differential pulse
Recently Published Documents


TOTAL DOCUMENTS

3062
(FIVE YEARS 510)

H-INDEX

68
(FIVE YEARS 10)

Author(s):  
Jéssica Santos Gomes ◽  
Érica Abadia Da Costa ◽  
Rodrigo A. A. Munoz ◽  
Alberto De Oliveira ◽  
Raquel M. F. Sousa

Abstract Most electrochemical sensors reported for catechin determination in herbal medicines actually involve the detection of not only catechins but also other flavonoids. This work proposes a strategy to selectively detect and quantify flavan-3-ol, known as catechins, in the presence of other flavonoids by complexation with AlCl3. Flavonoids (e.g.,rutin, quercetin) form stable complex with AlCl3 which affect the electrooxidation of these molecules. Hence, the electrochemical oxidation of catechin is free from the interference of other flavonoids as shown by differential-pulse voltammetry using glassy-carbon electrode. The approach was applied to herbal medicines and mass-spectrometry confirmed the presence of catechins in such samples.


Author(s):  
Olha Dushna ◽  
Liliya Dubenska ◽  
Serhiy Plotycya ◽  
Mariana Rydchuk ◽  
Mykola Blazheyevskіy

Abstract In the present paper, for the first time, the electrochemical behaviour of nicotine metabolite nicotine N-oxide (NNO) on static mercury dropping electrode (SMDE) and mercury meniscus modified silver solid amalgam electrode (m-AgSAE) has been reported. Nicotine N-oxide is reduced forming one peak at the potential -0.78 V on SDME and -0.86 V on m-AgSAE in Britton-Robinson buffer medium at pH 4.5 using cyclic voltammetry (CV). One electron and one proton take part in the reaction of NNO reduction. Calibration graphs for NNO determination using linear sweep voltammetry (LSV) on SDME and square-wave voltammetry (SWV) and differential pulse voltammetry (DPV) on m-AgSAE were obtained. Limit of detection (LOD) is 0.13 μM on SDME, and 0.16 μM (SWV) and 0.29 μM (DPV) on m-AgSAE. Since NNO can be used as an analytical form for nicotine voltammetric determination, so the developed methods were applied for the analysis of pharmaceutical preparations, and the recoveries from 97.3 to 104.6 % were achieved. Also, the elaborated methods were used in the analysis of biological fluids, and tobacco products. The obtained results were compared to those indicated in the certificates of drugs analysis, and to the results, obtained by reference methods (HPLC and GC).


2022 ◽  
Vol 12 (2) ◽  
pp. 699
Author(s):  
Danyelle Medeiros de Araújo ◽  
Elisama V. Dos Santos ◽  
Carlos A. Martínez-Huitle ◽  
Achille De Battisti

Hydroxychloroquine (HCQ) has been extensively consumed due to the Coronavirus (COVID-19) pandemic. Therefore, it is increasingly found in different water matrices. For this reason, the concentration of HCQ in water should be monitored and the treatment of contaminated water matrices with HCQ is a key issue to overcome immediately. Thus, in this study, the development of technologies and smart water solutions to reach the Sustainable Development Goal 6 (SDG6) is the main objective. To do that, the integration of electrochemical technologies for their environmental application on HCQ detection, quantification and degradation was performed. Firstly, an electrochemical cork-graphite sensor was prepared to identify/quantify HCQ in river water matrices by differential pulse voltammetric (DPV) method. Subsequently, an HCQ-polluted river water sample was electrochemically treated with BDD electrode by applying 15, 30 and 45 mA cm−2. The HCQ decay and organic matter removal was monitored by DPV with composite sensor and chemical oxygen demand (COD) measurements, respectively. Results clearly confirmed that, on the one hand, the cork-graphite sensor exhibited good current response to quantify of HCQ in the river water matrix, with limit of detection and quantification of 1.46 mg L−1 (≈3.36 µM) and 4.42 mg L−1 (≈10.19 µM), respectively. On the other hand, the electrochemical oxidation (EO) efficiently removed HCQ from real river water sample using BDD electrodes. Complete HCQ removal was achieved at all applied current densities; whereas in terms of COD, significant removals (68%, 71% and 84% at 15, 30 and 45 mA cm−2, respectively) were achieved. Based on the achieved results, the offline integration of electrochemical SDG6 technologies in order to monitor and remove HCQ is an efficient and effective strategy.


