Mode I stress intensity factor with various crack types

Presence of cracks in mechanical components needs much attention, where the stress field is affected by cracks and the propagation of cracks may be occurred causing the damage. The objective of this paper is to present an investigation of crack type effect on crack severity in a finite plate. Three cases of cracked plate with three different types of cracks are assumed in this work, i.e., single edge crack, center crack and double edge crack. 2D numerical models of cases of cracked plate are established in finite element analysis (FEA), ANSYS software by adopting PLANE 183 element. Values of FEA mode I stress intensity factor SIF and Von-Mises stress at crack apex are determined for cases of cracked plate under tensile stress with different values. To identify the crack severity, the comparison of FEA results for different cracked cases is made. The comparison showed that, single edge cracked plate (SECP) has the maximum values of mode I SIF and Von-Mises stress at crack apex, i.e. the greatest crack severity is considered. Also, values of FEA Von-Mises stress at crack apex for center cracked plate (CCP) are moderate and for double edge cracked plate (DECP) are the minimum. Besides, in case of high crack lengths, it is found that, FEA results of mode I SIF in case of (CCP) are higher than those of in case of (DECP). Consequently, crack severity is considered as moderate in case of (CCP) and the minimum in case of (DECP). Empirical formulas are used to approximately estimate mode I SIF for all the case studies of cracked plate in this study and the results are compared to those of FEA. A good agreement between analytical and FEA results has been showed by this comparison.

Study of plate vibrating in fluids having part-through crack at random angles and locations

This study presents the vibration characteristics of plate with part-through crack at random angles and locations in fluid. An experimental setup was designed and a series of tests were performed for plates submerged in fluid having cracks at selected angles and locations. However, it was not possible to study these characteristics for all possible crack angles and crack locations throughout the plate dimensions at any fluid level. Therefore, an analytical study is also carried out for plate having horizontal cracks submerged in fluid by adding the influence of crack angle and crack location. The effect of crack angle is incorporated into plate equation by adding bending and twisting moments, and in-plane forces that are applied due to antisymmetric loading, while the influence of crack location is also added in terms of compliance coefficients. Galerkin’s method is applied to get time dependent modal coordinate system. The method of multiple scales is used to find the frequency response and peak amplitude of submerged cracked plate. The analytical model is validated from literature for the horizontally cracked plate submerged in fluid as according to the best of the authors’ knowledge, literature lacks in results for plate with crack at random angle and location in the presence of fluid following validation with experimental results. The combined effect of crack angle, crack location and fluid on the natural frequencies and peak amplitude are investigated in detail. Phenomenon of bending hardening or softening is also observed for different boundary conditions using nonlinear frequency response curves.