with temperature, pressure, and humidity sensors from a Temperature-Pressure-Humidity measurement module, inherited from a radiosonde developed for sounding balloons. The acoustic anemometer and other sensors were used in a flight experiment of the SENSOR campaign that took place in the Da chaidan District (95.37° E, 37.74° N) on 4 September 2019. Three-dimensional wind speed observations, which were obtained during level flight at an altitude of around 25 km, are presented. A preliminary analysis of the measurements yielded by the anemometer are also discussed. In addition to wind speed measurements, temperature, pressure, and relative humidity measurements during ascent are compared to observations from a nearby radiosonde launched four hours earlier. The problems experienced by the acoustic anemometer during the 2019 experiment show that the acoustic anemometer must be improved for future experiments in the SENSOR campaign.

scholarly journals Development of an in situ Acoustic Anemometer to Measure Wind in the Stratosphere for SENSOR

2021 ◽  
Author(s):  
Song Liang ◽  
Hu Xiong ◽  
Wei Feng ◽  
Yan Zhaoai ◽  
Xu Qingchen ◽  
...  
Keyword(s):  
Wind Speed ◽  
Meridional Wind ◽  
Floating Platform ◽  
Level Flight ◽  
Subsequent Publication ◽  
Wind Measurements ◽  
Commercial Off The Shelf ◽  
Solar Storms ◽  
Acoustic Anemometer

Abstract. The Stratospheric Environmental respoNses to Solar stORms (SENSOR) campaign investigates the influence of solar storms on the stratosphere. This campaign employs a long-duration zero-pressure balloon as a platform to carry multiple types of payloads during a series of flight experiments in the mid-latitude stratosphere from 2019 to 2022. This article describes the development and testing of an acoustic anemometer for obtaining in situ wind measurements along the balloon trajectory. Developing this anemometer was necessary, as there is no existing commercial off-the-shelf product, to the authors' knowledge, capable of obtaining in situ wind measurements on a high-altitude balloon or other similar floating platform in the stratosphere. The anemometer is also equipped with temperature, pressure, and humidity sensors from a Temperature-Pressure-Humidity measurement module, inherited from a radiosonde developed for sounding balloons. The acoustic anemometer and other sensors were used in a flight experiment of the SENSOR campaign that took place in the Da chaidan District (95.37° E, 37.74° N) on 4 September 2019. The zonal and meridional wind speed observations, which were obtained during level flight at an altitude exceeding 20 km, are presented. This is the first time that in situ wind measurements were obtained during level flight at this altitude. In addition to wind speed measurements, temperature, pressure, and relative humidity measurements during ascent are compared to observations from a nearby radiosonde launched four hours earlier. Further analysis of the wind data will presented in a subsequent publication. The problems experienced by the acoustic anemometer during the 2019 experiment show that the acoustic anemometer must be improved for future experiments in the SENSOR campaign.

scholarly journals ON THE CORRECTION OF LAND-BASED WIND MEASUREMENTS FOR OCEANOGRAPHIC APPLICATIONS

1980 ◽  
Vol 1 (17) ◽  
pp. 43 ◽  
Author(s):  
S.A. Hsu
Keyword(s):  
Wind Speed ◽  
Gulf Of Alaska ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Data Sets ◽  
Onshore Wind ◽  
Mean Wind Speed ◽  
Wind Measurements ◽  
Nocturnal Inversion

Simultaneous offshore and onshore wind measurements were made at stations ranging from Somalia, near the equator, to the Gulf of Alaska. Offshore data obtained from standard U.S. NOAA buoys, research platforms, and merchant ships were compared with data from coastal stations. The results indicated that, under the commonly observed speed of 5-6 m/s, land measurements of mean wind speed are only 63% of the offshore mean speed. Furthermore, it was found that only those stations located in the beach area that measure wind speed above both the internal boundary layer and the nocturnal inversion height represent offshore conditions. In order to correct land-measured wind data, a formula is developed and verified by all 2/3 existing data sets. A simplified equation, i.e., U = 3 U1 s is proposed for offshore applications. Criteria for in situ wind measurements near the coast are outlined. Data reduction procedures for inland stations are also provided.

