ester yield
Recently Published Documents


TOTAL DOCUMENTS

38
(FIVE YEARS 14)

H-INDEX

7
(FIVE YEARS 2)

2021 ◽  
Vol 16 (3) ◽  
pp. 686-695
Author(s):  
Zeni Rahmawati ◽  
H. Holilah ◽  
Santi Wulan Purnami ◽  
Hasliza Bahruji ◽  
Titie Prapti Oetami ◽  
...  

Optimisation of biodiesel production from non-edible Reutealis Trisperma oil (RTO) was investigated using Taguchi method. Biodiesel was produced via consecutive esterification and transesterification reactions. Esterification of RTO was carried out using acid catalyst to decrease the amount of free fatty acid from 2.24% to 0.09%. Subsequent transesterification of the treated oil with methanol over a series of CaO-ZnO catalysts was optimized based on the L9 Taguchi orthogonal approach. The optimization parameters are Ca/Zn ratio (0.25, 0.5, and 1), methanol/oil ratio (10, 20, and 30) and reaction time (0.5, 1, and 2 h). CaO-ZnO catalysts at variation of Ca/Zn ratios were prepared using co-precipitation method and characterized using XRD, SEM, TEM, and FTIR analysis. The amount of methyl ester yield was used as the response parameter in the S/N ratio analysis and Analysis of Variance (ANOVA). The optimum parameter for RTO transesterification to biodiesel was determined at Ca/Zn ratio of 1, methanol oil ratio of 30 and reaction time for 2 h. Transesterification under these optimized parameter generated 98% of biodiesel yield, inferring the validity of the statistical approach. Furthermore, ANOVA analysis also confirmed that all the parameters were significantly contributed at approximately equal percentage towards the amount of biodiesel. Copyright © 2021 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0). 


Processes ◽  
2021 ◽  
Vol 9 (1) ◽  
pp. 181
Author(s):  
Ravisut Vitidsant ◽  
Satoshi Kodama ◽  
Hidetoshi Sekiguchi

Ultrasonic spraying was used in a three-phase reactor to produce small droplets of triolein mixed with CaO as a solid catalyst at temperatures above the boiling point of methanol for enhancement of the transesterification of triolein. Droplets fell in the methanol countercurrent flow and were collected at the bottom of the reactor, followed by circulation to the ultrasonic spray system. The experimental parameters included triolein flow rates of 2.5–9.0 mL/min, reaction temperatures of 70–100 °C, and catalyst contents of 1.0–7.0 wt%. The methanol feed rate was set to be constant. The results suggested that the enhancement was successful after using the three-phase reactor by generating a high contact surface area for the droplets, which was a key factor for determining the performance. Comparing the results with conventional transesterification in the liquid phase using the same CaO at 60 °C, the three-phase reactor produced a methyl ester yield 2–5% higher during the 60 min trial period. However, the yield became lower after 60 min because the mass transfer of methanol to the droplets was limited. The transesterification kinetics were estimated based on the experimental data—assuming a first-order reaction—and the results indicated a range of the rate constant, an apparent activation energy, and a pre-exponential factor of 1.21–3.70 × 10−2 min−1, 36.1 kJ mol−1, and 64.9 min−1, respectively, suggesting that the three-phase reactor was effective for fast transesterification at the initial stage.


BioResources ◽  
2021 ◽  
Vol 16 (1) ◽  
pp. 1469-1481
Author(s):  
Chuyang Tang ◽  
Lei Yang ◽  
Xianchun Li ◽  
Jinling Song

