Arthroscopic Management of Transchondral Talar-Dome Fractures (Osteochondritis Dissecans) and Anterior Impingement Lesions of the Ankle Joint

1991 ◽  
Vol 10 (3) ◽  
pp. 677-687 ◽  
Author(s):  
J. Whit Ewing
2016 ◽  
Vol 32 (7) ◽  
pp. 1367-1374 ◽  
Author(s):  
Alexej Barg ◽  
Charles L. Saltzman ◽  
Timothy C. Beals ◽  
Kent N. Bachus ◽  
Brad D. Blankenhorn ◽  
...  

2021 ◽  
pp. 661-668
Author(s):  
Myrthe Nagel ◽  
Rens Bexkens ◽  
Bertram The ◽  
Denise Eygendaal

2017 ◽  
Vol 2 (3) ◽  
pp. 2473011417S0003
Author(s):  
Christian Plaass ◽  
Leif Claassen ◽  
Christina Stukenborg-Colsman ◽  
Daiwei Yao ◽  
Kiriakos Daniilidis ◽  
...  

Category: Ankle Introduction/Purpose: Understanding the morphometry of the ankle joint is crucial to improve total ankle replacement (TAR). Despite improvements of the implant material TAR did not reach comparable success rates to total hip or knee arthroplasty. Recent studies queried whether current designs match with the articular geometry. The present study was performed to evaluate the ankle morphometry and thereby gain information about the joint axis. Methods: We analyzed 96 high-resolution CT-scans of complete caucasian cadaver legs. Using the software Mimics and 3-Matic (Materialize) 22 anatomic parameters of the talocrural joint were assessed, including the length, width and surface area of the tibial and talar bearing areas. Additionally the radii of the bearing areas, the medial distal tibial angle and the height of the talar dome were determined. Therefore we analyzed defined sagittal, axial and frontal planes. Results: The radius of the central trochlea tali was 44.6 ± 4.1 mm (mean ± SD). The central trochlea tali arc length was 40.8 ± 3.0 mm and its width was 27.4 ± 2.5 mm. Additionally we determined 47.0 ± 4.4 mm for the tibial sagittal radius, 27.6 ± 3.0 mm for the tibial arc length and 27.4 ± 2.5 mm for the central tibial width. Conclusion: The present study describes the three-dimensional morphometry of the caucasian ankle joint. Our results might be considered for the development of total ankle replacements.


2019 ◽  
Vol 40 (8) ◽  
pp. 978-986 ◽  
Author(s):  
Lena Hirtler ◽  
Katarina Schellander ◽  
Reinhard Schuh

Background: Osteochondral lesions of the talus are frequent pathologies of the ankle joint. Especially through arthroscopy, the treatment is kept as minimally invasive as possible. However, there are some drawbacks as to the reachability because of the high congruency of the ankle joint. Here, either noninvasive distraction or maximal dorsiflexion may be an option for better access to the lesion. The purpose of this study was to evaluate maximal dorsiflexion compared to neutral position or noninvasive distraction of the ankle joint in the arthroscopic reachability of the talar dome. The hypothesis of this study was that maximal dorsiflexion would allow for greater accessibility of the talar dome compared to neutral position or noninvasive distraction of the joint. Methods: Twenty matched pairs (n=40) of anatomical ankle specimens were used. The effects of neutral position, maximal dorsiflexion, and noninvasive distraction of the ankle joint on arthroscopic accessibility of the ankle joint were tested. After disarticulation of the talus, reach was measured and compared between the 3 positions. Results: In neutral position, 13.7±1.2 mm of the talar dome was reached laterally and 14.0±1.0 mm medially. In maximal dorsiflexion, the distance was 19.0±1.1mm laterally and 19.8±1.4 mm medially, and in noninvasive distraction it was 16.1±1.5 mm laterally and 15.7±1.0 mm medially. The statistical comparison showed a significantly better reach in dorsiflexion laterally ( P = .003) and medially ( P = .026). Conclusion: Accessibility of the talar dome in maximal dorsiflexion was superior to that in neutral position or noninvasive distraction. Clinical Relevance: Results of this study may allow for better planning in arthroscopic treatment of osteochondral lesions of the talus.


2020 ◽  
Vol 5 (4) ◽  
pp. 2473011420S0048
Author(s):  
Francesca E. Wade ◽  
Gregory Lewis ◽  
Andrea H. Horne ◽  
Lauren Hickox ◽  
Michael C. Aynardi ◽  
...  

