scholarly journals A Case Study of Double Lid Driven Cavity for Low Reynolds Number Flow

2018 ◽  
Vol 66 (2) ◽  
pp. 95-101
Author(s):  
Doli Rani Pal ◽  
Goutam Saha ◽  
Kajal Chandra Saha

The present numerical study has been accomplished remembering the true objective to explore the low Reynolds number flow with heat exchange behaviors inside a double lid driven square shaped cavity loaded with fluids such as air and water. Specifically, this work explores laminar, steady, incompressible mixed convection flow inside the cavity which has been done numerically by applying Finite Difference Method (FDM). In this analysis, top wall is treated as the heated wall and remaining walls are considered as cold walls. In addition, vertical side walls are moving at a relentless speed in its own particular plane along with the positive direction. Moreover, the numerical simulation is being conveyed out to observe the behavior of flow and thermal fields for variation of low Reynolds Number (Re), Richardson number (Ri) and Prandtl number(Pr). Also, the results have been validated through a comparison with other research works and a good agreement is observed. Also, results show that the above mentioned dimensionless parameters have significant effects on the flow and heat exchange attributes. Moreover, the effects of these parameters on average Nusselt number (Nu) have been analyzed and presented. Dhaka Univ. J. Sci. 66(2): 95-101, 2018 (July)

AIAA Journal ◽  
1972 ◽  
Vol 10 (10) ◽  
pp. 1381-1382
Author(s):  
CLARENCE W. KITCHENS ◽  
CLARENCE C. BUSH

2010 ◽  
Vol 39 (9) ◽  
pp. 1529-1541 ◽  
Author(s):  
Shengyi Wang ◽  
Derek B. Ingham ◽  
Lin Ma ◽  
Mohamed Pourkashanian ◽  
Zhi Tao

Robotica ◽  
2021 ◽  
pp. 1-17
Author(s):  
Hossein Nejat Pishkenari ◽  
Matin Mohebalhojeh

Abstract Microrobots with their promising applications are attracting a lot of attention currently. A microrobot with a triangular mechanism was previously proposed by scientists to overcome the motion limitations in a low-Reynolds number flow; however, the control of this swimmer for performing desired manoeuvres has not been studied yet. Here, we have proposed some strategies for controlling its position. Considering the constraints on arm lengths, we proposed an optimal controller based on quadratic programming. The simulation results demonstrate that the proposed optimal controller can steer the microrobot along the desired trajectory as well as minimize fluctuations of the actuators length.


Sign in / Sign up

Export Citation Format

Share Document