A voltage-based fault location algorithm for medium voltage active distribution systems

2021 ◽  
Vol 196 ◽  
pp. 107236
Author(s):  
Charalampos G. Arsoniadis ◽  
Christos A. Apostolopoulos ◽  
Pavlos S. Georgilakis ◽  
Vassilis C. Nikolaidis
2018 ◽  
Vol 8 (9) ◽  
pp. 1563 ◽  
Author(s):  
Cesar Orozco-Henao ◽  
Arturo Suman Bretas ◽  
Juan Marín-Quintero ◽  
Andres Herrera-Orozco ◽  
Juan Pulgarín-Rivera ◽  
...  

Modern fault location methods are robust; however, they depend strongly on the availability of the measurements given by Distributed Energy Resources (DER). If the communication or synchronism of this information is lost, the fault location is not possible. This paper proposes an adaptive impedance-based fault location algorithm for active distribution systems. The proposal combines information provided by Intelligent Electronic Devices (IEDs) located at the substation, the knowledge of the network topology and parameters, as well as the distributed power sources, to estimate the fault location. Its adaptive feature is given by the use of a Distributed Energy Resources (DER) electrical model. This model is used to estimate the DER current contribution to the fault, in case the information provided by a local IED is not available. The method takes two types of DER technologies into account: Inverter non-interfaced DER (INIDER) and Inverter-interfaced DER (IIDER). The proposed method is validated on a modified IEEE 34-node test feeder, which was simulated with ATP/EMTP. The results obtained using the IEDs information, presented a maximum error of 0.8%. When this information is not available, the method’s performance decreases slightly, obtaining a maximum error of 1.1%. The proposed method showed better performance when compared with two state of the art methods, indicating potential use for real-life applications.


2006 ◽  
Vol 89 (6) ◽  
pp. 503-508 ◽  
Author(s):  
Soon-Ryul Nam ◽  
Sang-Hee Kang ◽  
Jin-Man Sohn ◽  
Jong-Keun Park

Author(s):  
N. S. B. Jamili ◽  
M. R. Adzman ◽  
S. R. A. Rahim ◽  
S. M. Zali ◽  
M. Isa ◽  
...  

This paper focused on studying an algorithm of earth fault location in the medium voltage distribution network. In power system network, most of the earth fault occurs is a single line to ground fault. A medium voltage distribution network with resistance earthing at the main substation and an earth fault attached along the distribution network is modeled in ATP Draw. The generated earth fault is simulated, and the voltage and current signal produced is recorded. The earth fault location algorithm is simulated and tested in MATLAB. The accuracy of the earth fault location algorithm is tested at several locations and fault resistances. A possible correction technique is explained to minimize the error. The results show an improvement fault location distance estimation with minimum error.


2004 ◽  
Vol 19 (1) ◽  
pp. 35-41 ◽  
Author(s):  
M.-S. Choi ◽  
S.-J. Lee ◽  
D.-S. Lee ◽  
B.-G. Jin

Sign in / Sign up

Export Citation Format

Share Document