Correlated Studies of Cellular Interactions Using TEM, Freeze Etching, and SEM

1974 ◽  
Vol 32 ◽  
pp. 320-321
Author(s):  
J. P. Revel
Keyword(s):  
Developmental Stages ◽  
Three Dimensional ◽  
Cell Movement ◽  
Cellular Interactions ◽  
Serial Sections ◽  
Cell Sheets ◽  
Freeze Etching ◽  
Early Developmental

Movement of individual cells or of cell sheets and complex patterns of folding play a prominent role in the early developmental stages of the embryo. Our understanding of these processes is based on three- dimensional reconstructions laboriously prepared from serial sections, and from autoradiographic and other studies. Many concepts have also evolved from extrapolation of investigations of cell movement carried out in vitro. The scanning electron microscope now allows us to examine some of these events in situ. It is possible to prepare dissections of embryos and even of tissues of adult animals which reveal existing relationships between various structures more readily than used to be possible vithout an SEM.

In vitro and in vivo polysaccharides assembly: ultrastructural and cytochemical study of growing plant cell wall components.

1978 ◽  
Vol 36 (2) ◽  
pp. 434-435
Author(s):  
D. Reis ◽  
B. Vian ◽  
J. C. Roland
Keyword(s):  
Cell Wall ◽  
Self Assembly ◽  
Plant Cell Wall ◽  
Higher Plants ◽  
Three Dimensional ◽  
Cytochemical Study ◽  
Wall Components

Wall morphogenesis in higher plants is a problem still open to controversy. Until now the possibility of a transmembrane control and the involvement of microtubules were mostly envisaged. Self-assembly processes have been observed in the case of walls of Chlamydomonas and bacteria. Spontaneous gelling interactions between xanthan and galactomannan from Ceratonia have been analyzed very recently. The present work provides indications that some processes of spontaneous aggregation could occur in higher plants during the formation and expansion of cell wall.Observations were performed on hypocotyl of mung bean (Phaseolus aureus) for which growth characteristics and wall composition have been previously defined.In situ, the walls of actively growing cells (primary walls) show an ordered three-dimensional organization (fig. 1). The wall is typically polylamellate with multifibrillar layers alternately transverse and longitudinal. Between these layers intermediate strata exist in which the orientation of microfibrils progressively rotates. Thus a progressive change in the morphogenetic activity occurs.

In situ investigation of the primary recrystallization of alpha titanium in HVEM

1978 ◽  
Vol 36 (1) ◽  
pp. 634-635
Author(s):  
S. Naka ◽  
R. Penelle ◽  
R. Valle
Keyword(s):  
Dimensional Analysis ◽  
Texture Evolution ◽  
Cold Work ◽  
Three Dimensional ◽  
Primary Recrystallization ◽  
Thin Foils ◽  
In Situ Investigation ◽  
Grain Growth Model ◽  
Alpha Titanium

The in situ experimentation technique in HVEM seems to be particularly suitable to clarify the processes involved in recrystallization. The material under investigation was unidirectionally cold-rolled titanium of commercial purity. The problem was approached in two different ways. The three-dimensional analysis of textures was used to describe the texture evolution during the primary recrystallization. Observations of bulk-annealed specimens or thin foils annealed in the microscope were also made in order to provide information concerning the mechanisms involved in the formation of new grains. In contrast to the already published work on titanium, this investigation takes into consideration different values of the cold-work ratio, the temperature and the annealing time.Two different models are commonly used to explain the recrystallization textures i.e. the selective grain growth model (Beck) or the oriented nucleation model (Burgers). The three-dimensional analysis of both the rolling and recrystallization textures was performed to identify the mechanismsl involved in the recrystallization of titanium.

