Thermal and Physical Damage in Skull Base Drillings Using Gas Cooling Modes: FEM Simulation and Experimental Evaluation

Author(s):  
Seifollah Gholampour ◽  
Hossein Haghighi Hassanalideh ◽  
Mansore Gholampour ◽  
David Frim
Author(s):  
R.J. Mount ◽  
R.V. Harrison

The sensory end organ of the ear, the organ of Corti, rests on a thin basilar membrane which lies between the bone of the central modiolus and the bony wall of the cochlea. In vivo, the organ of Corti is protected by the bony wall which totally surrounds it. In order to examine the sensory epithelium by scanning electron microscopy it is necessary to dissect away the protective bone and expose the region of interest (Fig. 1). This leaves the fragile organ of Corti susceptible to physical damage during subsequent handling. In our laboratory cochlear specimens, after dissection, are routinely prepared by the O-T- O-T-O technique, critical point dried and then lightly sputter coated with gold. This processing involves considerable specimen handling including several hours on a rotator during which the organ of Corti is at risk of being physically damaged. The following procedure uses low cost, readily available materials to hold the specimen during processing ,preventing physical damage while allowing an unhindered exchange of fluids.Following fixation, the cochlea is dehydrated to 70% ethanol then dissected under ethanol to prevent air drying. The holder is prepared by punching a hole in the flexible snap cap of a Wheaton vial with a paper hole punch. A small amount of two component epoxy putty is well mixed then pushed through the hole in the cap. The putty on the inner cap is formed into a “cup” to hold the specimen (Fig. 2), the putty on the outside is smoothed into a “button” to give good attachment even when the cap is flexed during handling (Fig. 3). The cap is submerged in the 70% ethanol, the bone at the base of the cochlea is seated into the cup and the sides of the cup squeezed with forceps to grip it (Fig.4). Several types of epoxy putty have been tried, most are either soluble in ethanol to some degree or do not set in ethanol. The only putty we find successful is “DUROtm MASTERMENDtm Epoxy Extra Strength Ribbon” (Loctite Corp., Cleveland, Ohio), this is a blue and yellow ribbon which is kneaded to form a green putty, it is available at many hardware stores.


1986 ◽  
Vol 19 (4) ◽  
pp. 797-804 ◽  
Author(s):  
Yosef P. Krespi ◽  
Toni M. Levine ◽  
Randy Oppenheimer

1984 ◽  
Vol 17 (3) ◽  
pp. 601-612 ◽  
Author(s):  
Donald L. Myers ◽  
Robert Thayer Sataloff

1984 ◽  
Vol 17 (3) ◽  
pp. 577-589 ◽  
Author(s):  
Robert Thayer Sataloff ◽  
Donald L. Myers ◽  
Frederic B. Krenter

1982 ◽  
Vol 15 (4) ◽  
pp. 723-753 ◽  
Author(s):  
Mahmood F. Mafee ◽  
Galdino E. Valvassori ◽  
Glen D. Dobben
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document