CFD Research on the Hydrodynamic Performance of Submarine Sailing near the Free Surface with Long-Crested Waves

The simulations of submarine sailing near the free surface with long-crested waves have been conducted in this study using an in-house viscous URANS solver with an overset grid approach. First, the verification and validation procedures were performed to evaluate the reliability, with the results showing that the generation of irregular waves is adequately accurate and the results of total resistance are in good agreement with EFD. Next, three different submerged depths ranging from 1.1D to 3.3D were selected and the corresponding conditions of submarine sailing near calm water were simulated, the results of which were then compared with each other to investigate the influence of irregular waves and submerged depths. The simulations of the model near calm water at different submerged depths demonstrated that the free surface will cause increasing resistance, lift, and bow-up moments of the model, and this influence decreases dramatically with greater submerged depths. The results of the irregular wave simulations showed that irregular waves cause considerable fluctuations of hydrodynamic force and moments, and that this influence remains even at a deeper submerged depth, which can complicate the control strategies of the submarine. The response spectrum of hydrodynamic forces and moments showed slight amplitudes in the high-frequency region, and the model showed less sensitivity to high-frequency excitations.

Fungi anaesthesia

Electrical activity of fungus Pleurotus ostreatus is characterised by slow (h) irregular waves of baseline potential drift and fast (min) action potential likes spikes of the electrical potential. An exposure of the myceliated substrate to a chloroform vapour lead to several fold decrease of the baseline potential waves and increase of their duration. The chloroform vapour also causes either complete cessation of spiking activity or substantial reduction of the spiking frequency. Removal of the chloroform vapour from the growth containers leads to a gradual restoration of the mycelium electrical activity.

Estimate of Wave Overtopping Rate on Vertical Wall Using FUNWAVE-TVD Model

This study established a numerical model capable of calculating the wave overtopping rate of coastal structures by nonlinear irregular waves using the FUNWAVE-TVD model, a fully nonlinear Boussinesq equation model. Here, a numerical model was established by coding the mean value approach equations of EurOtop (2018) and empirical formula by Goda (2009), and adding them as subroutines of the FUNWAVE-TVD model. The verification of the model was performed by numerically calculating the wave overtopping rate of nonlinear irregular waves on vertical wall structures and comparing them with the experimental results presented in EurOtop (2018). As a result of the verification, the numerical calculation result according to the EurOtop equation of this model was very well matched with the experimental result in all relative freeboard (Rc/Hmo) range under non-impulsive wave conditions, and the numerical calculation result of empirical formula was evaluated slightly smaller than the experimental result in Rc/Hmo < 0.8 and slightly larger than the experimental result in Rc/Hmo > 0.8. The results of this model were well represented in both the exponential curve and the power curve under impulsive wave conditions. Therefore, it was confirmed that this numerical model can simulate the wave overtopping rate caused by nonlinear irregular waves in an vertical wall structure.

Numerical and Experimental Investigation of the Performance of Dynamic Wing for Augmenting Ship Propulsion in Head and Quartering Seas

Flapping-foil thrusters arranged at the bow of the ship are examined for the exploitation of energy from wave motions by direct conversion to useful propulsive power, offering at the same time dynamic stability and reduction of added wave resistance. In the present work, the system consisting of the ship and an actively controlled wing located in front of its bow is examined in irregular waves. Frequency-domain seakeeping analysis is used for the estimation of ship-foil responses and compared against experimental measurements of a ferry model in head waves tested at the National Technical University of Athens (NTUA) towing tank. Next, to exploit the information concerning the responses from the verified seakeeping model, a detailed time-domain analysis of the loads acting on the foil, both in head and quartering seas, is presented, as obtained by means of a cost-effective time-domain boundary element method (BEM) solver validated by a higher fidelity RANSE finite volume solver. The results demonstrate the good performance of the examined system and will further support the development of the system at a larger model scale and the optimal design at full scale for specific ship types.

Study on the Resonant Behaviors of a Bottom-Hinged Oscillating Wave Surge Converter

This paper studied the resonant behaviors of a bottom-hinged oscillating wave surge converter (OWSC) as well as the relationship of resonance with the response and capture width ratio (CWR). The time-domain dynamic equation of an OWSC in shallow water based on the boundary element method (BEM) was solved by a Python code, considering the corrected wave surface and the nonlinearities of restoring moment, drag, and friction. The unknown factors, such as wave surface corrected factor and drag coefficient, were effectively calibrated with computational fluid dynamics (CFD) method. An intermediate initial angle in free decay is appropriate for use to determine the natural period. Under regular waves, the resonance occurs near the natural period for the uniform wave amplitude, rather than the uniform wave torque amplitude, and can disappear due to the amplification of Power Take-Off (PTO) friction. Under unit-amplitude regular waves, the period of maximum CWR is relatively close to the period of maximum velocity, but far from the resonant period. Under irregular waves, no stable resonance is observed because the maximum equivalent pitch angle appears at different peak periods of wave spectra with the variation in PTO damping. When the period of a regular wave or the peak period of an irregular wave is close to the natural period, a phase hysteresis of velocity relative to wave torque always occurs.

SLAM CHARACTERISTICS OF A HIGH-SPEED WAVE PIERCING CATAMARAN IN IRREGULAR WAVES

Slam characteristics of a 112m INCAT wave piercing catamaran in a range of realistic irregular sea conditions are presented in this paper. Towing tank testing of a 2.5 m hydroelastic segmented catamaran model was used to gather a database of slam events in irregular seas. The model was instrumented to measure motions, centrebow surface pressures and forces, encountered wave elevations and wave elevations within the bow area tunnel arches. From these measurements characteristics of the vessel slamming behaviour are examined: in particular relative vertical velocity, centrebow immersion, archway wave elevations and slam load distributions. A total of 2,098 slam events were identified over 22 different conditions, each containing about 80 to 100 slam events. The data, although inherently scattered, shows that encounter wave frequency and significant wave height are important parameters with regard to centrebow slamming. Relative vertical velocity was found to be a poor indicator of slam magnitude and slams were found to occur before the centrebow arch tunnel was completely filled, supporting the application of a two-dimensional filling height parameter as a slam indicator.