Pyrolysis experiments of cotton stalk (CS) and Shenmu coal (SM) were conducted in a tubular furnace. The pyrolysis temperature was 600 °C at 5 °C/min and sustained for 15 min. The water-soluble small molecule compounds (WSMC) were derived from the liquid products obtained during pyrolysis with the methods of toluene entrainment and ultrasonic extraction. The compositions of WSMC were further characterized by gas chromatography–mass spectrometry (GC-MS). The components of the syngas were analyzed by gas chromatography (GC). The results showed that the phenol yield was promoted by the interaction of CS and SM during co-pyrolysis. Moreover, the co-pyrolysis interaction blocked the radical reaction pathway that produces amides and accelerated the formation of pyridines. Because the ester yield increased, the esterification was clearly enhanced and the yield of carboxylic acids in WSMC was reduced during co-pyrolysis. In addition, the inhibition of furan generation resulted in an increased yield of C2–C4 hydrocarbons in the co-pyrolysis syngas. The maximal yields of C2–C4 hydrocarbons all occurred at a 20/100 ratio of CS/SM. Lastly, the formation mechanisms of small molecule compounds were proposed.


2020 ◽  
Vol 5 (2) ◽  
pp. 23-29
Author(s):  
Andi Suryanto ◽  
Ummu Kalsum ◽  
Lailatul Qadariya ◽  
Mahfud Mahfud

Methyl esters derived from coconut oil are very interesting to study because they contain free fatty acids with a medium carbon chain structure (C12-C14), so most methyl esters (70%) can be bio-kerosene and the rest can be biodiesel. The process of preparing methyl ester by reaction of Trans-esterification triglyceride generally using a homogeneous KOH catalyst but this process requires a long catalyst separation process through washing and drying process. The use of heterogeneous catalysts in the production of methyl esters can remove the washing and drying processes, but trans-esterification reactions with heterogeneous catalysts require severe conditions (high pressure and high temperature), whereas at low temperatures and atmospheric conditions, the methyl ester yield is relatively low. Using microwave-irradiated trans-esterification reactions with heterogeneous catalysts, it is expected to be much faster and can obtained higher yields. Therefore, in this study we prepare a heterogeneous catalyst K/Al2O3 using solution KOH that impregnated in catalyst support Al2O3, and catalyst obtained are caracterized by XRD, BET dan SEM. Our objective was to compare the yield of methyl esters obtained through the trans-esterification process of coconut oil assisted by microwave using a heterogeneous K / Al2O3 catalyst with yield obtained using a homogeneous KOH catalyst. Experimental equipment consists of a batch reactor placed in a microwave oven equipped with a condenser, agitator and temperature controller. The batch process was carried out at atmospheric pressure with variation of K/Al2O3 catalyst concentration (0.5, 1.0, 1.5, 2.0, 2.5%) and microwave power (100, 264 and 400 W). In general, the process of producing methyl esters by heterogeneous catalysts will get three layers, wherein the first layer is the product of methyl ester, the second layer is glycerol and the third layer is the catalyst. The experimental results show that the methyl ester yield increases with increasing of microwave power, catalyst concentration and reaction time. The results obtained with K /Al2O3 catalysts are generally slightly lower than those obtained using a homogeneous KOH catalyst. However, the yield of methyl esters obtained by the K / Al2O3 heterogeneous catalyst process are relatively easy to separate rather than using a homogeneous KOH catalyst.


2020 ◽  
Vol 2020 ◽  
pp. 1-13
Author(s):  
Sri Krishna Murthy ◽  
Ankit Goyal ◽  
N. Rajasekar ◽  
Kapil Pareek ◽  
Thoi Trung Nguyen ◽  
...  

The present study undertakes the research problem on the optimization of production of biodiesel as a renewable energy resource from the transesterification of soybean oil and ethanol. Predictive modelling and surface analysis techniques were applied based on the artificial neural network search algorithm to correlate the yield of ethyl ester and glycerol and the input parameters. The formulated models accurately predicted the yield of the products with a high coefficient of determination. When the reaction time is low, the ester yield decreases with an increase in temperature and the maximum yield of obtained biodiesel at a very low value of time of reaction and temperature. Plots based on parametric and sensitivity analysis reveals that the yield of ethyl ester can be maximized and that of glycerol minimized at an integrated condition with lower ethanol/oil molar ratio, higher temperature value, higher catalyst concentration value, and longer time of reaction. The global sensitivity analysis reveals that the catalyst concentration and temperature of the reaction influence the yield of ethyl ester the most. In addition, an optimal ethyl ester yield of 95% can be achieved at specific input conditions. Moreover, according to the results of global sensitivity analysis, the catalyst concentration is found to be most significant for both the glycerol and ethyl ester yield.


