scholarly journals Extended Flexor Carpi Radialis Approach

2021 ◽  
Vol 35 (3) ◽  
pp. s1-s5
Author(s):  
Allicia O. Imada ◽  
Solomon F. Oloyede ◽  
Deana Mercer
2018 ◽  
Vol 47 (10) ◽  
pp. 1449-1453 ◽  
Author(s):  
Michalis Michaelides ◽  
Elena Drakonaki ◽  
Elia Petridou ◽  
Maria Pantziara ◽  
Cleanthis Ioannides

2016 ◽  
Vol 110 ◽  
pp. 37-42 ◽  
Author(s):  
Shinji Kobayashi ◽  
Masahiro Hayashi ◽  
Katsuhiro Shinozaki ◽  
Mitsuhiro Nito ◽  
Wataru Hashizume ◽  
...  

1986 ◽  
Vol 56 (2) ◽  
pp. 494-506 ◽  
Author(s):  
B. R. Botterman ◽  
G. A. Iwamoto ◽  
W. J. Gonyea

Single motor units of the flexor carpi radialis (FCR) muscle were activated with a series of constant-rate stimulus trains to study the relation between the frequency of activation and isometric tension development (F-T relation). The tension produced by each stimulus train was expressed as a percentage of the maximum tension-time area (Amax) found for a given unit. Between 25 and 75% Amax a clear separation was seen in the rates needed to produce the same relative tension for the F-T curves of slow-twitch (type S) and fast-twitch (type F) units. Over the steepest portion of the F-T curve (25-50% Amax), where tension output was most sensitive to changes in activation rate, type F units required substantially higher stimulation rates (30 pps) to achieve the same relative tension output as type S units. Furthermore, the frequency range that corresponded to the steep portion of the curve was 2.3 times greater for type F units. For both type S and F units, twitch duration was deemed to be an important determinant of the F-T curve, as has been shown previously. A direct continuous relation was seen between the integrated twitch time (ITT) and the stimulus interval needed to produce 50% Amax (r = 0.94, P less than 0.001). Thus, units that had relatively brief twitches required higher activation rates to achieve the same relative percentage of Amax. Comparison of F-T curves from FCR with those derived by other investigators for cat hindlimb units (medial gastrocnemius and peroneus longus) revealed that significant differences in activation rates were needed to produce the same percentage of Amax throughout the midrange of the F-T curve. At 50% Amax, type F units in FCR required activation rates approximately 20 pps higher than type F units in the hindlimb. Type S units in FCR required only slightly higher rates (approximately equal to 5 pps). Based on a number of well-founded assumptions, F-T curves derived from FCR units were used to estimate the potential contribution of rate coding to total muscle tension by type S and F units. This analysis leads to the conclusion that rate modulation is a potentially important factor in the gradation of tension for the FCR muscle.


2007 ◽  
Vol 104 (1) ◽  
pp. 287-297
Author(s):  
J. Greig Inglis ◽  
Anita D. Christie ◽  
David A. Gabriel

Sign in / Sign up

Export Citation Format

Share Document