Category: Ankle; Ankle Arthritis Introduction/Purpose: Deficits in ankle joint kinetics following total ankle arthroplasty (TAA) may be attributed to a reduction in the force-generating capacity of ankle joint muscles, but it is also important to consider the alterations to joint structure that may accompany this procedure. One key parameter indicative of joint structure with the potential to be influenced by TAA is the plantarflexion moment arm of the Achilles tendon (ATma). ATma is an indicator of the potential for the tendon force to produce plantarflexion moment that is determined by the three-dimensional line of action of the tendon relative to the ankle joint axis. The purpose of this study was to assess pre-to-post TAA changes in ATma; we hypothesized that pre- and post-TAA moment arms would not be different. Methods: We tested 10 TAA patients (age at surgery: 62.86 +- 9.72 y; height: 1.72 +- 0.08 m; body mass: 97.81 +- 20.89 kg) at pre-operative (˜ 1 mo pre) and post-operative (˜6 mo post) visits. All procedures involving testing of human subjects were approved by the Penn State Hershey Medical Center Institutional Review Board. ATma were measured using a method that combined ultrasound imaging of the tendon with 3D motion tracking of both the ultrasound probe and the ankle joint. The tendon and joint axis were located during trials in which the patients were seated with the knee extended while the ankle joint was voluntarily rotated in the sagittal plane. We also examined sagittal-plane weightbearing radiographs (pre- and post-op) to determine the AP distance from the center of the talar dome to the posterior margin of the calcaneus. Pre- and post-op ATma were compared using a paired t-test and regression. Results: No significant mean differences were found between post-op ATma and pre-op ATma (p = 0.360). Despite this, some patients were found to have large differences between pre- and postoperative ATma. For example, participants 1, 3, and 8 exhibited changes of -54.22%, +64.14% and +123.98% (pre-to-post) respectively (Figure 1). A moderate correlation between pre- and post-op ATma was found (r2 = 0.461, p = 0.031), indicating that only 46.1% of the variance in post-op ATma was explained by pre-op ATma (Figure 1). The normalized AP distance measured from the radiographs did not significantly change on average pre- to post-TAA (p = 0.561), and we found the change in this distance to correlate with the change in ATma (r2 = 0.370, p = 0.062). Conclusion: This is the first investigation of whether TAA alters ATma. Our results supported our hypothesis that pre-operative ATma predicts post-operative ATma. However, our hypothesis is supported only when the mean differences are considered, as there were sizeable differences for individuals. Despite a non-significant average change in ATma following TAA, at the individual level substantial changes in ATma were observed in seven of the 10 patients. Change in ATma was only partly explained by change in the AP position of the talar dome. Change in ATma has potential consequences for function in terms of ankle plantarflexor strength and walking velocity.


2011 ◽  
Vol 39 (11) ◽  
pp. 2457-2465 ◽  
Author(s):  
Ashraf M. Fansa ◽  
Christopher D. Murawski ◽  
Carl W. Imhauser ◽  
Joseph T. Nguyen ◽  
John G. Kennedy

Background: Autologous osteochondral transplantation procedures provide hyaline cartilage to the site of cartilage repair. It remains unknown whether these procedures restore native contact mechanics of the ankle joint. Purpose: This study was undertaken to characterize the regional and local contact mechanics after autologous osteochondral transplantation of the talus. Study Design: Controlled laboratory study. Methods: Ten fresh-frozen cadaveric lower limb specimens were used for this study. Specimens were loaded using a 6 degrees of freedom robotic arm with 4.5 N·m of inversion and a 300-N axial compressive load in a neutral plantar/dorsiflexion. An osteochondral defect was created at the centromedial aspect of the talar dome and an autologous osteochondral graft from the ipsilateral knee was subsequently transplanted to the defect site. Regional contact mechanics were analyzed across the talar dome as a function of the defect and repair conditions and compared with those in the intact ankle. Local contact mechanics at the peripheral rim of the defect and at the graft site were also analyzed and compared with the intact condition. A 3-dimensional laser scanning system was used to determine the graft height differences relative to the native talus. Results: The creation of an osteochondral defect caused a significant decrease in force, mean pressure, and peak pressure on the medial region of the talus ( P = .037). Implanting an osteochondral graft restored the force, mean pressure, and peak pressure on the medial region of the talus to intact levels ( P = .05). The anterior portion of the graft carried less force, while mean and peak pressures were decreased relative to intact ( P = .05). The mean difference in graft height relative to the surrounding host cartilage for the overall population was −0.2 ± 0.3 mm (range, −1.00 to 0.40 mm). Under these conditions, there was no correlation between height and pressure when the graft was sunken, flush, or proud. Conclusion/Clinical Relevance: Placement of the osteochondral graft in the most congruent position possible partially restored contact mechanics of the ankle joint. Persistent deficits in contact mechanics may be due to additional factors besides graft congruence, including structural differences in the donor cartilage when compared with the native tissue.


Sign in / Sign up

Export Citation Format

Share Document