Study of Heat Transfer Characteristics in a Wall-Bounded Plane-Jet Using Large-Eddy Simulation

Author(s):  
P. Kakka ◽  
K. Anupindi
Author(s):  
Z. Li ◽  
L. Khezzar ◽  
N. Kharoua

This study is devoted to a forced turbulent plane jet emerging from a slot rectangular nozzle impinging on a semi-cylindrical surface using large eddy simulation. Both forced and unforced cases are considered. The Reynolds number, based on the slot velocity and width, was 5600. The LES simulations were validated using published experimental results and contrasted against RANS models. The study is performed for a slot-to-surface distance equal to twice the nozzle width and considers two forcing frequencies equal to 400 and 800 Hz. The jet was excited using a sinusoidal inlet velocity profile at several harmonics of the preferred mode and the flow and heat transfer characteristics were analyzed. The phase averaged Nusselt number exhibited several peaks along the semi-circular target plane. Increases above the steady unforced jet values of heat transfer rates were obtained in the stagnation region and decreases were observed in the wall jet region. The fluctuations in the phase averaged surface Nusselt number are explained in terms of the interaction of organized shear layer structures with induced target wall structures.


Author(s):  
Sung-Eun Kim ◽  
Hajime Nakamura

Large eddy simulation has been carried out of turbulent flow and heat transfer around a circular cylinder in crossflow at three subcritical Reynolds numbers (Re = 3,900, 10,000, 18,900) where the flow and heat transfer characteristics change rapidly with the Reynolds number. The computations were carried out using a second-order-accurate finite-volume Navier-Stokes solver that permits use of arbitrary unstructured meshes. A fully implicit, non-iterative fractional-step method was employed to advance the solution in time. The subgrid-scale (SGS) turbulent stresses and heat fluxes were modeled using the dynamic Smagorinsky model. The LES predictions were found to be in good agreement with the experimental data of Hajime and Igarashi (2004). The salient features of turbulent heat transfer in subcritical regime such as the laminar thermal boundary layer and the rapid increase with Reynolds number both in the mean and the r.m.s. Nusselt number in the separated region are closely reproduced by the predictions. The numerical results confirmed that the heat transfer characteristics are closely correlated with the structural change in the underlying flow with the Reynolds number.


AIAA Journal ◽  
2001 ◽  
Vol 39 ◽  
pp. 1509-1516 ◽  
Author(s):  
C. Le Ribault ◽  
S. Sarkar ◽  
S. A. Stanley

Sign in / Sign up

Export Citation Format

Share Document