Fermentation ◽  
2020 ◽  
Vol 6 (2) ◽  
pp. 50
Author(s):  
Amparo Gamero ◽  
Annereinou Dijkstra ◽  
Bart Smit ◽  
Catrienus de Jong

Traditionally, Saccharomyces species are those used to conduct industrial alcoholic fermentations. Recently, an increasing interest has arisen with respect to the potential of so-called non-conventional yeasts to improve wine and beer aroma profiles, keeping the particular terroir of each region or for the development of craft beers. In this study, the potential of diverse non-conventional yeasts to improve aroma in winemaking and brewing was investigated, testing several pure and mixed culture combinations. In addition, a comparison between microscale and labscale was carried out in order to assess the value of microwine and microbeer as screening tools. The results indicated that non-Saccharomyces yeasts were good candidates to enhance or diversify aroma profiles in alcoholic beverages, especially regarding acetate ester yield and fruity aromas. However, mixed cultures with Saccharomyces spp. are normally required to achieve a successful fermentation. The adjustment of pithing ratios is crucial for this purpose. Microscale is presented as an effective and efficient screening tool to compare different culture combinations, although scaling-up will always be necessary in order to get results closer to real winemaking or brewing processes.


2020 ◽  
Author(s):  
Michelle van der Helm ◽  
Chang-Lin Wang ◽  
Mariano Macchione ◽  
Eduardo Mendes ◽  
Rienk Eelkema

<p>Signal transduction in living systems is the conversion of information into a chemical change and the principal process by which cells communicate. This process enables phenomena such as time-keeping and signal amplification. In nature, these functions are encoded in non-equilibrium (bio)chemical reaction networks (CRNs) controlled by enzymes. While these catalytically controlled processes are an integral part of biocatalytic pathways, man-made analogs are rare. Here, we incorporate catalysis in an artificial fuel driven out-of-equilibrium CRN. The study entails the design of an organocatalytically controlled fuel driven esterification CRN, where the forward (ester formation) and backward reaction (ester hydrolysis) are controlled by varying the ratio of two different organocatalysts: pyridine and imidazole. This catalytic regulation enables full control over ester yield and lifetime. The fuel-driven strategy is subsequently used in the design of a responsive polymer system, where transient polymer conformation and aggregation can be controlled through variation of fuel and catalysts levels. Altogether, we show how organocatalysis is an important tool to exert control over a man-made fuel driven system and induce a change in a macromolecular superstructure, as ubiquitously found in natural non-equilibrium systems. </p>


2020 ◽  
Author(s):  
Michelle van der Helm ◽  
Chang-Lin Wang ◽  
Mariano Macchione ◽  
Eduardo Mendes ◽  
Rienk Eelkema

<p>Signal transduction in living systems is the conversion of information into a chemical change and the principal process by which cells communicate. This process enables phenomena such as time-keeping and signal amplification. In nature, these functions are encoded in non-equilibrium (bio)chemical reaction networks (CRNs) controlled by enzymes. While these catalytically controlled processes are an integral part of biocatalytic pathways, man-made analogs are rare. Here, we incorporate catalysis in an artificial fuel driven out-of-equilibrium CRN. The study entails the design of an organocatalytically controlled fuel driven esterification CRN, where the forward (ester formation) and backward reaction (ester hydrolysis) are controlled by varying the ratio of two different organocatalysts: pyridine and imidazole. This catalytic regulation enables full control over ester yield and lifetime. The fuel-driven strategy is subsequently used in the design of a responsive polymer system, where transient polymer conformation and aggregation can be controlled through variation of fuel and catalysts levels. Altogether, we show how organocatalysis is an important tool to exert control over a man-made fuel driven system and induce a change in a macromolecular superstructure, as ubiquitously found in natural non-equilibrium systems. </p>


Sign in / Sign up

Export Citation Format

Share Document