local oscillator
Recently Published Documents


TOTAL DOCUMENTS

845
(FIVE YEARS 158)

H-INDEX

29
(FIVE YEARS 4)

Author(s):  
Hiroshi Ito ◽  
Norihiko Shibata ◽  
Tadao Nagatsuma ◽  
Tadao Ishibashi

Abstract We developed a novel terahertz-wave detector fabricated on a SiC platform implementing an InP/InGaAs Fermi-level managed barrier (FMB) diode. The FMB diode epi-layers were transferred on a SiC substrate, and a waveguide coupler and filters were monolithically integrated with an FMB diode. Then, fabricated detector chip was assembled in a fundamental mixer module with a WR-3 rectangular-waveguide input port. It exhibited a minimum noise equivalent power as low as 3e-19 W/Hz at around 300 GHz for a local oscillator power of only 30 microwatts.


Sensors ◽  
2021 ◽  
Vol 22 (1) ◽  
pp. 38
Author(s):  
Tomasz Kowalski ◽  
Gian Piero Gibiino ◽  
Jarosław Szewiński ◽  
Krzysztof Czuba ◽  
Dominik Rybka ◽  
...  

The low-level radio frequency (LLRF) control system is one of the fundamental parts of a particle accelerator, ensuring the stability of the electro-magnetic (EM) field inside the resonant cavities. It leverages on the precise measurement of the field by in-phase/quadrature (IQ) detection of an RF probe signal from the cavities, usually performed using analogue downconversion. This approach requires a local oscillator (LO) and is subject to hardware non-idealities like mixer nonlinearity and long-term temperature drifts. In this work, we experimentally evaluate IQ detection by direct sampling for the LLRF system of the Polish free electron laser (PolFEL) now under development at the National Centre for Nuclear Research (NCBJ) in Poland. We study the impact of the sampling scheme and of the clock phase noise for a 1.3-GHz input sub-sampled by a 400-MSa/s analogue-to-digital converter (ADC), estimating amplitude and phase stability below 0.01% and nearly 0.01°, respectively. The results are in line with state-of-the-art implementations, and demonstrate the feasibility of direct sampling for GHz-range LLRF systems.


2021 ◽  
Author(s):  
Qi Wu

Phase-retrieval (PR) schemes based on the modified Gerchberg-Saxton (GS) algorithm capture the full-field employing a dispersive element and intensity-only measurements to eliminate the use of a local oscillator. In this work, we propose two carrier-assisted PR schemes, namely central carrier-assisted PR (CCA-PR) and edge carrier-assisted PR (ECA-PR), to improve the comprehensive performance of PR receiver in terms of convergence speed, redundancy, and computational complexity. The proposed CCA-PR recovers the electrical field employing a reference carrier at 0 GHz with several iterations between two projection planes. It avoids pilot symbols and digital backpropagation to the transmitter and offers a flexible electrical bandwidth requirement compared with conventional PR schemes. To lower the carrier-to-signal power ratio (CSPR) requirement and enable faster convergence for the carrier-assisted PR schemes, the ECA-PR is proposed to obtain the initial phase for the GS algorithm. We numerically characterize the performance of the two schemes and experimentally demonstrate them for 30 GBaud 16-quadrature amplitude modulation (16-QAM) transmission over 80 km single-mode fiber with a bit error rate (BER) below the threshold of 7% hard-decision forward error correction (HD-FEC). Several critical parameters are analyzed, including the applied dispersion value, CSPR, and electrical bandwidth. Moreover, we compare the hardware complexity and optical signal-to-noise ratio (OSNR) sensitivity of proposed PR schemes with mainstream field recovery schemes.


2021 ◽  
Author(s):  
Qi Wu

Phase-retrieval (PR) schemes based on the modified Gerchberg-Saxton (GS) algorithm capture the full-field employing a dispersive element and intensity-only measurements to eliminate the use of a local oscillator. In this work, we propose two carrier-assisted PR schemes, namely central carrier-assisted PR (CCA-PR) and edge carrier-assisted PR (ECA-PR), to improve the comprehensive performance of PR receiver in terms of convergence speed, redundancy, and computational complexity. The proposed CCA-PR recovers the electrical field employing a reference carrier at 0 GHz with several iterations between two projection planes. It avoids pilot symbols and digital backpropagation to the transmitter and offers a flexible electrical bandwidth requirement compared with conventional PR schemes. To lower the carrier-to-signal power ratio (CSPR) requirement and enable faster convergence for the carrier-assisted PR schemes, the ECA-PR is proposed to obtain the initial phase for the GS algorithm. We numerically characterize the performance of the two schemes and experimentally demonstrate them for 30 GBaud 16-quadrature amplitude modulation (16-QAM) transmission over 80 km single-mode fiber with a bit error rate (BER) below the threshold of 7% hard-decision forward error correction (HD-FEC). Several critical parameters are analyzed, including the applied dispersion value, CSPR, and electrical bandwidth. Moreover, we compare the hardware complexity and optical signal-to-noise ratio (OSNR) sensitivity of proposed PR schemes with mainstream field recovery schemes.


