Effects of lubricant-fuel mixing on particle emissions in a single cylinder direct injection spark ignition engine

Gasoline direct injection (GDI) engines emit less carbon dioxide (CO2) than port fuel injection (PFI) engines when fossil fuel conditions are the same. However, GDI engines emit more ultrafine particulate matter, which can have negative health effects, leading to particulate emission regulations. To satisfy these regulations, various studies have been done to reduce particulate matter, and several studies focused on lubricants. This study focuses on the influence of lubricant on the formation of particulate matter and its effect on particulate emissions in GDI engines. An instrumented, combustion and optical singe-cylinder GDI engine fueled by four different lubricant-gasoline blends was used with various injection conditions. Combustion experiments were used to determine combustion characteristics, and gaseous emissions indicated that the lubricant did not influence mixture homogeneity but had an impact on unburned fuels. Optical experiments showed that the lubricant did not influence spray but did influence wall film formation during the injection period, which is a major factor affecting particulate matter generation. Particulate emissions indicated that lubricant included in the wall film significantly affected PN emissions depending on injection conditions. Additionally, the wall film influenced by the lubricant affected the overall particle size and its distribution.

Catalytic Materials for Gasoline Particulate Filters Soot Oxidation

The energy efficiency of Gasoline Direct Injection (GDI) engines is leading to a continuous increase in GDI engine vehicle population. Consequently, their particulate matter (soot) emissions are also becoming a matter of concern. As required for diesel engines, to meet the limits set by regulations, catalyzed particulate filters are considered as an effective solution through which soot could be trapped and burnt out. However, in contrast to diesel application, the regeneration of gasoline particulate filters (GPF) is critical, as it occurs with almost an absence of NOx and under oxygen deficiency. Therefore, in the recent years it was of scientific interest to develop efficient soot oxidation catalysts that fit such particular gasoline operating conditions. Among them ceria- and perovskite-based formulations are emerging as the most promising materials. This overview summarizes the very recent academic contributions focusing on soot oxidation materials for GDI, in order to point out the most promising directions in this research area.

Research of EGR On Commercial Turbocharged GDI Engine with Intense Tumble Flow

The application of exhaust gas recirculation (EGR) technology on GDI engines can suppress knocking, reduce fuel consumption, and reduce NOx emissions. The effects of EGR with enhanced intake tumble flow, on the combustion phase, combustion duration, knock index and combustion cycle variation of the engine, were studied at two speeds of 1500 r/min and 2000 r/min from low to medium and to full load. The research shows that although the commercial engine has been well calibrated and optimized, the optimization of EGR and enhanced tumble flow together with the optimization of the ignition angle can improve the engine's economy and emission characteristics, while maintaining relatively fast burning speed and low combustion cycle variation. From medium to heavy load, the economy can be improved by 2.6~10%, and the minimum fuel consumption can be reduced to 213 g/kW.h. Under heavy load conditions (BMEP more than 14 bars), power performance deteriorates due to insufficient boost performance. The 5~20% EGR rate brings 10% power loss. EGR combined with tumble intake has a significant effect on reducing the engine's NOx and CO, with average reductions of 60% and 22%, but HC increased by 32%.