An alternative method to match planned and achieved positions of implants, after virtual planning using cone-beam CT data and surgical guide templates – A method reducing patient radiation exposure (part I)

2010 ◽  
Vol 38 (6) ◽  
pp. 436-440 ◽  
Author(s):  
Hans-Joachim Nickenig ◽  
Stephan Eitner
Author(s):  
S Kottou ◽  
A Zapros ◽  
N Stefanopoulou ◽  
N Krompas ◽  
V Tsapaki

Abstract Advantages of Cone Beam Computed Tomography (CBCT) include high-quality 3D imaging and reduced radiation exposure with relatively low cost. In this study, patient radiation exposure in CBCT implant planning dentistry was measured in terms of Kerma Area Product (KAP). Data were obtained from 217 CBCT scans on 168 individuals using a CS9300 Carestream system. Scans were made using 80–90 kVp, 4–5 mA, 8 and 13.3 s exposure time (depending on voxel size) and a fixed field of view (FOV) of 10 × 10 cm2 (medium). Mean KAP was estimated using two voxel sizes 180 × 180 × 180 μm3 and 200 × 200 × 200 μm3 and found to be 399 and 314 mGycm2, respectively. Corresponding KAP values found in literature ranged between 210 and 2140 mGycm2. Mean E was estimated using conversion coefficient factors found in literature, according to FOV size and tube voltage value and found to range between 24 and 161 μSv.


2019 ◽  
Vol 42 (11) ◽  
pp. 1609-1618 ◽  
Author(s):  
Lauranne Piron ◽  
Julien Le Roy ◽  
Christophe Cassinotto ◽  
Julien Delicque ◽  
Ali Belgour ◽  
...  

2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0015
Author(s):  
Daniel Bohl ◽  
Blaine Manning ◽  
George Holmes ◽  
Simon Lee ◽  
Johnny Lin ◽  
...  

Category: Other Introduction/Purpose: Foot and ankle surgeons routinely prescribe diagnostic imaging that exposes patients to potentially harmful ionizing radiation. The purpose of this study is to characterize patients’ knowledge regarding radiation exposure associated with common forms of foot and ankle imaging. Methods: A survey was administered to all new patients prior to their first foot and ankle clinic appointments. Patients were asked to compare the amount of harmful radiation associated with chest x-rays to that associated with various types of foot and ankle imaging. Results were tabulated and compared to actual values of radiation exposure from the published literature. Results: A total of 890 patients were invited to participate, of whom 791 (88.9%) completed the survey. The majority of patients believed that a foot x-ray, an ankle x-ray, a “low dose” CT scan of the foot and ankle (alluding to cone-beam CT), and a traditional CT scan of the foot and ankle all contain similar amounts of harmful ionizing radiation to a chest x-ray (Table 1). This is in contrast to the published literature, which suggests that foot x-rays, ankle x-rays, cone beam CT scans of the foot and ankle, and traditional CT scans of the foot and ankle expose patients to 0.006, 0.006, 0.127, and 0.833 chest x-rays worth of radiation. Conclusion: The results of the present study suggest that patients greatly over-estimate the amount of harmful ionizing radiation associated with plain film and cone-beam CT scans of the foot and ankle. Interestingly, their estimates of radiation associated with traditional CT scans of the foot and ankle were relatively accurate. Results suggest that patients may benefit from increased counseling by surgeons regarding the relatively low risk of radiation exposure associated with plain film and cone-beam CT imaging of the foot and ankle.


2019 ◽  
Vol 175 ◽  
pp. 205-214 ◽  
Author(s):  
Zhaoqiang Yun ◽  
Shuo Yang ◽  
Erliang Huang ◽  
Lei Zhao ◽  
Wei Yang ◽  
...  

2005 ◽  
Vol 32 (6Part17) ◽  
pp. 2109-2109
Author(s):  
T Tücking ◽  
S Nill ◽  
U Oelfke

2014 ◽  
Vol 2014 ◽  
pp. 1-9 ◽  
Author(s):  
Ailong Cai ◽  
Linyuan Wang ◽  
Hanming Zhang ◽  
Bin Yan ◽  
Lei Li ◽  
...  

Iterative image reconstruction (IIR) with sparsity-exploiting methods, such as total variation (TV) minimization, claims potentially large reductions in sampling requirements. However, the computation complexity becomes a heavy burden, especially in 3D reconstruction situations. In order to improve the performance for iterative reconstruction, an efficient IIR algorithm for cone-beam computed tomography (CBCT) with GPU implementation has been proposed in this paper. In the first place, an algorithm based on alternating direction total variation using local linearization and proximity technique is proposed for CBCT reconstruction. The applied proximal technique avoids the horrible pseudoinverse computation of big matrix which makes the proposed algorithm applicable and efficient for CBCT imaging. The iteration for this algorithm is simple but convergent. The simulation and real CT data reconstruction results indicate that the proposed algorithm is both fast and accurate. The GPU implementation shows an excellent acceleration ratio of more than 100 compared with CPU computation without losing numerical accuracy. The runtime for the new 3D algorithm is about 6.8 seconds per loop with the image size of256×256×256and 36 projections of the size of512×512.


Sign in / Sign up

Export Citation Format

Share Document