Detection and mapping of interactions between chromatin and the nuclear envelope in drosophila embryos

1995 ◽  
Vol 53 ◽  
pp. 764-765
Author(s):  
W.F. Marshall ◽  
A.F. Dernburg ◽  
B. Harmon ◽  
J.W. Sedat
Keyword(s):  
Nuclear Envelope ◽  
Chromatin Condensation ◽  
Three Dimensional ◽  
Physiological Role ◽  
Nuclear Surface ◽  
Intact Cells ◽  
Molecular Determinants ◽  
Surface Harmonic ◽  
Drosophila Embryos

Interactions between chromatin and nuclear envelope (NE) have been implicated in chromatin condensation, gene regulation, nuclear reassembly, and organization of chromosomes within the nucleus. To further investigate the physiological role played by such interactions, it will be necessary to determine which loci specifically interact with the nuclear envelope. This will not only facilitate identification of the molecular determinants of this interaction, but will also allow manipulation of the pattern of chromatin-NE interactions to probe possible functions. We have developed a microscopic approach to detect and map chromatin-NE interactions inside intact cells.Fluorescence in situ hybridization (FISH) is used to localize specific chromosomal regions within the nucleus of Drosophila embryos and anti-lamin immunofluorescence is used to detect the nuclear envelope. Widefield deconvolution microscopy is then used to obtain a three-dimensional image of the sample (Fig. 1). The nuclear surface is represented by a surface-harmonic expansion (Fig 2). A statistical test for association of the FISH spot with the surface is then performed.

Three-Dimensional Subcellular Organization of Hepatocytes in Intact Liver: Simultaneous Visualization of Cytoskeletal and Membrane Markers by Confocal Microscopy

1996 ◽  
Vol 54 ◽  
pp. 288-289
Author(s):  
Greg V. Martin ◽  
Ann L. Hubbard
Keyword(s):  
Three Dimensional ◽  
Integral Membrane Proteins ◽  
Polarized Secretion ◽  
Microscope Images ◽  
Computer Aided ◽  
Intracellular Organelles ◽  
Cytoskeletal Elements ◽  
Simultaneous Visualization

The microtubule (MT) cytoskeleton is necessary for many of the polarized functions of hepatocytes. Among the functions dependent on the MT-based cytoskeleton are polarized secretion of proteins, delivery of endocytosed material to lysosomes, and transcytosis of integral plasma membrane (PM) proteins. Although microtubules have been shown to be crucial to the establishment and maintenance of functional and structural polarization in the hepatocyte, little is known about the architecture of the hepatocyte MT cytoskeleton in vivo, particularly with regard to its relationship to PM domains and membranous organelles. Using an in situ extraction technique that preserves both microtubules and cellular membranes, we have developed a protocol for immunofluorescent co-localization of cytoskeletal elements and integral membrane proteins within 20 µm cryosections of fixed rat liver. Computer-aided 3D reconstruction of multi-spectral confocal microscope images was used to visualize the spatial relationships among the MT cytoskeleton, PM domains and intracellular organelles.

Mathematical Model Investigation of Far-Field Transport of Ocean-Dumped Sewage Sludge Related to Remote Sensing

1982 ◽  
Vol 14 (3) ◽  
pp. 33-39
Author(s):  
C Y Kuo
Keyword(s):  
New York ◽  
Sewage Sludge ◽  
Laboratory Data ◽  
Three Dimensional ◽  
Approximate Model ◽  
Transport Processes ◽  
Far Field ◽  
New York Bight ◽  
Mean Current

An existing, three-dimensional, Eulerian-Lagrangian finite-difference model was modified and used to examine the far-field transport processes of dumped sewage sludge in the New York Bight. Both in situ and laboratory data were utilized in an attempt to approximate model inputs such as mean current speed, vertical and horizontal diffusion coefficients, particle size distributions, and specific gravities. Concentrations of the sludge near the sea surface predicted from the computer model were compared qualitatively with those remotely sensed.

Sign in / Sign up

Export Citation Format

Share Document