Abstract
The main thing for rotating equipment is to measure vibration, since, in the process of irreversible state change, a chain of defects always occurs and at least one of them significantly changes the vibration of the equipment. Using tank scales for static equipment, the vibration measuring makes it possible to determine the actual values of the levels and compare them with the maximum permissible values set by the manufacturer or regulatory documents. Also, the measurement of vibration levels in the time signal allows determining resonant frequencies at which vibration levels significantly increase due to the coincidence of the natural frequencies of the equipment with external workers, which can lead to increased loads on the supporting metal structures, suspended equipment and subsequently to fatigue destruction of the latter. Results of the work: the excess of the measured vibration levels on the supports of the hopper scales No. 28.1 was recorded by vibration acceleration in pt.11 (longitudinal direction) from twelve measurements; the excess of the measured vibration levels on the supports of the hopper scales No. 28.2 was not recorded, but increased levels of vibration speed were observed in pt. 11 and pt. 12; excessive vibration levels at the same measurement points on different scales may indicate that it is necessary to conduct a survey of the operation of the valve mechanism for smooth running and to monitor the condition of the metal structure under the fourth supports; it is recommended to perform a repeated measurement of the vibration of the hopper scales after inspection and repair of the structures of the scales.
Vibration Test Measures for Pump Fault Diagnosis