Micromachines ◽  
2022 ◽  
Vol 13 (1) ◽  
pp. 88
Author(s):  
Mahboobeh Shahsavari ◽  
Mojtaba Mortazavi ◽  
Somayeh Tajik ◽  
Iran Sheikhshoaie ◽  
Hadi Beitollahi

In this study, we prepared graphene oxide (GO)/ZIF-67 nanocomposites. Therefore, GO/ZIF-67 nanocomposites were used as a modifier on a screen-printed electrode (GO/ZIF-67/SPE) for studying the electrochemical behavior of epinine in phosphate buffer saline (PBS) at pH 7.0 with voltammetry techniques. The GO/ZIF-67/SPE showed greater electrocatalytic activities than the bare SPE. As a result, the GO/ZIF-67/SPE was utilized for additional electrochemical examinations. The epinine concentration determination was in the range 9.0 × 10−8 M to 5.0 × 10−4 M, and the limit of detection (LOD) as well as the limit of quantification (LOQ) equaled 2.0 and 6.6 nM, respectively. From the scan rate study, the oxidation of epinine was found to be diffusion-controlled, and the simultaneous detection of epinine and dobutamine were well achieved with the differential pulse voltammetric (DPV) technique. Moreover, the stability and reproducibility of epinine at the GO/ZIF-67/SPE was studied, and the use of the GO/ZIF-67/SPE to detect epinine and dobutamine in real samples was furthermore successfully demonstrated.


2022 ◽  
Vol 905 ◽  
pp. 204-209
Author(s):  
Nan Dong ◽  
Ke Cao ◽  
Chen Xi Si ◽  
Dan Zheng

In this work, core–shell structured nanocomposites consisting of Pd doped Ag@C were synthesized by impregnation–reduction method. Then, sensing electrodes were fabricated by modifying Pd/Ag@C core-shell nanoparticles on screen-printed electrodes (SPE) for electrochemical determination of bisphenol A (BPA). The composition and morphology of nanocomposites were characterized by scanning electron microscopy, transmission electron microscopy, X ray diffraction and energy-dispersive X-ray spectroscopy. The electrochemical response characteristics of nanocomposites to BPA was investigated by cyclic voltammetry (CV) and differential pulse voltammetry (DPV). The results indicated that, compared with Ag@C and Pd/C, Pd/Ag@C nanocomposite shows greater catalytic activity to the oxidation of BPA due to the synergistic effect of Pd and Ag. Among the four synthesized Pd/Ag@C-x (x=1-4) nanomaterials, the Pd/Ag@C-3 exhibits the best sensing performance toward the sensitive detection of BPA. The linear range for BPA determination was from 8.0×10-8 M to 1.5×10-5M with a detection limit of 1.0×10-8 M. A less than 9% oxidation peak current change was observed on the determination of BPA using Pd/Ag@C-3/SPE when added different interfering species into the BPA solution. The oxidation peak current attenuation of BPA on Pd/Ag@C-3/SPE within five weeks was found to be less than 3.6%.


The Analyst ◽  
2022 ◽  
Author(s):  
Siwei Shi ◽  
Haoxi Wu ◽  
Ling Zhang ◽  
pengfei Xiong ◽  
Denglei Chen ◽  
...  

A procedure for electroanalytical determination of the uranyl ions pre-concentrated from natural water by cloud point extraction (CPE) was developed in this work. The CPE parameters, such as surfactant concentration,...


Sensors ◽  
2021 ◽  
Vol 22 (1) ◽  
pp. 269
Author(s):  
Biresaw D. Abera ◽  
Inmaculada Ortiz-Gómez ◽  
Bajramshahe Shkodra ◽  
Francisco J. Romero ◽  
Giuseppe Cantarella ◽  
...  

Tetracycline (TC) is a widely known antibiotic used worldwide to ‘’treat animals. Its residues in animal-origin foods cause adverse health effects to consumers. Low-cost and real-time measuring systems of TC in food samples are, therefore, extremely needed. In this work, a three-electrode sensitive and label-free sensor was developed to detect TC residues from milk and meat extract samples, using CO2 laser-induced graphene (LIG) electrodes modified with gold nanoparticles (AuNPs) and a molecularly imprinted polymer (MIP) used as a synthetic biorecognition element. LIG was patterned on a polyimide (PI) substrate, reaching a minimum sheet resistance (Rsh) of 17.27 ± 1.04 Ω/sq. The o-phenylenediamine (oPD) monomer and TC template were electropolymerized on the surface of the LIG working electrode to form the MIP. Surface morphology and electrochemical techniques were used to characterize the formation of LIG and to confirm each modification step. The sensitivity of the sensor was evaluated by differential pulse voltammetry (DPV), leading to a limit of detection (LOD) of 0.32 nM, 0.85 nM, and 0.80 nM in buffer, milk, and meat extract samples, respectively, with a working range of 5 nM to 500 nM and a linear response range between 10 nM to 300 nM. The sensor showed good LOD (0.32 nM), reproducibility, and stability, and it can be used as an alternative system to detect TC from animal-origin food products.


