Characteristics of local geology and their influence on ground motions generated by the Loma Prieta earthquake in the San Francisco Bay region, California

1992 ◽  
Vol 82 (2) ◽  
pp. 603-641 ◽  
Author(s):  
Roger D. Borcherdt ◽  
Gary Glassmoyer

Abstract Strong ground motions recorded at 34 sites in the San Francisco Bay region from the Loma Prieta earthquake show marked variations in characteristics dependent on crustal structure and local geological conditions. Peak horizontal acceleration and velocity inferred for sites underlain by “rock” generally occur on the transverse component of motion. They are consistently greater with lower attenuation rates than the corresponding mean value predicted by empirical curves based on previous strong-motion data. Theoretical amplitude distributions and synthetic seismograms calculated for 10-layer models suggest that “bedrock” motions were elevated due in part to the wide-angle reflection of S energy from the base of a relatively thin (25 km) continental crust in the region. Characteristics of geologic and geotechnical units as currently mapped for the San Francisco Bay region show that average ratios of peak horizontal acceleration, velocity and displacement increase with decreasing mean shear-wave velocity. Ratios of peak acceleration for sites on “soil” (alluvium, fill/Bay mud) are statistically larger than those for sites on “hard rock” (sandstone, shale, Franciscan Complex). Spectral ratios establish the existence of predominant site periods with peak amplifications near 15 for potentially damaging levels of ground motion at some sites underlain by alluvium and fill/bay mud. Average spectral amplifications inferred for vertical and the mean horizontal motion are, respectively, (1,1) for sites on the Franciscan Complex (KJf), (1.4, 1.5) for sites on Mesozoic and Tertiary rocks (TMzs), (2.1, 2.0) for sites on the Santa Clara Formation (QTs), (2.3, 2.9) for sites on alluvium (Qal), and (2.1, 4.0) for sites on fill/Bay mud (Qaf/Qhbm). These mean values are not statistically different at the 5% significance level from those inferred from previous low-strain data. Analyses suggest that soil amplification and reflected crustal shear energy were major contributors to levels of ground motion sufficient to cause damage to vulnerable structures at distances near 100 km in the cities of San Francisco and Oakland.


1996 ◽  
Vol 86 (5) ◽  
pp. 1401-1416
Author(s):  
R. D. Catchings ◽  
W. M. Kohler

Abstract Our data indicate that critical and postcritical reflections from crustal layers and the Moho produced increased shaking at discrete distances along the San Francisco Peninsula during the 1989 Loma Prieta earthquake. These reflections may have produced an increase in amplitude that is as much as 10 times greater than that of the direct arrival. Peak amplitude-distance patterns measured from explosive sources, synthetic seismograms, aftershocks, and the mainshock of the 1989 Loma Prieta earthquake indicate that (1) point sources, such as explosions, produce similar peak amplitude-distance relations as distributed, double-couple sources when the crustal structure is approximately a Poisson solid; (2) peak amplitudes from smaller point sources (explosions) may be scaled to those of larger sources (earthquakes); and (3) reflections caused a pattern of high amplitudes at specific distances along the San Francisco Peninsula that geographically correlates with areas of reported damage following from the Loma Prieta mainshock. Our study indicates that critical and postcritical reflections were stronger influences on the locations of strong shaking than local geology because a number of sites around the San Francisco Bay that are underlain by unconsolidated sediments experienced much less shaking than sites that were underlain by hard rock. Furthermore, some severely shaken hard-rock sites were farther from the epicenter than many of the less severely shaken “soft-sediment” sites. Models of the regional crustal structure and seismic-wave propagation paths may be useful in identifying sites around the San Francisco Bay region that are at risk due to reflected seismic energy, and this type of analysis may be useful in other seismically active regions.


1992 ◽  
Author(s):  
Junpei Akamatsu ◽  
Masayuki Fujita ◽  
Hiroyuki Kameda ◽  
Mehmet Çelebi ◽  
R.D. Borcherdt

1976 ◽  
Vol 66 (2) ◽  
pp. 467-500 ◽  
Author(s):  
Roger D. Borcherdt ◽  
James F. Gibbs

abstract Measurements of ground motion generated by nuclear explosions in Nevada have been completed for 99 locations in the San Francisco Bay region, California. The recordings show marked amplitude variations in the frequency band 0.25 to 3.0 Hz that are consistently related to the local geological conditions of the recording site. The average spectral amplifications observed for vertical and horizontal ground motions are, respectively: (1, 1) for granite, (1.5, 1.6) for the Franciscan Formation, (3.0, 2.7) for the Santa Clara Formation, (3.3, 4.4) for alluvium, and (3.7, 11.3) for bay mud. Spectral amplification curves define predominant ground frequencies in the band 0.25 to 3.0 E for bay mud sites and for some alluvial sites. Amplitude spectra computed from recordings of seismic background noise at 50 sites do not generally define predominant ground frequencies. The intensities ascribed to various sites in the San Francisco Bay region for the California earthquake of April 18, 1906, are strongly dependent on distance from the zone of surface faulting and the geological character of the ground. Considering only those sites (approximately one square city block in size) for which there is good evidence for the degree of ascribed intensity, the intensities for 917 sites on Franciscan rocks generally decrease with the logarithm of distance as Intensity = 2 . 6 9 - 1 . 9 0 log ( Distance in kilometers ) . ( 1 ) For sites on other geological units, intensity increments, derived from this empirical relation, correlate strongly with the Average Horizontal Spectral Amplifications (AHSA) according to the empirical relation Intensity Increment = 0 . 2 7 + 2 . 7 0 log ( AHSA ) . ( 2 ) Average intensity increments predicted for the various geological units are −0.3 for granite, 0.2 for the Franciscan Formation, 0.6 for the Great Valley sequence, 0.8 for the Santa Clara Formation, 1.3 for alluvium, and 2.4 for bay mud. The maximum intensity map predicted on the basis of these data delineates areas in the San Francisco Bay region of potentially high intensity for large earthquakes on either the San Andreas fault or the Hayward fault. The map provides a crude form of seismic zonation for the region and may be useful for certain general types of land-use zonation.


Sign in / Sign up

Export Citation Format

Share Document