Detection and localization of S1 and S2 heart sounds by 3rd order normalized average Shannon energy envelope algorithm

Adults born after 1970s are more prone to cardiovascular diseases. Death rate percentage is quite high due to heart related diseases. Therefore, there is necessity to enquire the problem or detection of heart diseases earlier for their proper treatment. As, Valvular heart disease, that is, stenosis and regurgitation of heart valve, are also a major cause of heart failure; which can be diagnosed at early-stage by detection and analysis of heart sound signal, that is, HS signal. In this proposed work, an attempt has been made to detect and localize the major heart sounds, that is, S1 and S2. The work in this article consists of three parts. Firstly, self-acquisition of Phonocardiogram (PCG) and Electrocardiogram (ECG) signal through a self-assembled, data-acquisition set-up. The Phonocardiogram (PCG) signal is acquired from all the four auscultation areas, that is, Aortic, Pulmonic, Tricuspid and Mitral on human chest, using electronic stethoscope. Secondly, the major heart sounds, that is, S1 and S2are detected using 3rd Order Normalized Average Shannon energy Envelope (3rd Order NASE) Algorithm. Further, an auto-thresholding has been used to localize time gates of S1 and S2 and that of R-peaks of simultaneously recorded ECG signal. In third part; the successful detection rate of S1 and S2, from self-acquired PCG signals is computed and compared. A total of 280 samples from same subjects as well as from different subjects (of age group 15–30 years) have been taken in which 70 samples are taken from each auscultation area of human chest. Moreover, simultaneous recording of ECG has also been performed. It was analyzed and observed that detection and localization of S1 and S2 found 74% successful for the self-acquired heart sound signal, if the heart sound data is recorded from pulmonic position of Human chest. The success rate could be much higher, if standard data base of heart sound signal would be used for the same analysis method. The, remaining three auscultations areas, that is, Aortic, Tricuspid, and Mitral have smaller success rate of detection of S1 and S2 from self-acquired PCG signals. So, this work justifies that the Pulmonic position of heart is most suitable auscultation area for acquiring PCG signal for detection and localization of S1 and S2 much accurately and for analysis purpose.

Automated Signal Quality Assessment for Heart Sound Signal by Novel Features and Evaluation in Open Public Datasets

Automated heart sound signal quality assessment is a necessary step for reliable analysis of heart sound signal. An unavoidable processing step for this objective is the heart sound segmentation, which is still a challenging task from a technical viewpoint. In this study, ten features are defined to evaluate the quality of heart sound signal without segmentation. The ten features come from kurtosis, energy ratio, frequency-smoothed envelope, and degree of sound periodicity, where five of them are novel in signal quality assessment. We have collected a total of 7893 recordings from open public heart sound databases and performed manual annotation for each recording as gold standard quality label. The signal quality is classified based on two schemes: binary classification (“unacceptable” and “acceptable”) and triple classification (“unacceptable”, “good,” and “excellent”). Sequential forward feature selection shows that the feature “the degree of periodicity” gives an accuracy rate of 73.1% in binary SVM classification. The top five features dominate the classification performance and give an accuracy rate of 92%. The binary classifier has excellent generalization ability since the accuracy rate reaches to ( 90.4 ± 0.5 ) % even if 10% of the data is used to train the classifier. The rate increases to ( 94.3 ± 0.7 ) % in 10-fold validation. The triple classification has an accuracy rate of ( 85.7 ± 0.6 ) % in 10-fold validation. The results verify the effectiveness of the signal quality assessment, which could serve as a potential candidate as a preprocessing in future automatic heart sound analysis in clinical application.

Research on Segmentation and Classification of Heart Sound Signals Based on Deep Learning

The heart sound signal is one of the signals that reflect the health of the heart. Research on the heart sound signal contributes to the early diagnosis and prevention of cardiovascular diseases. As a commonly used deep learning network, convolutional neural network (CNN) has been widely used in images. In this paper, the method of analyzing heart sound through using CNN has been studied. Firstly, the original data set was preprocessed, and then the heart sounds were segmented on U-net, based on the deep CNN. Finally, the classification of heart sounds was completed through CNN. The data from 2016 PhysioNet/CinC Challenge was utilized for algorithm validation, and the following results were obtained. When the heart sound segmented, the overall accuracy rate was 0.991, the accuracy of the first heart sound was 0.991, the accuracy of the systolic period was 0.996, the accuracy of the second heart sound was 0.996, and the accuracy of the diastolic period was 0.997, and the average accuracy rate was 0.995; While in classification, the accuracy was 0.964, the sensitivity was 0.781, and the specificity was 0.873. These results show that deep learning based on CNN shows good performance in the segmentation and classification of the heart sound signal.