Surface Modification of Semiconductor by Simultaneous Thermal Oxidation Oxidation See Nitridation and Nitridation

2014 ◽  
pp. 2997-3029
Author(s):  
Kuan Yew Cheong ◽  
Yew Hoong Wong
Keyword(s):  
Surface Modification ◽  
Thermal Oxidation

Surface modification layer of Ti–6Al–4V produced by surface rolling and thermal oxidation

2017 ◽  
Vol 5 (4) ◽  
pp. 232-242 ◽  
Author(s):  
Gang Li ◽  
Shengguan Qu ◽  
Zhaojun Ren ◽  
Xiaoqiang Li
Keyword(s):  
Surface Modification ◽  
Thermal Oxidation

Thermal oxidation of silicon carbide with surface modification by the molecular layering method

Refractories ◽  
1985 ◽  
Vol 26 (1-2) ◽  
pp. 82-84 ◽  
Author(s):  
L. V. Miroshnichenko ◽  
A. A. Malygin ◽  
S. I. Kol'tsov
Keyword(s):  
Silicon Carbide ◽  
Surface Modification ◽  
Thermal Oxidation ◽  
Molecular Layering

Effects of ultrasonic nanocrystal surface modification on the thermal oxidation behavior of Ti6Al4V

2017 ◽  
Vol 325 ◽  
pp. 289-298 ◽  
Author(s):  
Jun Liu ◽  
Sergey Suslov ◽  
Shengxi Li ◽  
Haifeng Qin ◽  
Zhencheng Ren ◽  
...  
Keyword(s):  
Surface Modification ◽  
Thermal Oxidation ◽  
Oxidation Behavior

Bio-inspired fabrication of copper oxide nanowire films with switchable wettability via a facile thermal oxidation method

RSC Advances ◽  
2015 ◽  
Vol 5 (33) ◽  
pp. 26107-26113 ◽  
Author(s):  
YanLong Shi ◽  
Wu Yang ◽  
XiaoJuan Feng ◽  
Lei Feng ◽  
GuoRen Yue ◽  
...  
Keyword(s):  
Surface Modification ◽  
Copper Oxide ◽  
Thermal Oxidation ◽  
Oxidation Method ◽  
Cuo Nanowire

CuO nanowire surfaces imitating the structures and superhydrophobicity of the wings of boatmen have been fabricated by thermal oxidation and surface modification.

Surface Modification Effects on Microstructure and Mechanical Properties of Bio-Titanium Alloys

2017 ◽  
Vol 909 ◽  
pp. 199-204 ◽  
Author(s):  
Ahmed Zaki ◽  
Shimaa El-Hadad ◽  
Waleed Khalifa
Keyword(s):  
Mechanical Properties ◽  
Wear Resistance ◽  
Surface Modification ◽  
Titanium Alloys ◽  
Thermal Oxidation ◽  
Surface Properties ◽  
Equiaxed Microstructure ◽  
Hard Layer ◽  
Β Phase ◽  
Ti64 Alloy

Ti-6Al-7Nb (Ti67) alloy has recently been developed to replace the commercial Ti6Al4V (Ti64) alloy because of the reported cytoxicity of vanadium. Surface modification by thermal oxidation is used to enhance the hardness and wear resistance of such titanium alloys. Since Ti67 alloy contains Nb as β phase stabilizer instead of V in Ti64, it is expected to behave differently upon processing by thermal oxidation. Therefore, it is of interest to compare the response of the two alloys to thermal oxidation in terms of hardness and wear resistance. Forged and cast samples were used to study the influence of the microstructure on the surface properties after oxidation. The forged samples with their equiaxed microstructure showed a well developed sub-surface hard layer (α-case) compared to the cast structure for the two alloys. The thickness of this case in Ti64 after oxidation at (900-1100 °C) was greater than in Ti67. This resulted in higher wear resistance of the Ti64 alloy relative to Ti67. These results are worth considering when designing implants for joints replacement.

Surface modification of a Ti–6Al–4V alloy by thermal oxidation

2005 ◽  
Vol 192 (2-3) ◽  
pp. 164-170 ◽  
Author(s):  
H. Guleryuz ◽  
H. Cimenoglu
Keyword(s):  
Surface Modification ◽  
Thermal Oxidation

Surface modification of CP-Ti to improve the fretting-corrosion resistance: Thermal oxidation vs. anodizing

2010 ◽  
Vol 30 (6) ◽  
pp. 921-927 ◽  
Author(s):  
Satendra Kumar ◽  
T.S.N. Sankara Narayanan ◽  
S. Ganesh Sundara Raman ◽  
S.K. Seshadri
Keyword(s):  
Corrosion Resistance ◽  
Surface Modification ◽  
Thermal Oxidation ◽  
Fretting Corrosion ◽  
Cp Ti

Fabrication of superhydrophobic ZnO nanorods surface with corrosion resistance via combining thermal oxidation and surface modification

2015 ◽  
Vol 151 ◽  
pp. 24-27 ◽  
Author(s):  
Yanlong Shi ◽  
Wu Yang ◽  
Xiaojuan Feng ◽  
Yongsheng Wang ◽  
Guoren Yue
Keyword(s):  
Corrosion Resistance ◽  
Surface Modification ◽  
Thermal Oxidation ◽  
Zno Nanorods

Surface modification and bio-activation of bio-inert glasses through thermal oxidation

2014 ◽  
Vol 389 ◽  
pp. 1-10 ◽  
Author(s):  
Eun-Tae Kang ◽  
Jong-Po Kim ◽  
Chang-Yeoul Kim
Keyword(s):  
Surface Modification ◽  
Thermal Oxidation
Sign in / Sign up

Export Citation Format

Share Document