2021 ◽  
Vol 3 (2) ◽  
pp. 297-314
Author(s):  
Ketan Patil ◽  
Astha Pandey

New Psychoactive Substances (NPS) are synthetic drugs that create similar effects as various narcotic drugs and psychotropic substances. Different NPS such as mephedrone, synthacaine, synthetic cannabinoids, etc. are available today which are sold across numerous platforms like drug markets, head shops, the dark web, etc. They are emerging rapidly and becoming popular in society because of their variable nature and ease in avoiding breaking the law. Consequently, their analysis is extremely crucial in the prohibition of drug abuse and the development of laboratory methods. This review introduces a broad overview of the analysis of various new psychoactive substances by voltammetric techniques such as cyclic voltammetry, differential pulse voltammetry, square wave voltammetry, stripping voltammetry etc. It also focuses on various methodologies that were developed for the detection of these NPS which play a leading role in forensic investigation by providing a rapid, sensitive, and cost-effective platform of analysis. The need for the advancement of various detection methods and analysis of more drugs is additionally discussed.


2021 ◽  
Author(s):  
Manikanta P ◽  
Hari Prasad B R ◽  
Sanjay B P ◽  
Sandeep S ◽  
Santhosh A S ◽  
...  

Abstract The work demonstrates the development of an electrochemical sensor for quantification of Chloramphenicol (CA) using pencil graphite electrode (PGE) modified with Gadolinium tungstate nano flakes and carbon nano fibers composite (PGE/GWNfs/CNFs). The composite was further characterized and confirmed by X-ray diffraction (XRD), energy-dispersive X-ray spectroscopy (EDS), Transmission electron microscopy (TEM) analysis. The prepared GWNfs/CNFs nano composite was fabricated by drop casting method to get PGE/GWNfs/CNFs working electrode. The modified electrode is then analyzed by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and differential pulse voltammetry (DPV) methods for its electrochemical and electrocatalytic property. The electrochemical investigation of developed sensor shows enhanced activity towards electro-oxidation of CA. The DPV studies revealed high efficacy characteristics such as sensitivity in the range 0.03984 µA µM-1cm-2, selectivity, good linear range (5-50 μM), and low detection limit (0.4 μM). The study benchmarks the use of GWNfs/CNFs as an excellent transducer material in electrochemical sensing of CA in standard samples thus, it finds an efficient potential application in the analysis of CA in environment sample analysis.


Catalysts ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 1561
Author(s):  
Kadir Selçuk ◽  
Hilal Kivrak ◽  
Nahit Aktaş

In this study, novel carbon nanotube-supported Mo (Mo/CNT) catalysts were prepared with the sodium borohydride reduction method for the detection of L-cysteine (L-Cys, L-C). Mo/CNT catalysts were characterized with scanning electron microscopy with elemental dispersion X-ray (EDX-SEM), X-ray diffraction (XRD), UV-vis diffuse reflectance spectrometry (UV-vis), temperature-programmed reduction (TPR), temperature programmed oxidation (TPO), and temperature-programmed desorption (TPD) techniques. The results of these advanced surface characterization techniques revealed that the catalysts were prepared successfully. Electrochemical measurements were employed to construct a voltammetric L-C sensor based on Mo/CNT catalyst by voltammetric techniques such as cyclic voltammetry (CV) and differential pulse voltammetry (DPV). Further measurements were carried out with electrochemical impedance spectroscopy (EIS). Mo/CNT/GCE exhibited excellent performance for L-C detection with a linear response in the range of 0–150 µM, with a current sensitivity of 200 mA/μM cm2 (0.0142 μA/μM), the lowest detection limit of 0.25 μM, and signal-to-noise ratio (S/N = 3). Interference studies showed that the Mo/CNT/GCE electrode was not affected by D-glucose, uric acid, L-tyrosine, and L-trytophane, commonly interfering organic structures. Natural sample analysis was also accomplished with acetyl L-C. Mo/CNT catalyst is a promising material as a sensor for L-C detection.


Sign in / Sign up

Export Citation Format

Share Document