scholarly journals Dynamic oxidation mechanism of carbon fiber reinforced SiC matrix composite in high-enthalpy and high-speed plasmas

2022 ◽  
Vol 11 (2) ◽  
pp. 365-377
Author(s):  
Lingwei Yang ◽  
Xueren Xiao ◽  
Liping Liu ◽  
Jie Luo ◽  
Kai Jiang ◽  
...  

AbstractThis work employed an inductively coupled plasma wind tunnel to study the dynamic oxidation mechanisms of carbon fiber reinforced SiC matrix composite (Cf/SiC) in high-enthalpy and high-speed plasmas. The results highlighted a transition of passive/active oxidations of SiC at 800–1600 °C and 1–5 kPa. Specially, the active oxidation led to the corrosion of the SiC coating and interruption of the SiO2 growth. The transition borders of active/passive oxidations were thus defined with respect to oxidation temperature and partial pressure of atomic O in the high-enthalpy and high-speed plasmas. In the transition and passive domains, the SiC dissipation was negligible. By multiple dynamic oxidations of Cf/SiC in the domains, the SiO2 thickness was not monotonously increased due to the competing mechanisms of passive oxidation of SiC and dissipation of SiO2. In addition, the mechanical properties of the SiC coating/matrix and the Cf/SiC were maintained after long-term dynamic oxidations, which suggested an excellent thermal stability of Cf/SiC serving in thermal protection systems (TPSs) of reusable hypersonic vehicles.

Author(s):  
Shunichi Kubo ◽  
Hiroshi Tsuchiya

The metal-impregnated carbon fiber-reinforced carbon composite (C/C composite) is expected to be a candidate material for pantograph contact strips of high-speed electric railway vehicles, because its mechanical strength for flexure and impact is much higher than that of the conventional metal-impregnated carbon. The authors have investigated the wear properties of copper-titanium-alloy impregnated C/C composite sliding against a copper disk under an electric current and frequent arc discharges. The tested C/C composite was prepared by press molding and baking of laminated carbon fiber woven sheets. There exists anisotropy in the physical properties originated from the orientation of carbon fiber woven sheets lamination. The C/C composite was slid in two directions, in parallel with or perpendicular to the sheet layer. The test results show that the wear rate in sliding in the parallel direction exceeds that in the perpendicular direction, especially in the cases where the material is subjected to higher current density and more frequent arc discharges.


2019 ◽  
Vol 9 (6) ◽  
pp. 648-652
Author(s):  
Xu Zhang ◽  
Xueping Gan ◽  
Yichun Liu ◽  
Ming Xie ◽  
Jianhong Yi

Fe–Ni alloys with low thermal expansion coefficients were deposited on carbon fiber reinforced carbon matrix composite (C/C composite) as metallization coatings via ultrasound-assisted electrodeposition. The interface was compact at the micrometer scale, and the micro-cracks and pores on the composite surface were fully filled with the deposited alloy. The interface shear strength reached 16.24 MPa, which was a significant improvement in comparison with that of the conventional electrodeposition. These results may have been due to the residual stress reduction, the joining area increasement, and the pinning effect enhancement.


Sign in / Sign up

Export Citation Format

Share Document