2021 ◽  
Author(s):  
Lingzhi Kong ◽  
Weiqi Liu ◽  
Fan Jing ◽  
Chen He

Abstract When developing practical continuous-variable quantum key distribution (CVQKD), detector is necessary at the receiver’s side.We investigate the practical security of the CVQKD system with unbalanced heterodyne detector.The result shows that unbalanced heterodyne detector introduces extra excess noise into system and decreases the lower bound of secret key rate without awareness of the legitimate communicators, which leaves loopholes for Eve to attack the system. In addition, we find that the secret key rate decreases more severely with the increase of the degree of imbalance and the excess noise induced by the imbalance is proportional to the intensity of local oscillator (LO) under the same degree of imbalance. Finally, the countermeasure is proposed to resist this kind of effects.


2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Qibin Zheng ◽  
Yanpeng Jian ◽  
Lei Wang ◽  
Ziyue Ma ◽  
Xinyu Li ◽  
...  

The precision of local oscillator (LO) signal in in-phase and quadrature (IQ) demodulation strongly affects the imaging performance of millimeter wave (mmWave) radars. Therefore, to eliminate the requirement for high-precision LO, a simple yet effective digital IQ demodulation method has been proposed with the aid of a specified sampling scheme in order to eliminate the demand for LO. Based on the bandpass sampling theorem, the characteristic of the intermediate frequency signal of mmWave imaging indicates that the LO is unrequired if the sampling rate is twice of the frequency of the carrier of the intermediate signal. In this way, the in-phase signal would be directly and accurately obtained by performing the Binary-Phase-Shift-Keying (BPSK) modulation on the samples, based on which the IQ demodulation would be completed by using the Hilbert transform. The proposed method does not employ LO and thus simplifies the demodulation process and is suitable for implementation in a Field-Programmable Gate Array (FPGA) with fewer hardware resources. To verify the method, a three-dimensional mmWave radar imaging is carried out at the 30-34 GHz bandwidth, where the sampling and digital IQ demodulation are realized by an ADC (AD9250) and FPGA (XC7K325T), respectively. The results show a simplified transceiver with lower requirements and the prospect of the proposed method being applied in radar imaging and other related fields.


2021 ◽  
Vol 2103 (1) ◽  
pp. 012169
Author(s):  
R Goncharov ◽  
E Samsonov ◽  
A D Kiselev

Abstract The aim of the paper is to describe a well-known quantum key distribution GG02 protocol using multimode coherent states generated on subcarrier frequencies of the optical spectrum. In order to detect signal states, we use a method of coherent detection without the participation of a local oscillator directly but where power from a carrier wave is used as such. Within the framework of the modern GG02 protocol description and the secutity proof against collective attacks, we introduce the necessary amendments to reduce our model to a model of the common system.


Entropy ◽  
2021 ◽  
Vol 23 (11) ◽  
pp. 1395
Author(s):  
Yin Li ◽  
Yijun Wang ◽  
Yun Mao ◽  
Weishao Peng ◽  
Di Jin ◽  
...  

An improved continuous variable quantum key distribution (CVQKD) approach based on a heralded hybrid linear amplifier (HLA) is proposed in this study, which includes an ideal deterministic linear amplifier and a probabilistic noiseless linear amplifier. The CVQKD, which is based on an amplifier, enhances the signal-to-noise ratio and provides for fine control between high gain and strong noise reduction. We focus on the impact of two types of optical amplifiers on system performance: phase sensitive amplifiers (PSA) and phase insensitive amplifiers (PIA). The results indicate that employing amplifiers, local local oscillation-based CVQKD systems can enhance key rates and communication distances. In addition, the PIA-based CVQKD system has a broader application than the PSA-based system.


Author(s):  
Alin Jderu ◽  
Marcelo A. Soto ◽  
Marius Enachescu ◽  
Dominik Ziegler

AbstractWe report on the development and implementation of an optical frequency-domain reflectometer (OFDR) sensing platform. OFDR allows to measure changes in strain and temperature using optical fibers with a length of several tens of meters with very high spatial resolution. We discuss the operation principles and challenges to implement an OFDR system using optical homodyne detection based on a dual-polarization 90° optical hybrid. Our setup exhibits polarization and phase diversity, fully automated data acquisition and data processing using a LabVIEW-based implemented software environment. Using an optical hybrid enables to discriminate phase, amplitude and polarization by interfering the Rayleigh scatter signal and a local oscillator with four 90° phase stepped interferences between the two signals. Without averaging and a fast acquisition time of 230 ms, our preliminary results show a spatial resolution of 5 cm and a temperature resolution of about 0.1 Kelvin on a 3 m-long fiber.


Sign in / Sign up

Export Citation Format

Share Document