A Project To Estimate The Power Capacity Of Geothermal Power Plants Based On The Enthalpy Of Geothermal Fluid And Plant Design

Surface phenomena that signal the presence of viable geothermal energy can be found in various locations in Nigeria. None of these locations have been explored extensively to determine the feasibility of sustainable geothermal energy development for electricity generation or direct heating purposes. In this context, the present study aims to provide insight into the energy potential of such development based on the enthalpy estimation of geothermal reservoirs. This particular project was conducted to determine the power output from a geothermal resource given an estimated enthalpy of the geothermal fluid. The process route chosen for this project is the single-flash geothermal power plant because of the temperature (180℃) and unique property of the geothermal fluid (a mixture of hot water and steam that exists as a liquid under high pressure). The Ikogosi warm spring in Ekiti State, Nigeria was chosen as the site location for this power plant. To support food security efforts in Africa, this project proposes the cascading of a hot water stream from the flash tank to serve direct heat purposes in agriculture for food preservation, before re-injection to the reservoir. The flowrate of the geothermal fluid to the flash separator was chosen as 3125 tonnes/hr. The power output from a single well using a single flash geothermal plant was evaluated to be 11.3 MW*. This result was obtained by applying basic thermodynamic principles, including material balance, energy balance, and enthalpy calculations. This particular project is a prelude to a robust model that will accurately determine the power capacity of geothermal power plants based on the enthalpy of geothermal fluid, size of the geothermal resource, and different plant designs. I hope that the knowledge gained from the study will promote best practices in geothermal engineering and emphasize appropriate planning for, and implementation of, geothermal plants.

A Project To Estimate The Power Capacity Of Geothermal Power Plants Based On The Enthalpy Of Geothermal Fluid And Plant Design

Nigeria has some surface phenomena that indicate the presence of viable geothermal energy. None of these locations have been explored extensively to determine the feasibility of sustainable geothermal energy development for electricity generation or direct heating. In this context, the present study aims to provide insight into the energy potential of such development based on the enthalpy estimation of geothermal reservoirs. This particular project was conducted to determine the amount of energy that can be gotten from a geothermal reservoir for electricity generation and direct heating based on the estimated enthalpy of the geothermal fluid. The process route chosen for this project is the single-flash geothermal power plant because of the temperature (180℃) and unique property of the geothermal fluid (a mixture of hot water and steam that exists as a liquid under high pressure). The Ikogosi warm spring in Ekiti State, Nigeria was chosen as the site location for this power plant. To support food security efforts in Africa, this project proposes the cascading of a hot water stream from the flash tank to serve direct heat purposes in agriculture for food preservation, before re-injection to the reservoir. The flowrate of the geothermal fluid to the flash separator was chosen as 3125 tonnes/hr. The power output from a single well using a single flash geothermal plant was evaluated to be 11.3 MW*. This result was obtained by applying basic thermodynamic principles, including material balance, energy balance, and enthalpy calculations. This particular project is a prelude to a robust model that will accurately determine the power capacity of geothermal power plants based on the enthalpy of fluid and different plant designs.

The impact of joint attention on the sound-induced flash illusions

Humans coordinate their focus of attention with others, either by gaze following or prior agreement. Though the effects of joint attention on perceptual and cognitive processing tend to be examined in purely visual environments, they should also show in multisensory settings. According to a prevalent hypothesis, joint attention enhances visual information encoding and processing, over and above individual attention. If two individuals jointly attend to the visual components of an audiovisual event, this should affect the weighing of visual information during multisensory integration. We tested this prediction in this preregistered study, using the well-documented sound-induced flash illusions, where the integration of an incongruent number of visual flashes and auditory beeps results in a single flash being seen as two (fission illusion) and two flashes as one (fusion illusion). Participants were asked to count flashes either alone or together, and expected to be less prone to both fission and fusion illusions when they jointly attended to the visual targets. However, illusions were as frequent when people attended to the flashes alone or with someone else, even though they responded faster during joint attention. Our results reveal the limitations of the theory that joint attention enhances visual processing as it does not affect temporal audiovisual integration.

Exergy Analysis Using a Theoretical Formulation of a Geothermal Power Plant in Cerro Prieto, México

The purpose of this research is the calculation of the exergy destruction of the single-flash and double-flash cycles of a geothermal power plant located on the ladder of the 233 m Cerro Prieto volcano, on the alluvial plain of the Mexicali Valley, Mexico. The methodology developed in this research presents thermodynamic models for energy and exergy flows, which allows determining the contribution of each component to the total exergy destruction of the system. For the case-base, the results indicate that for the single-flash configuration the efficiency of the first and second law of thermodynamics are 0.1888 and 0.3072, as well as the highest contribution to the total exergy destruction is provided by the condenser. For the double-flash configuration, the efficiency of the first and second law of thermodynamics are 0.3643 and 0.4983. The highest contribution to the total exergy destruction is provided by the condenser and followed by the low-pressure turbine.

Does ganciclovir exert retinal toxicity after multiple continuous intravitreal injections?

Background The objective of this study is to report a case of acute retinal necrosis in which abnormalities in visual function did not correspond to retinal anatomical outcomes. Case presentation A 39-year-old female diagnosed with acute retinal necrosis underwent repeated (nine rounds) intravitreal ganciclovir injection (3 mg/0.1 ml) into the left eye, one injection every 2 weeks. During the therapy, the patient noticed her visual acuity declining gradually. The best corrected visual acuity in the left eye was 20/33. The visual field showed massive visual damage. There was no posterior necrotizing involvement, no macular edema or exudation, and only slight abnormity of the interdigitation zone in the fovea area was visible on OCT. Angio-OCT revealed normal capillary density of three retinal capillary and choriocapillaris layers. The visually evoked potential was normal. The photopic single-flash response showed a declined amplitude of a-wave and b-wave. The amplitudes of photopic 30 Hz flicker were decreased. Multifocal electroretinography revealed macular dysfunction. Conclusion Ganciclovir-associated photoreceptor damage may induce abnormalities in retinal function in response to multiple continuous intravitreal ganciclovir injections at a relatively high dosage (3 mg/0.1 ml).

Development and Analysis of the Novel Hybridization of a Single-Flash Geothermal Power Plant with Biomass Driven sCO2-Steam Rankine Combined Cycle

This study investigates the hybridization scenario of a single-flash geothermal power plant with a biomass-driven sCO2-steam Rankine combined cycle, where a solid local biomass source, olive residue, is used as a fuel. The hybrid power plant is modeled using the simulation software EBSILON®Professional. A topping sCO2 cycle is chosen due to its potential for flexible electricity generation. A synergy between the topping sCO2 and bottoming steam Rankine cycles is achieved by a good temperature match between the coupling heat exchanger, where the waste heat from the topping cycle is utilized in the bottoming cycle. The high-temperature heat addition problem, common in sCO2 cycles, is also eliminated by utilizing the heat in the flue gas in the bottoming cycle. Combined cycle thermal efficiency and a biomass-to-electricity conversion efficiency of 24.9% and 22.4% are achieved, respectively. The corresponding fuel consumption of the hybridized plant is found to be 2.2 kg/s.

Development and Analysis of the Novel Hybridization of a Single Flash Geothermal Power Plant with Biomass Driven sCO2-steam Rankine Combined Cycle

This study investigates the hybridization scenario of a single flash geothermal power plant with a biomass driven sCO2-steam Rankine combined cycle where a solid local biomass source, olive residue, is used as a fuel. The hybrid power plant is modeled using the simulation software EB-SILON®Professional. A topping sCO2 cycle is specifically chosen for its potential for flexible elec-tricity generation. A synergy between the topping sCO2 and bottoming steam Rankine cycles is achieved by a good temperature match between the coupling heat exchanger where the waste heat from the topping cycle is utilized in the bottoming cycle. The high temperature heat addition problem common sCO2 cycles is also eliminated by utilizing the heat in the flue gas in the bottoming cycle. Combined cycle thermal efficiency and biomass to electricity conversion efficiency of 24.9% and 22.4% are achieved, respectively. The corresponding fuel consumption of the hybridized plant is found as 2.2 kg/s.